I cracked my dell studio 15 (1535) LCD screen , I have been looking for a replacement screen but I can’t seem to find one. Can they be purchased from dell?
I had a WLED 1440X900 screen and would like a LED back lit screen to replace it. I have checked several places including few sellers on ebay but they don’t seem to have one.
Does anyone know what the part number for the Verizon 5720 card is for the 1340?.
I found this on Dell's website - verizon 5720..
But, the picture is for a sprint card so the P/N on screen is no help. I have been thinking about adding one from ebay or somewhere cheaper but want to make sure I get the right one...
Since they don't ship this laptop with a backlit keyboard over here, i'm about to get a replacement part from eBay so i can replace it by myself.
So i did some browsing - and found out that for a US/International Keyboard replacement part the part#KR766
After searching on eBay it shows up a >
Dell Studio 1535 1536 1537 Backlt Laptop Keyboard KR766 .....
Problem resolved
View 3 Replies View RelatedOccasionally the screen on my nx7010 will flicker and I can usually fix it by gently pressing the black plastic overlay bit on the bottom left hand side of the screen. I once removed this plastic and noticed the wire under there was pinched and unpinching it solved the problem for a while. The flickering is now getting worse and I'm assuming I have to change that wire but I don't know what it's called or where to look for it. Can anyone let me know what I should be buying?
View 8 Replies View RelatedI've had a flickering screen problem with my NX7010 for a while now and previously asked about it here:
What part do I need to fix the screen on my nx7010?
Since then I've changed both the LCD cable and the inverter but flickering problem has not gone away. I'm now assuming it's the backlight but as I've heard the backlight is very difficult to change, I'm hoping to pick up a cheap screen somewhere.
The service manual says these are the options for the NX7010
With carbon finish for use with
HP Compaq nx7000 notebooks
15.4-inch, WUXGA - 337006-001
15.4-inch, WSXGA+ - 337003-001
15.4-inch, WXGA - 337008-001
How do I know if my computer is WUXGA, WSXGA+ or WXGA? Are these interchangeable?
Also, I've looked on eBay and have seen LCDs with part number 337008-001 listed but they don't mention compatibility with the NX7010. They do say they are compatible though with the X1000. Since it's the same part number can I assume that the X1000 and NX7010 use the same screen?
Lastly, I've also seen screens listed on eBay with the part number SAMSUNG (LTN154X1 - L02) and again, it says compatible with 337008-001. Is this LT part number now also an option for me?
Okay so i probaly have the weirdest problem ever with this laptop, so the issue started when the display stopped working properly and would only work at a certain angle or when u would apply slight pressure on a certain part of the screen, faulty monitor correct?wrong. When i uninstalled the intel gpu drivers and reverted back to the standard microsoft display adapter all these problems disappeared, screen would work at all angles and the display would have no issues, so that sums out the possibility of the monitor being faulty. The display starts having these issues everytime the intel display drivers are installed, it just blows my mind how this is even a thing. The screen flickers twice and turns off after windows is done booting when the intel drivers are installed and works perfectly without them.
View 9 Replies View Relatedi just purchased an old dell m170 from ebay. i asked for the service tag (8819S91) and it showed me this for the video card:
1NF524Module,Card,Graphic,256MB G70,M170..
can anybody confirm what kind of video card that is? is it the 6800 or the 7800?..
This laptop just went out of warranty when the lcd started growing vertical lines(have had 4 screens replaced under warranty for the same thing )
Should i fix it with a new screen and sell it or just part it out?
What is/are the part number(s) for the 16" 1080p RGBLED screen? My Dell order keeps getting some 1080p 15.6" WLED screen ... I'd like to use the part # and get the manager to fix it quickly. Also what is the part # for Bluetooth?
View 9 Replies View RelatedA replacement system has been set out and typical Dell can tell me not a freaking thing about it.
They did tell me F754K is the Dell part number of the video card. I have to know cause I may have to refuse the delivery.
does anybody know if 2 of these
Product Description HP memory - 4 GB - SO DIMM 200-pin - DDR2
Storage Capacity 4 GB
Upgrade Type System specific
Technology DDR2 SDRAM
Form Factor SO DIMM 200-pin
Memory Speed 800 MHz ( PC2-6400 )
I belive since bios A07 the M1730 will take 8GB
can some body confirm this HP ram will fit in the dell m1730
my work pc is a Dell inspiron 1520. it is mounted on Ram stand in my tow truck. the problem i am having is sometimes now when im driving down a bumpy road the backlight goes out.
to get it back on i either have to close the lid and open it, or shut it down and reboot.
i was thinking its the switch that tells the mother board that the lid is closed when its not. Is there any way to disable that switch so the backlight is on permantly
I have a Studio XPS 13 with the 256GB SSD option and absolutely love it.
My wife uses a Mac... one of the new 13" Macbook Pro's. It came with a 160GB 5400RPM drive but she needs more room and after seeing my XPS fly with the SSD she has decided that she just has to have an SSD.
Looking out on the Dell website I see that they sell the 256GB Dell branded SSD for under $500 which seems like a really good deal but I'm not sure if it will work in the MBP .....
I just ordered the XPS 1640 from the dell Outlet I need the part number for the 4X Slot Load Blu-ray Disc (BD) Burner
(Writes to DVD/CD/BD) so I can replace the dvdrw drive that came with the system.
Also just to play a game: Name the price you will pay for it.
Studio XPS 16 (1640) Laptop: Intel Core 2 Duo T9800 (6MB cache/2.93GHz/1066Mhz FSB) w/2.0MP Integrated Webcam
32BIT Operating System CD
Operating System Label
Power DVD Software
Dell Wireless 370 Bluetooth Module
Intel WiFi Link 5300 802.11a/g/n Draft Mini Card .....
I have extended warranty so I called XPS support to replace it and they said no problem, but they would need the part number shipped w/ the XPS M1530 system.
If anyone has the part number from the bottom the the Dell Reinstall disk, or better yet, an SP2 disk, though I doubt they are shipping yet, I could sure use it. You can PM me or post it here..
I want to get it replaced b4 it goes out of warranty as I deleted my recovery partition...
Dell just upgraded my faulty 9500m mother board to the latest rev with the G 210M. Problem is the old heatsink and fan combo (part number U943D) will no longer fit as the screw post location has changed.
Images below reflect the changes.
1st 1340 w/9500m with dell part #U943D
2nd 1340 w/G210m (just cant read Part#)
3rd My mainbaord and fan the tech said would work (without a heatsink on gpu. Yeah I know.. )
If you look close the heatsink right under the fan (and fan is different too) is different on the right side as the screw moves up.
Can anyone with the G210m give me the part number of the fan and heatsink?
Dell for the life of them cant figure it out and have sent the wrong parts 4 times already. Its really getting frustrating. Any and all part numbers or High detailed readable pictures would be greatly apreciated!!!
-= The part has been identified!! Dell Part#C755T =-. See post #11 for more info
i noticed now DELL is offering a blu-ray writter in XPS 1640 . i am looking for a part number on tha
View 7 Replies View RelatedAnyone, by chance, know the part number for the HDD bracket and plastic cap assembly for the M1330? This is bascially the assembly that goes around your HDD with the 'cap' on the end that mates up to the laptop case.
I've been looking on Dell's site for a bit (and ebay) and can't seem to find the part. I'd like to pick up a spare for my Win7 Drive I've been playing with, rather than swapping the HDD in and out of my existing frame.
This thread is an extension of the original Precision M6400 Owner's Lounge thread. The old one was getting to be too large and slowing down the database.
View 10 Replies View RelatedIt flies through most of the boot, and then stops when there is about a centimeter left of the progress bar.
There it stays for 15 seconds or more doing presumably nothing. Then I hear the dvd-rom "awakening" before it goes on to boot windows .....
I received two of the incorrect travellite modules from Dell so far and the third one seems a bit sketchy as it rattles around in the bay as if isn't quite tall enough. The part numbers don't match up with what I see on the accessories site either. The latest one I received (on the left) looks like the one for the E6400 and carries a sticker with 0M011C-38561-87M-05FT-A00 on it. The ones on the right which didn't fit had 0H022G-69400-88U-01C0-A00 on the sticker. Can anyone confirm if the one on the left is in fact the proper one for the E6500?
View 9 Replies View RelatedThis thread is an extension of the original Precision M4400 Owner's Lounge thread. The old one was getting to be too large and slowing down the database.
View 10 Replies View RelatedI've recently upgraded to a Quadro 2500m in my 9400. Sometimes after playing games for awhile it will freeze up for a second and then get really slow (sometimes staircase like lines will appear on the monitor). I doubt the 2500m is broken since it came in a sealed Dell box and my temps aren't too high, so I'm suspecting that the 130W adapter that I got off of eBay is not really up to it. I noticed that sometimes when it boots up it cannot recognize the adapter (Press F1 to continue, F2 for setup etc...) but other times it recognizes it as the 130W adapter fine.
I also noticed that that PA-13 that I have was made in 2004...isn't that way before any of the Inspiron 9400s came out?
So I'm wondering if anyone knows where to get a reputable 130/150W adapter and/or what the part numbers are that people have been using successfully.
I finally replaced the keyboard on my Latitude D800 - the spacebar stopped functioning. The new keyboard works fine, but I think I screwed up putting stuff back together.
The back plastic part that needed to come off (the thing with the power buttons, mute, and lights, etc.)
has a small bump in front of the four indicator lights around where the right screw is for the keyboard. I can't press it down more, thoug
Long ago (A year ago lol) I bought the Gateway FX gaming notebook. It was a great PC and could not beat the price with the hardware and performance it offered, however the screen was really bad.
At first glance it wasn’t, 1080p res and good brightness level, but when I plugged in my old external LCD monitor to dual screen, I was floored. My 4 year old desktop LCD screen was almost better in every single way.
The Gateway’s colors were dull, muddy, and dark, no matter how much I recalibrated the screen, I could not get it to look anywhere as good when compared to my Samsung screen on my desk.
In the near future I'd like to get one of these cards as replacement for a 5300 for the integrated WiMAX modem.
View 4 Replies View RelatedI'm having trouble sourcing the screen assembly (the bezel or surround rather than the screen itself) for a Sony TZ series. Is there a site that can show me part numbers on a diagram..
I can't look at the machine in question until next week to find out the part numbers directly..
Anyone know where to get some replacement parts such as the keyboard for the Vaio Z?
View 4 Replies View RelatedMy fan recently died in my macbook (early 2008, probably a penryn right?) and i decided to replace it myself.
I ordered a fan that was stated it would fit all macbook's except the macbook with unibody.
It was shipped from the US and i live in Sweden so it took a while. I recieved it today and lo and behold, it does not fit.
I've opened up a dispute with the seller but i need to fix my laptop asap so i need to get another fan somewhere.
I will probably be buying from ebay since it's cheaper, but this time i want to be certain i get the right part.
I wanted to ask if i can identify what fan i want and don't just go by the description of the item (since that fooled me once)?............