Sony :: Z590 With 2.26 Ghz Processor, Can I Upgrade It
Jan 23, 2009
Are the components that come in a 2.26 ghz motherboard compatible with a 2.53 or 2.66 or higher ghz processor? I plan on ordering a Z590 as I fear the 690 will end up starting at a higher base price (ie like in Canada), and then upgrading it with a faster processor, more ram, etc. I just want to make sure I can do all of those things without issue.
I'm trying to determine if owners of Z590s that were purchased after the win7 upgrade start date (6/26) have been able to register for Sony's upgrade program.
several people here who have been able to upgrade their SZ's to x9000 processors. I want to do the same but I want to know if it is as simple as putting the processor inn or do you have to do some modding. I am also interested in upgrading to a x7900 or t9500. Basically the x9000 is my first choice, x7900 is second and t9500 is 3rd and I want your advice as to what to do, and will I need to do any modding to put these processor in my SZ670?
I had replaced mobo on my dead SZ 4 series (don't ask why) and couldn't stop there since I was in the move thus consequently contemplated about possible upgrades. For now I settled for fan, WLAN card and CPU upgrade. If it works well, I might install SSD also.
1.Fan Modification
As you all proud SZ owners know, fan is very noisy on this machines so it made me think if there is any possible modification to reduce the noise. Since the BIOS is controlling it there is not much to do on the RPM part (in win at least, but more on that later) I settled for a fan and fan casing swap from SZ 4 to SZ 7 series.
In the photos you can see that fans, fan casings and heat-sinks are of different design. Besides design differences, voltage and the amperage are the same, 5V-300mA.
Only way was to install the fan and the casing of the SZ 7 heat-sink to my old one as one of the heat-sinks bolt bushings is off for a few millimeters.
There has to be some care exercised when prying off the fan casing, some heating was required from the aluminium side on three pins were casing is attached.
Not to be simple, the difference is also in the inlet hole. One on the SZ 7 heat-sink is bigger and off centre compared to SZ 4s. Had to do some filing there, to match it to the size of the new fan. Fan of SZ7 is not bigger, it is due to different design of the fan eye and its volutes...................
Not sure who moved my post to "price check", but if I wanted it there I would have put it there as I am looking for opinions from Sony users and owners who frequent this specific thread and possibly not the price check thread. Thanks
I am preparing to sell my Z590, it has 4GB of RAM, original Sony restore disks, 320GB 7200 RPM HD and I believe a 2.4Ghz P8600 processor, slimline ac adapter and the Sony high resolution screen.
after seeing that Sony had updated it's drivers page with Windows 7 drivers, I decided to take the plunge and install Windows 7 on my VGN-Z590.
Everything worked out fine, and seamlessly (well, except video, that one got a little weird for a bit, but I eventually figured that out), except for one thing.
I have a Sony SRS-BTM30 Bluetooth speaker. This used to work just fine with my VGN-Z590, when I was running Vista on it, but now that I've installed Windows 7, it refuses to connect.
I can pair it just fine, it shows up amongst my bluetooth devices, but unlike previously, it does not show up in the list of "Playback Devices" (in the Windows 7 mixer/audio controls), and if I go to Audio tab of the Windows 7 Bluetooth Settings, it shows up in the list of devices, but if I select it and click on Connect, it will flash "Connecting" for a second, then return to its previous "Disconnected" state without connecting.
So, I was wondering if anyone else had any similar experiences with their Bluetooth gear.
Also I am wondering what Bluetooth driver you guys (people who have upgraded their Zs to Windows 7) are using? I noticed that there are no Bluetooth drivers listed in the Sony eSupport site for the VGN-Z590's Windows 7 drivers. I tried, uninstalling the Bluetooth drivers that came along from my previous OS (Vista) install, during the Windows 7 upgrade process and tried reinstalling the Windows Vista Broadcom drivers for the VGN-Z590, but that didn't seem to make a difference.
I just got a CTO Z590 2.4 GHZ, 3 GB ram, Vista Business "Fresh Start". I'm getting a feel for its performance.
When I attempt to play a HD video with my from within IE, Chrome, Firefox, or quicktime at full screen the video is choppy, less than 10fps. I've got the newest versions of webbrowers, flash, and quicktime.
Here are some examples:
[url]
[url]
[url]
I've let the videos buffer so internet connection isn't an issue, and I'm in "speed" mode.
I'm upgrading from 6 year old 1.4Ghz Athlon, so I had expected the Z590 wouldn't have a problem, am I expecting too much?
I configure(CTO) the same spec (color, CPU, Harddrive and so on) for all these three. But the prices are a little bit different. They have same graphic card 256MB too. Does anyone know about the difference?
Another question is... Are Sony SR series good? I configure them as Z series, the only difference is DDR2(SR) and DDR3(Z) and SR even has 512 graphic memory.
I didn't make the disks when I first bought the computer (not sure why not) but I want to make disks for just in case I need to reformat in the future. What are the steps I need to take to do so? I am using Windows Vista Business.
just installed the Intel X25 160GB SSD. If you all coach me on what benchmarks you would like to see I would be more than pleased to post them.
It does seem to make the system snappier - but I question the cost benefit.
My question for you all is that I cloned the drive using acronis true image and I am wondering if I would get better performance if I did a clean install rather than a clone of my drive?
I recently updated my bios and decided to do a new full install of Windows 7. (Previously running Windows 7 Beta).
After doing a clean install and installing the Sony Notebook Utilities. I started getting this pop up message.
"The installed battery may not be properly connected to the computer or may not be compatible with the computer.
Click OK to enter Hibernate Mode, and remove reinsert the battery See the electronic VIOA(R) User guide for more information about using the battery"
At first I thought this was an issue with Windows 7 - so after searching the forums and no results I figured I would revert back to Vista. Now I am getting the same error.
I also have two Sony Notebook batteries here - both bought direct from Sony. One extended and one standard - both give same error message.
Could this be a BIOS issue? Is there a way to revert to an older bios?
if it is possible to upgrade my Studio 1535's processor (Intel C2D T5750, 2.0GHz). I cheaped out on most of the parts when I first bought this thing, as I was somewhat strapped for cash, so I went with the bare-minimum processor, but now I think I can do better.
So, is it possible to replace my processor? If so, what are some compatible models? I'm looking for at least 2.4GHz, for the record.
I was looking through some of my spare parts the other day and I came across a Pentium M 2.13GHz processor I removed from an old laptop I had a while back. The only problem is it was just thrown in a drawer with some other laptop parts, where its sat for about a year.
I was just wondering if anything bad could come from using it in my laptop since it hasn't been stored in ideal conditions. I looked at it pretty closely and there don't appear to be any bent pins or anything.
Im thinking about upgrading my processor in my M1730 from my 2.4 to somthing with a little more mustard.
I am concidering the X9000.... Will this work with my m1730.... also does 1730 have potential for 64 bit.... Im lost as I have been out of the loop on this machine for a while.
i'm new to these forums and know VERY LITTLE about computers. i bought my laptop 2 years ago and cheaped out on the processor to save some cash.
i want to upgrade the processor now because it is a little slow for my liking plus i want to be able to play some newer video games like BC2 and MW2.
my current processor is an Intel Core 2 Duo CPU T7100 @ 1.80GHz
I dont know too much about computers like I said but im pretty sure I want one that can run at at least 2.4GHz and read that the T8300 ran at 2.4GHz in a thread but that thread was about 3 years old XD.
edit: found an Intel Core 2 Duo CPU T8600 @ 2.4GHz for $210. is that a good deal?
I've been out of the hardware game for quite some time. Cisco for 2 years will make you forget stuff.
I have a Dell XPS M1530, T9300 processor. I am wondering if I can upgrade to the T9900. Also, my current processor is 32 bit. Can I get a T9900 in 64 bit, and will it work with my mobo? OS doesn't matter, can redo it. I am trying to beef it up for better gaming. 3gb ram is killing me...
Another question. Just wondering if it is possible to get an i5 or i7 instead? Will the i7 physically fit into the slot? 45nm
Yet another question. The laptop runs hot already. With a processor upgrade, surely it will run hotter.
I'm using a Pentium M (730) 1.6 GHz processor. For the moment instead of buying a new laptop I'm interested in upgrading the processor.
The Bios shows that it can detect and appears to be able to use a dual core processor but none of the 9300's were ever sold that way.
The motherboard uses a m-FCPGA socket. Does anyone know or has tried to use a dual core processor in this motherboard? I'm even curious as a project but,
if someone has info/data on this I would truly appreciate the info. I have a 250 GHz harddrive and 2GHz on the RAM. Looking to speed this thing up a bit before finally putting her out to pasture.