I want to buy a spare 130W supply for my 1645 so I dont need to keep carrying it between office and home.
Are one of these correct?
(I'm in UK)
http://accessories.euro.dell.com/sna...&sku=450-11261
http://accessories.euro.dell.com/sna...&sku=450-10540
I'm not sure of the difference between the two.
so is it the 90w or 130w for the quad core i7?? i just ordered one today but nowhere i can find about it.
View 7 Replies View RelatedSo how does one go about getting the 130w adapter from Dell?
View 3 Replies View RelatedI just recieved a PA-13.. My comp gives me an odd dos screen saying it dosent recognize the power adapter... Is there something i have to do to make it recognize..? or should it be automatically recognized..?
I have a 9400 and i was planning on putting a fx-2500 vid card in tonight... Whats wrong here..?
I have a Dell Latitude E6400 which uses Dell's 90w Charger PA-10 which is a 90w 4.62A and 19.5V.
I have been looking for a second power supply, but before I drop the money on a new one. I also have an old Inspiron which uses a the 130w Dell Charger, it is a 6.7A power supply, and the same 19.5V as my Latitude Charger.
Could I use this charger with my Latitude without causing damage? I am just a little concerned about the Amperage being higher than my current charger.
Well many people seem to suffer from the dreaded brick Failure, I have had a few go crap, and many of those failures usually were traced back to a broken wire in the DC cable assemly. If you wiggle the cable in the area if the strain relief you can usually hear the crackling sound.
I usually find it breaks in the strain relief - See attached Picture.
Fixing this can be easily done with a few items, there are a few little challanges as well.
1. Soldering Iron & Solder
2. Solder Sucker (removing tool) or Solder Wick
3. Wire Cutters
4. pliers, Small Screw drivers
5. Volt Meter (DVM)
6. Electrical tape
If you see Picture 1 of the plug, I just wanted to point out the typical barrel type connector used in the Dell laptops 6000/6400/9400/M1710 Etc.
There are 3 wires to connect here, The Out side Barrel is the Negative supply, The inside Barrel is Postive, and the inside Tip is a Voltage Sense.
I have added some new Pictures to show the inside of the PA-13 brick.
You can see the three connectoins on the bottom side of the board. The spacing is tight, and you can easily solder across two pads, checking for solder bridges is important
Please note, the spaces are small, and you require good eyes, a magnifying glass would help, and some soldering skills.
After your soldered the new connections careful inspection to check for any solder bridges is required.....
As I'm about to upgrade my Inspiron 9400 to a 7950 GTX GPU and quite probably 4 gb of ram soon, I've read that I will need a new Power Adapter since 90W won't be enough.
My question is: Is PA13 (130W) enough? Everywhere I look on this forum, they say you should get a PA13 (130W) or a PA15 (150W)...
Is there any reason to get the PA15 (150W), because if not, there would be no reason to pay more for extra power if you don't need it. In that case, why mention de PA15 (150W) at all?
My XPS L501x does not accept the 130W charger from Dell.
The original charger (90W) was broken, so I bought a new 130W charger (Art-Nr. 450-12071).
With this 130W charger connected, the BIOS says "Unknow device installed".
When I use an old 60W charger (Inspiron 6000) then the BIOS says something about a "60W AC ..."
I have already installed the current BIOS version A08 !
So, what can I do to repair my system. The L501x will not not recharge the battery with any of the chargers.
It sounded like a mouse or something chewing/clawing away at something. I freaked out I searched the entire room and finally narrowed down the sound to my damn power adapter.
It was making a sort of clicking/ light scratching noise. It's still doing it, is this normal, this is the first time I've heard it.
Heres an MP3 I made of the noise.
https://dl.dropbox.com/u/3226360/Untitled.mp3
It sounds like there are some dodgy sellers for the Dell power supplies, at least on ebay, based on some discussions. If anyone has purchased a 130W PS and feels like they could recommended the seller I'd appreciate the tip. If posting an ebay or retail link violates forum rules then just PM me.
View 15 Replies View RelatedWhat's the difference size wise? Is it negligible?
View 10 Replies View RelatedI currently have a xps 1330 with Intel core 2 duo T7500 2.2ghz Nvidia 8400M gs
3GB ram Operating on Vista home premium sp1
So far everything was going well on my laptop, did the tweaks I found on the forum and the laptop was performing very quickly. I noticed it was overheating however and called dell and they sent me a replacement motherboard.
Everything was working fine at first until I notice a huge performance drop. The computer took around 3-5 minutes to start up and all the programs took quite a while to start. The cpu usage was constantly reaching 100%.
After calling dell a few times and running a bunch of test and spyware removal tools, the problem still exist. I noticed today that this problem is only occurring when the ac adapter is plugged in and will work fine on just battery power. I called dell again today to report this finding and they still couldn't figure out what was wrong, they were just sure it couldn't be a hardware error. They can only suggest I do a clean install of Vista.
I own a Studio 1557 that uses an adaptor with 19.5V/4.62A output.
The jack sizes are identical. Can we use each other's adaptors? My assumption is that I might get away with both but that my wife might damage her laptop with my adaptor due to the higher output.
My PA-10 ac adapter died a few months ago just out of warranty, it was powering at the mains for a while but it is totally dead now. I have finally decided I need a new charger however not sure what to get.
Do I need to go for the PA-10 again or can I get the newer slim PA-3E one instead?
Its just I have found the PA-3E on amazon.co.uk for a lot less than I can get the PA-10 either from Dell themselves or on eBay.
Now for a few days my Vostro 1500 gives me message that power adaptor isn't recognized by DELL ...
and so on. But I didn't change anything this is original power adaptor from the box.
Just this morning I was using my notebook (E1505) for my homework. Than I went to class, plugged it in and the light on the adaptor didnt come on.
I tried different outlets and the same thing.
I unwravelled my cord, and the problem seemed to go away, (for now)
I guess i need to replace my power adaptor.
How long do you think it will take to get a new one?
I have the highest warranty thing Dell offers
I'm using xps with vista home premium, suddenly, I was not able to connect to the internet via Huawei e220, I googled out and find some thing called rarepair.exe and I run it then in device manager see the picture.
Also the error 720 appear when I try to connect
I don't want to re install windows
I received my 1555 today and am absolutely over the moon. Trying to installing Windows 7 RC on at the moment and apart from some small hiccups - due to user erroor everything is going smoothly. BUT
From the moment I plugged in the a/c power adaptor I noticed that every so often it produces a buzzing noise? It happens every 20sec to 1min or so and last between 1sec to 10sec each time. Does anyone's do that? Not only that, it gets pretty hot as well, when I put my hand on it(on the label side) it feels really hot, in fact so hot that I have to take my hand off unless I 'made' myself stay there. Is this normal?
I installed windows 7 on my studio 1537, but can't find bluetooth adaptor in device manager.
I also turned it on before installing. The LED turns on too.
What are your experiences regarding how hot the adaptor gets? A couple of times now I've been viewing a flash video or what ever while browsing and have found that the 90W adaptor has gotten uncomfortably hot to the touch.
i mean it gets hot enough that the label on the back with the adaptor specs has begun to bubble in spots.
I want to be able to download photos to my studio 1555 from an IBM Microdive Compact Flash type II
is this what I need?
http://cgi.ebay.com/CF-to-ExpressCar...QQcmdZViewItem
i have a Samsung TV and i want to connect my laptop to it by using an cable from the laptop (VGA) to a HDMI to VGA adaptor.do i need a special driver for my windows 8.1 Operating system?
View 4 Replies View RelatedI've got an Acer AS1810TZ (originally bought in the US) which I'm going to be using in the UK. Can someone please confirm:
a) That I just need to get a UK power adaptor to run it in the UK.
b) That this one will do the job?
If either of those assumptions are wrong I'd very much like to be corrected and shown a suitable solution -
I have brought a Vaio SR19VN. I am travelling soon and would like to know if there is a in an in-flight power adaptor for this model
View 3 Replies View Relatedare there any sony memory stick adaptors for the 13" macbook pro? can I use a usb sony memory stick adaptor?
View 6 Replies View RelatedI have a new Acer Aspire 5315 Notebook, I've only had it about a month, and just a few days ago when I tried to plug in, as the batter was about to die, it wouldn't register that I was plugging it into the AC adapter. I can't get it to charge at all. I did notice that the small LED on the box on the AC adapter was coming on, so I know it's getting power, it just won't take power to the notebook, could someone tell me if there's a way to check if it's the adapter that's the problem?
It is still under warranty, so I called Acer support, and the guy wouldn't listen to me, he kept interrupting me just saying they'd send a new adapter. I just want to be sure that's the problem.
name your network adaptor (ethernet) comes up as in your device manager.
Mine won't show up, when I download the drivers from acer it encounters an error, just need the name it comes up as in device manager,
what the model # of the 320 GB 7200 RPM drive in the New MBP is? If not, does anyone know if the harddrive comes with a Free Fall Sensor? Is there a Intel 5300 network adapter in the MBP?
View 5 Replies View RelatedMy adaptor for my battery of the VPCZ1 gets very hot. Also when I listen to it, it makes a watery sound.
View 8 Replies View Relatedi have reinstall my Presario CQ57 window 7 Home Premiun 32 bit and since than these drivers are missing.
Ethernet controller
PCIVEN_10EC&DEV_8136&SUBSYS_3672103C&REV_05
PCIVEN_10EC&DEV_8136&SUBSYS_3672103C
PCIVEN_10EC&DEV_8136&CC_020000
PCIVEN_10EC&DEV_8136&CC_0200
[code]....