As I'm about to upgrade my Inspiron 9400 to a 7950 GTX GPU and quite probably 4 gb of ram soon, I've read that I will need a new Power Adapter since 90W won't be enough.
My question is: Is PA13 (130W) enough? Everywhere I look on this forum, they say you should get a PA13 (130W) or a PA15 (150W)...
Is there any reason to get the PA15 (150W), because if not, there would be no reason to pay more for extra power if you don't need it. In that case, why mention de PA15 (150W) at all?
Well many people seem to suffer from the dreaded brick Failure, I have had a few go crap, and many of those failures usually were traced back to a broken wire in the DC cable assemly. If you wiggle the cable in the area if the strain relief you can usually hear the crackling sound.
I usually find it breaks in the strain relief - See attached Picture.
Fixing this can be easily done with a few items, there are a few little challanges as well.
1. Soldering Iron & Solder 2. Solder Sucker (removing tool) or Solder Wick 3. Wire Cutters 4. pliers, Small Screw drivers 5. Volt Meter (DVM) 6. Electrical tape
If you see Picture 1 of the plug, I just wanted to point out the typical barrel type connector used in the Dell laptops 6000/6400/9400/M1710 Etc.
There are 3 wires to connect here, The Out side Barrel is the Negative supply, The inside Barrel is Postive, and the inside Tip is a Voltage Sense.
I have added some new Pictures to show the inside of the PA-13 brick.
You can see the three connectoins on the bottom side of the board. The spacing is tight, and you can easily solder across two pads, checking for solder bridges is important
Please note, the spaces are small, and you require good eyes, a magnifying glass would help, and some soldering skills.
After your soldered the new connections careful inspection to check for any solder bridges is required.....
It sounded like a mouse or something chewing/clawing away at something. I freaked out I searched the entire room and finally narrowed down the sound to my damn power adapter.
It was making a sort of clicking/ light scratching noise. It's still doing it, is this normal, this is the first time I've heard it.
It sounds like there are some dodgy sellers for the Dell power supplies, at least on ebay, based on some discussions. If anyone has purchased a 130W PS and feels like they could recommended the seller I'd appreciate the tip. If posting an ebay or retail link violates forum rules then just PM me.
I can barely touch my charger it is so hot, it is one of the new slimmer blocks. It is seriously hot and nowhere near the temperature of my friends Vaio block.
I killed my BIOS my mistakenly running a BIOS update in WinXP... Power light, power to drives but nothing else.
After much searching I found I might be able to reflash it using a Crisis Recovery Disk, an external USB floppy drive and some combination of key-presses on boot.
Various combinations of this have been tried (FN+ESC, Win+B, Win+Fn, Fn+B....battery in/out, yada, yada, yada) and so the fallback is to use the boot block jumper as per Acer's support information: [url]
After downloading FRU guides, user guides and service manuals for loads of Acer models, I haven't got one for the 2000 series that helps, though I have managed to get the keyboard off (I understand this is the usual location for boot block jumpers) revealing switch SW5 with 4 DIP switches.
Now what? :-)
I have emailed Acer support but hear less than glowing reports about their responses,
(I believe the motherboard is an Intel MS2154 which is used in TM20**, TM21**, TM25** and TM26** models, and maybe an Aspire one or two)
I just recieved a PA-13.. My comp gives me an odd dos screen saying it dosent recognize the power adapter... Is there something i have to do to make it recognize..? or should it be automatically recognized..?
I have a 9400 and i was planning on putting a fx-2500 vid card in tonight... Whats wrong here..?
I have a Dell Latitude E6400 which uses Dell's 90w Charger PA-10 which is a 90w 4.62A and 19.5V.
I have been looking for a second power supply, but before I drop the money on a new one. I also have an old Inspiron which uses a the 130w Dell Charger, it is a 6.7A power supply, and the same 19.5V as my Latitude Charger.
Could I use this charger with my Latitude without causing damage? I am just a little concerned about the Amperage being higher than my current charger.
I have a Dell Latitude D800 that will not power on. When the power button is pushed the green power indicator light comes on, the CDROM spins for a moment, but then nothing happens, there is no BIOS information displayed, no power on self test, no Dell logo. It just sits there with the green power light on.I have tried removing the power & battery then pressing the power button for 10 seconds (actually, I have tried as long as 60 seconds). I have tried to turn on with the power connected but not the battery. I have tried removing the connector cable for the power button and the connector cable for the display and then reseating them.
I have a Dell Inspiron N5010 laptop, the power light (light on the power button) and the left front LED white light blinks every 5 seconds. It doesn't power on at all.
Our Studio 1749 will retain a solid connection when the power adapter is plugged into the power board along the side of my laptop. I am unsure if the pins residing in the power board are pushed toward each other so as to not retain connection when the adpater in plugged into the laptop.
When I pull the power cord to switch to battery power while in Windows my lcd goes to black. The only way I get my video back is a hard reset and reboot. Later on I tried this and everything was back to normal. Why is this happening? Is this some weird standby?
I have just installed an i7 2670Qm on my T420 today.The machine will crash pretty soon after booting up, with the screen having colorful vertical and horizontal lines before it restarts itself and give the memory error beeping pattern (1 beep-pause-3 beeps-3 beeps-pause-1 beep).So then I took out one RAM from the bottom, and the machine appears to work normally again, more or less.
In the OS (Win7 64), The power manager alerts me that the 65w AC adapter is giving not enough power, so the laptop is running on battery. I thought I just need a 90W AC brick so the laptop will work as it should, so I am arranging a 90w one to come in later. But on a second thought, if the battery cannot start the laptop with 8GB of RAM properly.
Is it the CPU or RAM or Mobo or something else? Where should I look?The machine works fine with the previous CPU i3-2310m and 8GB of RAM.The RAM modules I have are 2 x 4GB Samsung 2Rx8 PC3-12800S-11-11-F3.The BIOS version is updated to the latest 1.46.
I enjoy the feature of automatically powering off the optical drive in power manager. My issue is after reformatting my T530 the option is there until I do an update using the Lenovo ThinkVantage System Update. One of the updates seems to remove the feature from the power manager.
After replacing the fan, I have a power up issue with the laptop. Basically, the laptop will only power on with the power cable disconnected at the motherboard. It was by mistake that after the fan was replaced and everything was put back together, that I noticed that the battery was not charging.
I then reopened the machine and reconnected the power cable to the motherboard and nothing - no power.
When plugging in the power source with the battery in place, the LED adjacent to the power socket lights up WHITE then stays ORANGE and will not power up. No other lights, no fan noise, nothing.
If I remove the battery, the LED adjacent to the power socket lights up WHITE and stays white however will not power up either. Same agin, no other LEDs, not fan noise, nothing.
I have now opened the machine back up and disconnected the power from the motherboard. Put it all back together and the laptop powers up as normal with the battery and it works fine. (Well until the battery runs out anyway).
I'm having some issues with my MacBook's USB hub. I have the macbook from 2007 I believe that has 2.0GHz and 1GB of RAM. WHenever I connect my iPhone to the USB port to sync, it pops up with this dialog box that says that my iPhone is drawing too much power and thus the USB hub will be deactivated.
I have an Aspire 6930 that suddenly died and will not power on. The LED power button was dark and unresponsive. I performed a power reset and the blue light on the power button came back on until I pressed the button to try to restart the laptop. When I did that, the blue LED immediately went dark and stayed that way until I did another power reset. It never gets to the point of anything powering on. Is it a problem with the battery or it the laptop toast?
This is a real bummer since I just replaced the hard drive a few weeks ago and replaced Windows Vista with Linux Mint (which btw is blazing fast compared to Vista).
Acer 5253 - Will not power on, battery or on AC power. Have tried all the suggested solutions but none have worked. Is it possible to get maintenace instructions (disassembly, where certain items are located, etc)?
I have a D800 I haven't used in about 10 monthes. I took it out of the bag and charged the battery.
When I turn it on, it boots approximately one third of the way through the loading bar for the BIOS, and then it powers off.
I've tried it with both the power cable and battery, just power cable, and just battery; and it behaves the same way. Last time I used it, it was working fine.
I was just wondering, what power setting do you all run your computers on? Balanced, power saver, or high performance? Is there a benefit to running balanced? Also, do any of you have custom power settings such as the ones dell offers, if so how do those work for you?
My parents have an E1505. The battery crapped out after about a year and we've been running on AC power (with the battery in).
Eventually the charger broke at the laptop side plug. We got a new one off ebay (china junk) and it worked for a bit. Now it turns on and shuts right off.
If I remove the battery and run straight AC, it doesn't even power on. The connector is really loose. Any way to fix it?
I've just received my Dell m1530 about a half hour ago. I plugged in the power supply (which has a solid green light) and turned on the laptop. The only thing that happens is I can hear the fan turn on.. no display, nothing illuminates, the only lights on are the blinking wi-fi symbol.
This is my first time dealing with Dell and so far it's been a nightmare.. did I get a lemon out of the box, or is it something small I'm overlooking? I'm dreading the idea of having to call tech support after dealing with their customer service.
