Ive recently bought 2-2gb sticks to upgrade my memory to 4gb. Ive seen that for vista it can only support up to 3gb, which is fine,
but my computer still says that it is only 2gb? whats wrong
The keyboard is sticking out from the right hand side...So I can literally lift it up from the lap top using my finger.
Also the lap top doesn't stay balanced sitting on a table. It rocks back forth as if one of eraser pads underneath is bigger than the other. But that's not the case after I examined it..
I've only had it for 5 months and today is the first day I noticed these things...It's never been dropped or anything with light use.
I have the extended warranty, I wonder if its covered.
SZ Series Windows 7 Clean install (32bit and 64bit)
Primarily for the SZ750, but works most other SZ models.
Yes, it's long, but it overs a lot and makes it very, very simple.
A Note about the "new" Sony utilities on their website.
Don't bother, you end up with FAR less functionality than you will with this guide. Sony simply put up utilities that work with Windows7, they didn't check to see if there is a driver to allow them to work.
Contributors who helped fine tune this guide:
Rachel, James007bond, Jtravers, Jupillam, Aralos1999, CKF92
Status:
32bit 100% working – Use the Vista drivers and Utilities.
64bit 99.9-100% WWAN is possibly working (depends on the model, see below under “issues”)....................
Anyone could tell me if this is feasible to be installed on the TZ.
> OSWIN32 >
http://www.fadfusion.com/selection.p...er=10122600671
I'm looking at purchasing an FW with only 2g of RAM and upgrading it myself cheaper than I can do buying it from Sony. The RAM from Sony is DDR2-800 PC2-6400. where to buy a couple 4g modules (2x4, 8g total)?
View 3 Replies View RelatedI got a Vaio Z620D, it's a Canadian Model. It's got only 2GB of ram, so I am looking to add 2 more. I was told that it should match the frequency or something like that, I am not too sure about the whole deal.
[url]
Here is the detailed specs for this laptop, just scroll down for the RAM info.
[url]
Figured the G60T was sufficient, cheaped out on everything, 3GB memory. Loaded everything up and started receiving blue screen in Vista. Reloaded from factory image and still seems to be flaky. I ran memtest 86+ (failed in test 5 and 8) and windows diagnostic tools failed ERAND test. I think the memory is okay as they test fine separately so either timing off or bus or something else is messed. One week of frustration with HP support. Bottom line HP answer is if the BIOS memory test runs okay, then everything is okay. What a hassle. Anyone know if there is some quirk that would have the tests fail but everything be okay? I guess we'll return but printer and other rebates were bundled in along with cash back.
View 3 Replies View RelatedI have a Sony Vaio S460 laptop.
Recently it had been lagging really bad, and so I was advised that it might be a power supply problem, or, another solution would be to upgrade the memory.
I went to my local computer store asking about it, and he recommended trying to upgrade the memory (I currently had two 256 MB memory sticks, for a total of 512).
I told him my model number, and he pointed me to a Kingston 1 GB memory stick, and said he was pretty sure that it would be compatible. Since it was only $10, I bought two of them.
so I went ahead and replaced the two 256 MB memory sticks with my newly acquired 1 GB memory sticks. But after I put the laptop back together, and I pushed the power button, nothing showed up on the screen (although the lights indicated the power was at least on)
Considering buying a UK spec Vaio FW laptop. How easy is it to upgrade the memory on this?
From 4 to 8 GB. Looking at the spec on the Sony UK site it looks like it's already fitted with 2x2GB RAM
And would either of these brands be compatible? - Crucial.com or Orcalogic.co.uk .....
Sony VAIO W211 comes with 1GB installed with max. upgrade limit of 2GB.
Can someone tell how easy or hard (as in Dell 1010, forget about doing it because you have to disassemble the whole thing) to upgrade the memory on this
DDR3 PC3-8500 or DDR3 PC3-10600 modules? Two 4 GB modules or a matching pair 8 GB kit?
View 4 Replies View RelatedI just purchased a used Elitebook 8540w with i7 quad core and four memory slots (I love it!).  It is running 64 bit Windows 7 Professional  It came with one 4gb memory module and I purchased an additional 4gb module to bring total RAM to 8gb. Â
Â
I have the HP document that shows for two 4gb memory modules, one should be in memory slot 1 and the other in memory slot 3 for correct functioning of dual channel memory. Â All set right?
Â
Not quite.  In the Elitebook 8540w, the primary memory slots under the keyboard are clearly labeled "1" and "2"  However, the expansion memory slots on the underside of the chassis are also clearly labeled "1" and "2"  Opps!  There is no "3" and there is no "4"  In which of the unfilled three slots do I install the second 4gb module for correct functioning of dual channel memory?
I recently upgraded my ThinkPad W530 laptop BIOS from version 1.11 (which it shipped with) to the latest, version 2.59.
Â
After doing so, my two 16 GB DIMMS are not only showing up as 8 GB each, thereby cutting my usable memory in half from 32 GB to 16 GB.
Â
I ran through all the normal hardware checks to ensure that one of the DIMMS wasn't bad. Â I tried each DIMM separately, tried in different slots, etc. Â They both show up just fine and even pass the memory quick test in the BIOS. Â Only, they are showing up as 8 GB DIMMs.
Â
Is there a feature in the latest BIOS that would somehow limit this? Â It was working fine at 32 GB before.
Â
And, unfortunately, there is no reverting back to BIOS v.1.11 from anything after v.2.55. Â It asked me if I was sure I wanted to proceed...this was the last type of problem I expected to see though. Â (I also tried reverting back to previous versions of the BIOS that were allowed and it didn't work...
I have a 2.5 year old E1705 notebook. I'm going to upgrade to W7 soon and in the process I thought I'd upgrade my memory from 2GB to 4GB.
I ran Dell's utility from their tech support page and it seems to be the case that the maximum my computer will support is 2GB! Is that possible?
In any case, I ran a diagnostic program (from Dell's utility) and it says my computer has two memory slots, and currently each slot on my computer has "Dual In-line Memory Module 1GB, 533, 128X64, 8K, 200", whatever that means.
I assume the 533 is memory speed (Hz) value. So according to Dell's utility, I am unable to increase the amount of RAM, but I could, for instance, "upgrade" to better chips (i.e., Dell sells DDR2 SDRAM Memory Speed: 800 MHz). Price would be $56.
i currently have a TM 5720 with 2GB of ram. I was thinking of upgrading it to 3GB. I was wondering if you think it will make much of a difference and whether any of these would be suitable (already done a small bit of research)
i cant post any links but had seen a few on play.com
2gb pc 5300 200 pin
would it matter that there would be 2 different types of RAM in the laptop.
I found out from the release notes for BIOS 3.60 that one of the changes is to "update kernel code for 4GB memory support". Does it mean that if I update my BIOS from v 3.33(dated 9/1/07) to v 3.60 I will be able to increase my current maximum memory of 2GB to 4GB in Acer Aspire5610z.
View 5 Replies View RelatedI have Aspire2000 and am trying to upgrade RAM to 1GB.
I already bought 2x512mb sticks and I CANNOT find second ram slot.
I managed to find the first one which is located on the bottom of laptop.
Where is the second slot? If it is under the keyboard or you have to dissect whole computer, how do you get to that area?
I have a m7750n HP Pavilion PC, it comes with 2 gigs of memory. I just purchased a GeForce 9800 gtx+ graphics card and installed it, it uses 1 gig of memory.
When I play games my psychical memory shoots up to almost 100% and have a very low fps. I was wondering if there is a way to improve this. Is my system eligible to get another gig?
I recently got a Macbook Aluminum (the 2.0 Ghz), and i'm really impressed with it. Well, i haven't really explore everything (first time using a Mac, so please be gentle, ).
One thing's for sure is that i absolutely love the trackpad. The swipe thingy is incredible.
Anyway, any advice on applications that I should be using? I mean, other than the ones stated here (a superb guide by Sam if i might add)
I plan to install Windows to do some programming (job requirements, visual studio 2008 bla bla bla). Should I upgrade my memory to 2 x 2gb? Currently considering between boot camp and vmware...
I'm planing to upgrade Ram Memory of my DELL XPS 15z for running some virtual environments. My question it's about the max amount of memory that the laptop support and the compatible memory modules. In some forums I read about 16Gb, but Dell PcCheckup shows 8Gb as the max amount of memory.
View 6 Replies View Relatedcan i upgrade from 2GB to 3GB or necessarily i have to go to 4G?
tks, Douglas
I have a Dell Inspiron 9300, about 4 years old. I bought it with 1 gb RAM, and I'd like to extend the life of it by a few months, and make it a little faster.
This is the RAM that dell recommends for my laptop to upgrade:
http://accessories.us.dell.com/sna/P...x?sku=A0758238
Unfortunately, looking at my order when I first got the laptop, it says this .....
I have a Dell XPS M1210 notebook with 2x512MB DDR2 533MHz Memory. Now i wants to upgrade my memory but there is a lot of confusion in what module
i should buy.
After going through several sites i have came up with a few options and understanding them is so far above my knowledge.
There are 533MHz and 667MHz available ...
i do not know which one should i use .
There is also question of dual channel and shared channel ... where i am totally lost.
My hdd crapped out and I'm replacing it - I am toying with the idea of upping my memory as well. Current memory:
DUAL IN-LINE MEMORY MODULE, 256, 333, 32X64, 8K, 200
I am looking at one stick of:
Transcend 1GB 200-Pin DDR SO-DIMM DDR 266 (PC 2100) Notebook Memory Model TS128MSD64V6A - Retail
I mainly use office and surf the net.
PROCESSOR, 80535, 1.5G, 1M, PENTIUM M BANIAS, PLASTIC GRID ARRAY, INSPIRON
1) Given my usage and proc, is adding 1gb overkill?
2) Is there any advantage to getting 2 new sticks of 512, rather than one new stick of 1gb and 1 old stick of 128mb?
3) Is there any advantage to getting higher-speed ram (PC>2100)?
I've just completed a CPU upgrade on my 5315 (to a T7300, which took 15 minutes!). I'm now thinking of upgrading the memory from my current 2GB @ 667 MHz (with the new CPU the memory runs at 667 MHz rather than 533 MHz with the old CPU) to 2GB @ 800 MHz.
However, I've read that the performance increase between 667 MHz and 800 MHz is very little, thus, it's not worth spending the money, even if it is only $AUD40.
Can anyone provide any input, benchmarks or experiences?
I have a 5810TZ that I have upgraded to Win 7 64-bit. I have tried to upgrade to 8GB ram and Windows hangs. CMOS reads it as 8GB, but I cannot get Windows 7 to boot.
I have installed two 10600 DDR3 chips. If I remove one chip, it boots normally. It doesn't matter which slot I use or which chip I use. But when I put both chips in, Win 7 hangs.
Considering an Aspire One right now because it is less expensive than the others. I have a 512MB RAM (DDR2-PC5300) and 80GB 2.5" SATA HDD from my Thinkpad (which I upgraded both). So, I think maybe I could buy the Aspire One the cheapest version (8GB I guess).
So, is it can be done? I know that there is SATA version of the Aspire One but not sure the connector will be there in the SSD version. Try to google it but found only SSD upgrade....
I also have a HP DV800 and i want to upgrade the memory.Currently it has 512 mb, but i'm not pretty sure what is the maximum that i can upgrade.
Is it 1GB or 2GB?
I ask this because one time somebody told me that there are 2 versions (or something like that) of this laptop. One has DDR and other one DDR2. I'm not really familiar with those terms. Can somebody explain to me which one can i do?
I was checking on EBAY, to buy them but i'm not pretty sure:
[url]
I wanted to upgrade the laptop memory which originally had one 1GB module in the primary slot, and nothing in the secondary.
I purhased 2GB of DDR memory and installed according to the user manual with no problems. At the time I was running XP Pro, and have now updated to Windows 7. Everything still works very well.
Only problem is, neither XP Pro nor Windows 7 seem to report that I have 2GB of memory installed? only 1GB? was there something I had to change that wasn't mentioned in the manual, like a BIOS etting or something? I thought both Windows versions would automatically detect the upgrade
Sorry if I'm being dumb here, never done this to a laptop before! If you know the answer could you also tell me how please, it would be very much appreciated..thank you
HP/Compaq nx8220 (PY518ET)
I upgraded my 2.4 Ghz MBP, to 4 gb ram from 2gb. I use crucial, but i think systems feels hot on the right side. and the base! is that normal?
View 9 Replies View Related