I have a Dell Latitude E6400 which uses Dell's 90w Charger PA-10 which is a 90w 4.62A and 19.5V.
I have been looking for a second power supply, but before I drop the money on a new one. I also have an old Inspiron which uses a the 130w Dell Charger, it is a 6.7A power supply, and the same 19.5V as my Latitude Charger.
Could I use this charger with my Latitude without causing damage? I am just a little concerned about the Amperage being higher than my current charger.
When I plug my acer laptop charger into the wall, the green light lights up accordingly. when i plug it into my laptop the greenlight begins blinking and my laptop does not charge. is something wrong with my laptop or charger? Yesterday my laptop just shut itself off, i wasnt monitoring the battery because at the time it was plugged into the wall. Now its not charging anymore, did I burn something out?
I'm using Dell Inspiron N5110 and recently did fan cleaning on my laptop. Once I've completed the fan cleaning, my laptop doesn't detect my charger. No error message appears and my laptop only can be switched on by using battery power.
I just recieved a PA-13.. My comp gives me an odd dos screen saying it dosent recognize the power adapter... Is there something i have to do to make it recognize..? or should it be automatically recognized..?
I have a 9400 and i was planning on putting a fx-2500 vid card in tonight... Whats wrong here..?
Well many people seem to suffer from the dreaded brick Failure, I have had a few go crap, and many of those failures usually were traced back to a broken wire in the DC cable assemly. If you wiggle the cable in the area if the strain relief you can usually hear the crackling sound.
I usually find it breaks in the strain relief - See attached Picture.
Fixing this can be easily done with a few items, there are a few little challanges as well.
1. Soldering Iron & Solder 2. Solder Sucker (removing tool) or Solder Wick 3. Wire Cutters 4. pliers, Small Screw drivers 5. Volt Meter (DVM) 6. Electrical tape
If you see Picture 1 of the plug, I just wanted to point out the typical barrel type connector used in the Dell laptops 6000/6400/9400/M1710 Etc.
There are 3 wires to connect here, The Out side Barrel is the Negative supply, The inside Barrel is Postive, and the inside Tip is a Voltage Sense.
I have added some new Pictures to show the inside of the PA-13 brick.
You can see the three connectoins on the bottom side of the board. The spacing is tight, and you can easily solder across two pads, checking for solder bridges is important
Please note, the spaces are small, and you require good eyes, a magnifying glass would help, and some soldering skills.
After your soldered the new connections careful inspection to check for any solder bridges is required.....
As I'm about to upgrade my Inspiron 9400 to a 7950 GTX GPU and quite probably 4 gb of ram soon, I've read that I will need a new Power Adapter since 90W won't be enough.
My question is: Is PA13 (130W) enough? Everywhere I look on this forum, they say you should get a PA13 (130W) or a PA15 (150W)...
Is there any reason to get the PA15 (150W), because if not, there would be no reason to pay more for extra power if you don't need it. In that case, why mention de PA15 (150W) at all?
It sounded like a mouse or something chewing/clawing away at something. I freaked out I searched the entire room and finally narrowed down the sound to my damn power adapter.
It was making a sort of clicking/ light scratching noise. It's still doing it, is this normal, this is the first time I've heard it.
It sounds like there are some dodgy sellers for the Dell power supplies, at least on ebay, based on some discussions. If anyone has purchased a 130W PS and feels like they could recommended the seller I'd appreciate the tip. If posting an ebay or retail link violates forum rules then just PM me.
I can barely touch my charger it is so hot, it is one of the new slimmer blocks. It is seriously hot and nowhere near the temperature of my friends Vaio block.
with an xps used my 9300 charger and now it wont power on anymore with her old charger. it would only bring her to the screen where it says...this is a different charger, even when she is now using her original charger. it was working before on battery, but now that her battery is discharged, it's not working.
I've had my D630 for over 1,5 years now and having grown tired of lugging the 65W PA-12 adapter to work and back, I'm thinking of buying an extra adapter, so the new one would stay stationary at home and the 65W one at work and on the move, if neccesary.
I know a safe bet would be the 90W PA-10 chunky brick but looking ahead (hint E6400), I'm thinking the E-series 90W flat brick would be a better choice. D and E series chargers voltages/amperages match but will the E series one work reliably? Both choices can be had for the same money
Having great difficulty trying to find one that will plug into the cigerrette lighter socket in a car. Could really do with one as I spend quite a bit of time on the road, and being able to use the laptop would help kill time (obviously i wouldn't be driving whilst doing this )
Dell doesn't have this, but are there any good third part solutions. I guess the reason Dell doesn't have it is that the computer demands a rather hefty PSU, but still...
I have a 90w Dell charger that came with my studio XPS 13 (6 cell).
If I was to use this charger on a 3 cell Dell Inspiron Mini 12, can this seriously damage the 3-cell battery, or are the chargers smart enough to know what type of battery they're charging?
I was just wondering if someone could help me solve a power problem with my laptop. I have an old Latitude Cpi laptop which stopped working when the AC charger is plugged in.
If I remove the charger, the laptop boot up without problem, but when I connect it back again it will stop imediately.
The LED on the charger stays on green steadily, so I suppose it's a problem on the motherboard. Removing the battery and using another AC charger didn't help neither.
About three weeks ago, I came in to the machine to begin my day. The machine had been plugged and charging through the night, status=Hibernated. This is my common practice. I immediately noted the Charger light on the hinge was blinking alternately white then three or four quick red blinks rather than the usual steady white when the charger is plugged in.
I interpreted it as some sort of alarm; but after an exhaustive look, running diagnostics, searching DELL website and viewing the User manuals, I cannot find an answer.
· I checked the Windows 7 battery app and the DELL Battery Meter and “Battery Health” showed the battery to be performing normally. · I went to DELL support and ran the battery diagnostics which were OK. · The problem is seen always several hours of charging with no activity; and it is intermittent. It has happened several times since the first time. It happened again this morning. · I made the assumption that the red light was a warning and the battery was failing or in trouble – no. · Then I thought it might be due to overcharging. If so, shouldn’t the problem be every time I leave it on overnight? · Note my solution: If I unplug the machine and go on battery power when the red light is blinking and do work on the machine, when the battery goes down 10% or so, the red blinking light stops. · My machine is otherwise working well.
The probleme is that when i plug the charger into the wall, there is a green light on the charger. As soon I plug the charger into the laptop, nothing is happening (+) plus its flicking off the light on the charger
I tried several DELL charger and it did all the same senario.
I've got a Vostro 1500 and the specs for Dell's charger/adapter can be found here: http://support.dell.com/support/edoc...html/specs.htm
Dell's charger: 90W, 19.5V, 4.62A
Is it ok if I use a 90W, 19.5V, 3.34A charger instead? I'm using it right now, charger getting hot though. What do you think? Is it safe to continue using this charger with lower amp rating?
My Dell XPS M1530 just shut down on me. When I plug the charger into the laptop, the green light on the charger turns off, just like it wasn't plugged into the wall outlet.
I tried a second charger, and the light on that one just blinks in rapid succession. I've tried booting it up without the battery and with a replacement battery with the same results.
So now my laptop can't start up and I'm not sure what's going on.
Basically my 1640 laptop has worked perfectly pretty much constantly plugged into the mains for two weeks but now I have to charge it while switched off and then take the charger out when I switch it on, because otherwise the laptop just powers off after a minute of loading up Windows 7...
Also if I try to plug in the charger randomly then it just powers off.!
i have bought dell xps 1710 after few months the charger stopped charging the battery even when i changed charger-adapter / battery. so i even cant turn on the laptop :-( please give me advice what can i do or how can i ask for my money back.i dont know if there is some warranty.
