I just picked up a Latitude E6500 from the outlet, and it only comes with B wireless. People on the forum have mentioned that the E6500 has 3 Mini PCIe slots. One is full length and has 3 antenna connections, one is half length with 2, and one is half length with 1 (for Bluetooth).
I'm planning on upgrading with an Intel 5300 wifi card, it's amazing how cheap they are on eBay. The 5300 comes in two configurations, full and half, but it's a 3x3 antenna, so it'll have to go in my full length slot.
However, most of the listings seem to be for half, and they cost the same. I figure I might as well get the cheaper half length card that also saves .5 ounces of weight if it'll fit in the slot, and the antenna wires will reach. Does anyone know if this would work, or do I need to find one of the full length cards?
if the Intel Ultimate-N 5300 Wireless Wifi Link Card will work on my Dell XPS M1530 laptop?
I currently use the Intel 4965A AGN so i have the 3 antennas connected to it, But i can't find any confirmation that the 5300 will work with the M1530. I see that it says it's for the Centrino 2 but i don't know if it's for a certain motherboard or chipset.
I just recieved my Latitude E6400 today. I like the laptop, but the Intel Wifi Link 5300 AGN adapter continually drops my wireless connections to my home Linksys WRT54G access point and router. This is a version 5 Linksys unit running in mixed b/g mode with WEP encryption. It is running with a unique SSID which is not broadcast.
At first, my connections would drop and it seemed related to the Control Point software preinstalled on the E6400. So I uninstalled the Control Point System Management and Connection Management software, and this seemed to result in a small improvement: I can do a download successfully, but if I'm idle any amount of time the connection drops. This last makes me think power to the Wifi Link card might be getting turned off somewhere if there is no activity. However the Control Point Security Manager software is still installed (as it came from the factory) and might also be contributing to the problem.
I've used an 802.11n-compatible WiFi card in my home.The driver version for the WiFi Link is 188.8.131.52 and is dated 07/08/2008. The Linksys access point has been here a couple of years and is running Linksys firmware version v1.00.6. It is set up for 128-bit WEP encryption. I've had numerous laptops connect to it, all with older Broadcom b/g cards, and as long as the WEP encryption is set properly there has not been a connection problem. now to see if I can duplicate the connection dropping issue.
Has anyone else tried getting the VLAN support working on a Dell Latitude E6500? The network device I have is a "Intel(R) 82567LM Gigabit Network Connection".
Using the latest drivers available from support.dell.com, both the Dell download page and the driver report it as version 184.108.40.206. The Dell download page states it as A01, and dated 2009-02-24. The driver reports a date of 2008-04-04.
Under the "Advanced" tab of the properties from Device Manager, it shows "Priority & VLAN" as set to "Priority & VLAN Enabled". However, it doesn't appear to provide a way to add and configure the VLANs.
For Intel network cards, this typically requires the Intel PROSet application. The only download I can find from Dell is the "Intel 825xx Gigabit Platform LAN Network Device - Application", 14.0.2/Gold Build 01, A00, 2008-08-13 - and it is for 32-bit Windows only
I have had the following computer for a few days after purchasing from the Dell online store, Latitude E5540. The WiFi was having trouble connecting anywhere except close to my router, but recently the laptop is saying that a driver or hardware problem is detected in the Intel Dual Band Wireless-Ac 7260, and that Windows has stopped the device due to a problem (Code 43). The drivers are up to date, and connecting using an ethernet cable and checking for new updates tell me the drivers are up to date.
I've spent half an hour searching and still haven't found the answer. I'm set to order a Studio XPS 16, but am stuck on the wireless card. There are two Intel 5300 cards listed, a mini and a half-mini.
The half mini says it has "MyWiFi". That's not listed on the mini card
Intel® 5300 WLAN Wireless-N (3x3) Mini Card add $0
Intel 5300 Ultimate-N Half Mini Card (3x3) with MyWiFi [Included in Price
I'm looking to upgrade my E6400 to an intel 5300 card. Do I have to buy a card that is programed specificly for a Dell computer, or will any one work? In shopping around I see that some say Dell only, or HP/IBM only.
How about the ones on e-bay, have users had good luck with those? For some reason I'm wary of those sellers. Of course I know I can buy one from Dell, but I'm trying to save a few bucks if I can
I have seen at least one thread where someone mentioned that they had swapped out the Intel 5100 wireless card in their Z for a 5300. I have a router that can take advantage of it so I think I might want to try the same thing. I downloaded the service manual that was put up on the boards and I can handle getting to the wireless card.
I chose the Intel WiFi 5300 over the WiFi 5100 as I understand it is the better card. However, a few hours later I received an email telling me my order was cancelled because the 5300 was 'unavailable'.
I contacted Dell chat this morning, and was told that the part was available but was incompatible with my processor choice. Apparently the 5300 is a Centrino 2 part, and is only compatible with a Centrino 2 processor. I thought the T9400 was a Centrino 2 processor?
If it's true that the parts are incompatible should I go with the T9400/WiFi 5100 or the P8400/WiFi 5300? The Dell chat guy told me that these were the only compatible configurations. If I try to order T9400/5300 again will my order be cancelled again - anyone else tried this?
Every time I boot up the computer and switch on the WiFi/Bluetooth button on the right side - only the Bluetooth light turns on above the keyboard.
I go to Device Manager and find that the "Intel WiFi Link 5300 AGN" slot has the exclamation sign next to it so I disable the card and then reenable it again, then the problem is gone (the WiFi light turns on and I can now finally see wireless networks in the "Connect" window) .....
I reinstalled Vista 64-bit Business on my laptop. And I've installed all of the drivers which are working, but my wifi drops out every 20-30 minutes. I've done some research and found this isn't uncommon...
so I installed the lastest Intel drivers, disabled all of the power saving features on my wifi card/DCP.
But, it still disconnects! What the heck!? I might have had this same issue in Windows 7, but I can't really remember. All I know is that when I tried to back it up using WHS, it would always fail.
I have the HP 8530w and a D-Link DIR-615 wireless router and am trying to make them work together. Using the G speed (54mbit), the network is stable (signal quality is excellent). But when I try the N speed, the situation is different. The network starts working as it should, but when loaded (big files transferred), the network suddenly dies and windows vista can take up to a couple of minutes before it discovers the missing link. During that time, the 5300 AGN still receives packets from the router (10 beacons per second as per setup in the router). But no packets are sent (checking with Intels statistics tool).
So it looks like the Intel 5300 AGN doesn't send any packets all of a sudden OR that the DIR-615 has become temporarily deaf. But disconnecting/reconnecting in vista make the network work right away indicating the problem is with the Intel 5300.
As an ekstra test, I tried having the Asus EeePC 1000H (also has 802.11n draft) transfer the same files while the HP 8530w was and then the network was MUCH more stable. The HP 8530w experienced 1 dropout but the EeePC continued transferring at full speed. Obviously the Intel 5300 AGN has severe problems talking with the DIR-615, problems so big it cannot figure out how to recover normally. :-(
Needless to say, I have tried playing with most settings in the Intel 5300AGN and also with the DIR-615, but without success. The network breaks down, always.
On the plus side, the EeePC 1000H is stable.
I wonder if it is possible to exchange the Intel 5300 in the 8530w with another wireless lan? I'd prefer to have a card that works.
Just recieved my intel 5300 wifi card ready for the upgrade.
Upgrade physically went semi well, the 4965agn that was fitted was a devil to get out.
Seems like acer decided to get superman to tighten the two screws that hold the wifi card down. In the end the only solution was to remove the 2 pillers from the pcb(with pliers and brute force) and remove the card.
Windows xp fired up fine, no wifi connected popup. drivers were my first thought.
Checked device manager, code 10 on the device. tried new drivers, old driver sets, no progress.
Also there was a few links about the pcie 2 and pcie 1 compatiblity problems. But a pcie2 card should run at the pcie1 speeds when fitted to that slot, so that shouldnt be the problem.
Ive ordered a 2nd intel 5300, one that should be 'more' compatible..we will see. will post update on that when it arrives.
as of this point id say that the intel wifi 5300 does not play well with the acer 6920g.