So when I'm at home using my powerbook i use a wifi connection at 1.5 mbps and my internet usage is awesome.
But when I go to school and connect into my 3 mbps ethernet connection it is slow as hell. I have a PC and when it ran on the ethernet connection it was fast, and i've speed tested this baby and it it shows the internet at 3 mbps. Im not quite sure what is causing the slow down.
When I boot up my Y50, The lenovo logo comes up and the windows 8.1 loading logo below it lags. It starts slow and then goes back to normal. The problem is, My other laptop which is also windows 8.1 it boots up 2x as fast even though my y50 has better computer specs. Both laptops have fast boot enabled.
Edit: My other windows 8.1 laptop boots in 14 seconds while my Y50 boots in 35seconds. There is noticable lag when it boots up.
Edit 2: A Video URL...
Edit 3: ALL good now!
I have an Ideapad Z580 with a 30mbps cable internet connection (running Win8.1). I've tested the cable modem with a number of laptops in my house, and the Ideapad is the only one that regularly times out on loading webpages.
What I've tried:
1. Updated Realtek Ethernet driver to newest version
2. Changed to Google Pub DNS servers (no difference from cable providers)
3. Changed power settings to High Performance (rather than balance or the battery setting)
4. Turned off IPV6 on the ethernet adapter
The problem seems to be random. Pages will load quickly and then suddenly they all time out (such as google and lenovo.com). When I ping both the url and the ip address they time out during these periods.
The problem is definitely with the laptop and not the cable connection as such. The modem does not need to be reset, as other laptops in the house load webpages normally.
My brothers PowerBook G4 1.67 (2006 model) stopped working. It was working fine yesterday.
When I tried to restart it beeps three times and does not start.
According to Apple's webpage, three beeps at startup means no good banks.
1 beep = no RAM installed
2 beeps = incompatible RAM types
3 beeps = no good banks
4 beeps = no good boot images in the boot ROM (and/or bad sys config block)
5 beeps = processor is not usable
i already tried using a different memory and nothing.
i have an issue with my G4, when i go to boot it up it had the blue/grey page with the gears and apple logo, after the gears have spun for a while a promp comes up in the top right of the screen that says:
SH-2.05a# [HCIController][setupHardware] AFH Not Supported (0x1bea780)
i have a PowerBook G4 15' Aluminum edition, it gets about 1 1/2 to 2 hours on power saving mode sometimes way less depending if it stays on during the whole class. I was wondering if this was normal or if a new battery would give me longer life?
View 4 Replies View RelatedI have an old PowerBook G4 here which once had a dead hard drive that I have now replaced. I've attempted to install both Leopard and Tiger but it acts as though the discs are corrupt in the case of Leopard, while Tiger simply fails to install after finishing one of the later stages of the install process (something after it installs the additional languages).
So I'm thinking now that there may be a problem with the DVD drive, and would like to install from a USB drive - is this possible? I would like to do this with Tiger preferably as I already have an image of the disc on another computer.
Another idea of mine is that it is a RAM issue. Possible? I can try removing one of the sticks.
Oh and another minor problem is that I seem to be unable to get all the hinge screws all the way back in... but this doesn't matter if I can't even install OSX on the thing.
i have an appl g4 powerbook and it doesnt have a harddrive, cd drive, and it may need a new battery. does anyone know where i can get inexpensive parts for this thing? they dont need to be apple parts, i just want this thing to work.
this is all the info on the laptop:
PowerBook G4 model no m6091 14.4v
400 MHz/1 mb cache 128 mb/10gb/8mb video/DVD/ap
serial No: Qt1390f9lbw
I just got a free Powerbook G4 17inch from a relative and I was wondering if I should upgrade it to Leopard or if I should keep it on Tiger. It has a 1.67Ghz processor, 2GB of ram and an ATI 9700 128mb. Will I notice any significant improvement in performance or will it slow this machine down more? I was inevitably planning to sell it but if I can run Leopard decently I'd most likely keep it. Though being unable to play HD youtube videos without stuttering is kinda annyoing.
View 3 Replies View RelatedWould you consider the new Unibody the new Powerbook 12"!
- The white macbooks were never in the 12" Powerbook league because:
a) Intel graphics
b) Made from lower quality plastic
The new unibody macbook shares with the Macbook Pro:
a) Same build material, also same build quality
b) Way better graphics then the old white macbook
c) 2.4ghz model has backlight keyboard
d) Similar keyboard
Now I know the Unibody Macbook is missing pro features:
a) Firewire
b) express card slot
c) decent display
But for the price I would consider the new Macbook to be a good 12" powerbook replacement!
I have an old mac powerbook G4, i dont want to buy a new mac but I rather use a little money fixing this one up and making it faster and putting in the new OS. What are some steps I can take to make this computer faster, more reliable and up to speed with the new stuff out there (well this may be a stretch, but as much as possible)?
I need it to handle some multi-tasking and mostly school related stuff. Nothing major like designing, etc.
My girlfriend has a PowerBook G4 (12" titanium), and she wants to know if she can use (and how) her Sony Ericsson K770i as an image capture device, as her laptop doesn't have a webcam installed.
Also, she wants to use the same phone as well to surf the internet (serving as a modem) when she's out of range of telephone lines etc.
I just acquired a Kanga Powerbook running OS 9.1. It's in great shape except that the keyboard is experiencing a bizarre malfunction. Using Key Caps, I have determined that it is getting input from the Apple, control, option, and shift keys but the other keys are not responding. System Profiler also recognizes the keyboard as a Powerbook extended keyboard. It's as if the internal keyboard was somehow disabled. How can I reactivate it?
View 5 Replies View Relatedon a mac are you able to get more than one internet page up at one time? like how with windows u can have tabs.
View 7 Replies View RelatedSo I'm finally sick of my wife's laptop and it's measly 512mb's of ram and would like to run bootcamp and some 'light' use of 3ds max it's clear a Ram upgrade is needed. My question for you apple gurus is can her system handle more than 2gb's of ram... i'm obviously challenging the max ram statement on the linked page I've heard of people installing more than the "limit" and the system running fine. I'd like to get 667MHz DDR2 SDRAM (PC2-5300) on two SO-DIMMs.
first of all, can 4gb's work in this laptop and secondly, does anyone recommend memory that's proven to work in this scenario?
I have a PowerBook G4 1.5GHz 12" DVI Titanium which is now from what I can tell has a busted board. I have some sensitive material on my hard drive and I would prefer not to take it to a repair store for privacy. I would also like to go a little bigger. So the only thing I could come up with is to purchase a 17 or 15" G4 Powerbook Titanium and swap the hard drive. My question to all of you is if the 12" and the others of the same class are using the same hardrive. Will I many any complications in trying, is it even cross compatible. Am I going through too much trouble entirely? does anyone have any better suggestions? if I have a shop swap it for me can they even access the contents of my hard drive with out the password.
View 9 Replies View RelatedI am trying to connect via Adium to my MSN account but it keeps loading and nothing ever happens..
I tried connecting via microsoft messenger and it worked.. anyone have any idea of what happening? is there any difference between the way adium connects compared to MSN?
Anyone here trying safari 4? I think i actually do notice a speed diferrence when loading websites.
View 10 Replies View RelatedMy MacBook Pro used to shutdown in about 6 seconds. Now it takes over 40. I've added and removed a lot of software over time and am wondering if there are shutdown procedures being run where the software doesn't exist (resulting in a long search for shutdown programs that ultimately fail). Could someone tell me the filename and directory of the file that calls other scripts to shutdown? I'd like to take a look at this file to see if there's stuff in it that shouldn't be there. Alternative a shutdown log (if such a thing exists)
View 10 Replies View RelatedI just installed another gig of ram and it still runs as it did when i still had one gig what should i do?
View 6 Replies View RelatedI have Windows XP installed through boot camp, and it seems the hard drive is acting very very slow. Or basically XP in general. Installations are taking a very long time. It literally took 4 hours to install Modern Warfare 2. In case anyone is wondering I have the 2008 iMac 2.4 Ghz, 1 GB RAM, 7200rpm HD. Also in device manager, under SM bus controller there is a yellow question mark, could that be part of the problem?
View 10 Replies View RelatedHas anyone found a better solution to the slow Magic Mouse tracking problem than the "Mouse Zoom" utility?
Does anyone know if Apple has plans to fix the problem, once and for all, with a native OS update?
out of the blue connecting to a server takes about 20-30 seconds. This problem remains, also the connections close by themselves. When I boot linux on this machine there is no problem. Other machines on the network have no problems. Connecting to these other machines with this laptop show the same results ->slow connection, difficult browsing. (the domain controller is a slack box - no machine restrictions are in order)
-Firewall is down for the occasion but no effect.
-There were no recent updates.
-It doesn't matter what interface I use wireless or Ethernet.
My guess is problem with samba. Restarting samba or restarting osx have no effect. Resolve.conf shows the right info and HTTP traffic is normal.
I find reinstalling is no option. I want to know the problem and if there are more users with the same problem.
OS: OSX 10.5.6
Just started TM backups on a new 1TB drive today....
It did 30GB in 2 & half hours! A little slow...
Why does it go soooo slow? Supposed to be faster in SL.... don't think so....
Went for Carbon Copy Cloner..... much better.... currently 27GB in 23 mins.... thats more like it.
That'll be my weekend moan out of the way I guess...
Recently my games and videos are running real slow on XP.
Especially noticeable while sounds are going, for example on youtube, sounds like its on slow motion.
I have Compaq Presario CQ42-273TU NBPC. In my laptop , if i play video , it becomes very slow. After video becomes slow, everything else on the laptop becomes slow. recently i gave laptop for service also, then also i have issue with video.
View 8 Replies View RelatedI have Firefox, VLC and Digsby running, my RAM is 90% used. What's going on?
My other PCs don't have this problem and it's causing major slow downs on my computer!
Since upgrading to Snow Leopard I have experienced slow boot times and many more color wheels when launching apps that I had with Leopard. From reading other Snow Leopard posts, this seems to be contrary to what other users are seeing. I updated to 10.6.1 hoping that would fix the issue, but so far has not. I'm about ready to wipe and do a clean install, but wanted to see if anyone else was experiencing the same problems.
View 7 Replies View RelatedI have a mighty mouse (the one with the scroll nipple), and for some reason I can only scroll upwards properly, scrolling down does not work or scrolls down slow and jerkily.
View 6 Replies View RelatedI have an e4300 with 4 gigs of ram and Win7. I recently downloaded the latest Windows Update as prompted by the OS, and now I'm having an issue where everytime I start the computer it asks me to set the page file size. It's always listed as 0 megs.
So, I got to reset it using the box marked managed by the system, and when I restart the same thing happens.
So instead I chose a custom size 1.5xRam for lower limit, 3x ram for higher limit, and still eveytime I restart it gives me an automatic pop-up telling me my page file is set to zero.