HP Envy 4-1046tx OS/Software :: No Hard Drive Found When Installing Windows 7 On UltraBook
Mar 24, 2013
I have a HP Envy 4 - 1046tx Ultrabook and the operating system is Windows 8.1 64-bit. While downgrading to Windows 7 64 bit I was unable to find the hard drives. In the installation screen it showed me "No drives were found. Click Load Driver to provide a mass storage driver for installation.".
I downloaded all the versions (from latest to the oldest) of Intel Rapid Storage Technology drivers and tried installing them one by one but they didn't work and still the hard drives aren't visible. But if I use a Windows 8 installation disc and install the driver the hard drives are visible.
I need my computer to display the hard drives by default without requiring a SATA driver. How do I do that? My chipset manufacturer is Intel and the model is Ivy Bridge HM77.
I'm new to having Dell computers. Today I received a Dell Inspiron 15z 5233 laptop with windows 8 on it. It has a 32 GB SSD and 500 GB hard drive. I can not see the SSD drive in the windows file explorer, nor do I see it in the Disk Management utility from the Control Panel. However, I do see it in the Device Manager as an SSD and another Hard Drive in the Disk Drive section. The SSD driver is up to date. I have not installed any drivers on the computer except for the Serial ATA CY1HK_WN_12.8.0.1016_A03. That was only after I tried to install windows 7 and it said "No Drive Found" when I tried to select a drive to install on.
I googled what could be the problem and saw that it could be a driver issue with the SATA connection. So I got that driver (Intel Rapid Storage Technology Driver) and the SK Hynix Solid State Drive Firmware update. These are the most current on Dells website. This is an older computer, says late 2012. It has an i5 Processor. The SSD is SSDPM830 mSATA in the device manager. Storage Controller: Intel Mobile Express Chipset RAID SATA controller. When I try to save a file, I do not see an SSD drive, there is only one drive, the C: drive which is the 500 GB disk drive. I hope I have supplied enough information to understand the problem.
So I put the drivers on a USB and tried to install windows 7 again, and it still shows No Drive Found, and when I tried to browse for the drivers, they do not appear on the USB. It will show all the folders on the USB, but I can not open the folder they are in. So I put them directly on the USB outside of any folders, and they still do not show up. Also, I changed it to Legacy mode, safe mode off for the boot settings.
I assumed I did not have to install any drivers on windows 8, because it detects everything automatically now days. Should I go ahead and install some drivers on windows 8?
My hard drive failed on my Inspiron 14z laptop. I ordered an exact replacement and installed it. The computer was purchased 2 1/2 years ago, and I downloaded the operating system on 4 DVDs per Dell instructions. After installing the new hard drive, I am downloading the 1st DVD. I come to a page that asks me to either click on "Restore my computer" or "Factory Recovery - Deletes data & resets all partitions". I click on Factory Recovery, hit next, and a new page comes up saying this application will recover your drive to the factory condition. "Do you confirm?" I click "yes", hit next, and I get yellow triangle with an explanation mark inside and it says "Your hard drive size is not supported for this process. Please use a hard drive at least GB in size.
I have an HP Pavillion dv6000 notebook with a hard drive that is partitioned. One partition contains the recovery program, which will install Windows XP should I ever need it to do so. I have recently installed Windows 7 on the other partition, and believe it would make sense to install Windows 7 on the recovery partition, so that if it is ever needed, it would reinstall Windows 7 rather than Windows XP. How can I accomplish this?
I have Acer Aspire 5742G notebook and I'm having problems installing the Windows 7 OS on my new SSD hard drive (I bought the SSD because the original hard drive is failing and making blue screens all the time...)For the factory restore, I'm using restore discs. I burned the discs few years back when the laptop insisted me of doing it (by using eRecovery or something, 3 dvds total).
The computer tries to install the OS with the dvds (asks to insert a dvd and then press a key). The actual problem is that the installer is just going in loops, restarting and eventually freezing in the end.. Reboot -> Acer logo -> Windows is loading files... -> Starting windows -> Reboot -> etc.That kept going for more than a hour (on the first dvd!) and suddenly it just froze on the "starting windows" screen.. So I had to reboot and star over again.I can still use my old formatted HDD, should I make new set of recovery discs or use an USB drive?
I'm installing Windows 7 x64 on my HP Envy 14 2090.
Setup cannot find my harddrive, presumably because a SATA driver is missing. I have tried the supplied SATA driver from HP driver download page for my model, but they don't work. I've tried various others, still no luck.
The harddrive is found by BIOS. The harddrive has been working without a hitch for years, right up until I tried a re-install.
PS: I'm not using the HP recovery DVDs, since these install all sorts of unneccessary software I don't want. (Why do all major laptop producers add this crap?)
Where can I find the correct SATA drivers for use with Windows 7 x64 installation?
I am having difficulty booting Windows 8 on my HP Envy 4 Ultrabook. Firstly when I try to login to Windows using my Windows 8 password it says "The User Profile Service service failed the sign-in. User profile cannot be loaded".
Then following advice from other online support forums including this one, on restarting the computer then pressing F8 repeatedly I get the following message: "Boot device not found. Please install an OS on your hard disk. Hard disk (3F0).
HP Pavilion Dv5-2077cl Entertainment NotebookProduct #: WQ799UA#ABAWindows 7 64-bit
I have been getting a random blue screen popping up every once and a while, that will "dump my physical memory" or something and then reboot itself after like 30 seconds. my hard drive was the reason for these constant errors. So I backed everything up, in preparation of a real crash. I am in the process of ordering a new hard drive from Newegg.com, and I would like to know if it is hard to replace a hard drive in a notebook, or if I should have Geek Squad do it for $50. Also, I dont think I have the Operating system disc that came with my computer, so how do I order that from HP and how much is it?And last but not least, Is there a post or video with instructions on how to install a hard drive and the operating system?
My hard drive turned bad few days back and i now purchased a new WD3200BPVT 320 GB internal hard drive for my system. I installed it myself after reading all instructions and guidelines. But when i start it, system says, hard drive not found, try to reseat it. I have also reset it, but again same error coming. I dont know whats gone wrong with the hard drive or system..?
internal hard drive disk not found; no bootable devices; start up repair finds no solution..... I have reseated the hard drive several times. the computer runs extremely slow. Dell Data Safe had recommended replacing the hard drive ''couple of months" ago.
I have Inspiron 14R N4010. Its 2 years old. Its Toshiba hard drive(320 Gb) crashed 8 months before so I bought new WD hard drive(500 Gb), which also crashed again 2 weeks before(OS drive had bad sectors apperently) . Hence i got it replaced by WD for a new 500Gb hard drive.
Now, when I am trying to install OS in my new hard drive, i am getting following error:
after learning about possible mistakes by reading some forums
1) I checked that hard drive is installed properly, all connections are good. 2) DVD I'm using to install Window 7 is bootable one & i have used it before 3) BIOS settings are checked to boot fromCD/DVD drive. (It is not booting from network adapter which supposed to be reason for ethernet error as per many other forums) 4) I tried draining current by pressing power button for 20 sec to reset settings.(I read in some forum) but even that didn't worked.
BIOS is detecting hard drive...so that is also not issue. Could new hard drive be damaged? should i get this new one also replaced again? I need some way to confirm this before me sending it back to WD.
In one microsoft forum, I read for same problem
"update the basic input/output system (BIOS) to the latest version by contacting the motherboard or computer manufacturer and check if it works.Important: Modifying BIOS/complementary metal oxide semiconductor (CMOS) settings incorrectly can cause serious problems that may prevent your computer from booting properly. Microsoft cannot guarantee that any problems resulting from the configuring of BIOS/CMOS settings can be solved. Modifications of the settings are at your own risk.
That's was Dell's Diagnostic's (F12) tells me about my Studio 1745 - and no other errors are found. I'm assuming it's has a fried hard drive but how can I be sure before I buy a placement hard drive and install it?
i just bought my hp hdx 16 yesterday the main reason i choosed hdx 16 over dv6 is the second hard drive option(as said in maintenance guide) now i opened the back and no place for my second hard drive if any1 knows where the connector
My Macbook is coming in tomorrow, but I've already got a new hard drive that I'm planning to install on it. How do I install the OS onto the new drive? Do I just assemble the new drive in and put the CD that comes with the Macbook in and it'll do everything for me?
Installed replacement hard drive in Latitude E6510. Ordered same drive as originally installed from Dell. When I try to install OS on new drive I get the "No Boot Device Found" error. When I enter set up the HDD and DVD drive are shown as installed. I changed the boot sequence to have the DVD run as first boot device.
i just bought my hp hdx 16 yesterday the main reason i choosed hdx 16 over dv6 is the second hard drive option(as said in the maintenance manual) now i opened the back and no place for my second hard drive
I have to swap out the current hard drive on my old Power Mac G5 because it's become unreadable. I've decided on the hard drive to replace it, but I have no idea how to go about installing the operating system. Moreover, my Power Mac G5 came with 10.3.5 Tiger, so is it safe to upgrade to Leopard even if I have older components?
I just got a new 640GB hard drive, and plan to install OS X, Windows XP, and Ubuntu on it. I would like some guides and recommendations on which operating system to stalled first, and what other preparation/softwares I need to get before installing.
I have a system hp pavilion dv4 2101tu. My 320 GB internal hard drive got corrupted and i just bought 500GB new wd black internal hard drive. the problem is that when i am going to install window , i am facing problem . Just tell me that is there any prerequisite for installing a new hard drive into laptop. How to update bios information where it's shows i.e. internal hard disk size is 320 GB.
I had to install a new hard drive onto Dell Inspiron 17R (5720, Mid 2012). Ordered new hard drive from Dell, and also Operating System reinstall DVD. Windows was loading, but computer shut down and did not restart. I pressed the power button to restart, but now get 'BOOT MGR is missing' error, and don't know what to do next. I chose 'Custom Installation' and selected the only hard drive that was visible when prompted. Computer will not restart with DVD or without DVD. What now? Windows 7-
I have a Dell Latitude E6330 laptop and I recently replaced my hard drive as my old one had died--this was confirmed by the IT department at my school. After replacing the hard drive on my laptop, I found that the Fn+F5 command to disable my touchpad/touch stick was unresponsive. Upon further inspection, the touchpad button on my system tray was gone, and all touchpad related functions of my laptop were gone. In place of my touchpad (and all windows, settings, options, etc. ... that concerned it) was this ps/2 compatible mouse, which I am not allowed to disable.
I am a gamer and a student, and having my touchpad/touch stick enabled hinders my ability to type or play games as easily as I am used to due to misclicks. I used to be able to set my laptop to disable my touchpad (and other related hardware) automatically when I plugged in a USB mouse, and I would like to return to this setting if possible. How to do this without disabling the touchpad in the BIOS (as I do need to use my touchpad during lectures) ...
just picked up a new ENVY 15 from Asia. It was preconfigured on special with decent specs. The only downside is that it only comes with a 500GB hard drive. I was looking under the North American specs for the customizable model and noticed that there is an option for a secondary hard drive. Just wondering if anyone can confirm this? Don't want to operate on this beauty if the second drive bay doesn't even exist.
I have an Envy 14-1110NR laptop and am getting a Hard Drive failure imminent message every time I boot up. Having run the HP diagnostics, the hard drive check fails so I'm guessing I have to replace it.
The hard drive is a Samsung HM640JJ which has gone obsolete.
I bought yesterday new notebook, HP ENVY 17-j162no. The very first time (and each time later) I started the laptop, I got an error of smart drive failure. I have never before on any computer experienced that even after such an error, nothing seems to be broken. I went to BIOS and ran the examining tool, and you can see below the results. What's the next step to do?
SystemDiags.log 2014-10-05 11:28:30 ================================================2014-10-05 11:28:30 EFI System Diagnostic 5.4.3.0 Started2014-10-05 11:28:30 Load Options =2014-10-05 11:28:30 Old Hii Protocol not found.2014-10-05 11:28:30 SysDiagsBiosData2011 Configuration Variable Acquired2014-10-05 11:28:30 Absolute Pointer Protocol Not Available
Has anyone attempted to remove the turtle 4200rpm drive that comes with the base unit and install a 7200rpm or a better SSD drive? Just wondering if its possible for someone with a little know-how.
