today for some reason,my dell vostro1700-xp with mouse attached to bottem right hand side.usb port stopped working.
everytime i plug it in now it starts out ok working-then the mouse stops working all together within 1 min after plug it in
states in the little bubble
usb is not recoognized,windows does notrecognize it,one of the usb malfunctioned
did i lose usb ports ?
the previous m4400 mouse driver wouldnt recognise the middle button....and now the new one dated 4th january wont recognise it either !!! this is getting really annoying...
running windows 7 x64
Just updated my mouse driver with the one released on the 24th, it dosent recognise the middle button. Basically the software has 3 options, right button, both buttons, and left button
this means i couldnt set the middle button to perform a click.
The E4300 uses the Dell Touchpad driver and I think it feels very buggy.
It looks like the Dell uses an Alps hardware
This is probably the first time where I'm quite annoyed by a touchpad/buttons. The touchpad buttons do not always respond immediately, sometimes requiring two presses to click.
And sometimes, when I'm using the touchpad, it will automatically click on a link I didn't intend to.
I know this seems minor, but it's quite annoying at times. I almost returned the laptop because of it, but now I'm trying to live with it but it would be most helpful if there was an alternative.
I just bought an Acer computer, and am to the point where I am about to return it for a MAC because I cant turn off the tap to click feature. I have tried going through the control panel and messing with the mouse settings. I have tried to install the elantech driver as well as the synaptics driver. I can't get the drivers to actually work. I have contacted Microsoft and they are basically like "we don't know so go ask Acer."
View 2 Replies View RelatedI got my self a Thinkpad S1 Yoga (20CD) and I have two issues;
1) The wireless lan driver fails and startup. (Dual Band AC 7260)
2) The trackpad acts as a simple mouse. (ultranav driver is installed)
I'm running Windows 8.1pro (x64). All drivers are updated and the BIOS is updated.
The wireless lan driver starts normally when I disable USB3 support in the bios or disable the "Intel(R) USB 3.0 eXtensible Host Controller - 0100 (Microsoft)" in de device manager.
When I disable and enable the wireless lan driver again the driver works normally.
The trackpad does not support actions like scrolling.
The soundcard just turned off, the computer crashed and turned off. When it was back up, the soundcard could not be founded anymore, and i've got like fourty "Unknow Device on High Definition Audio Bus" on my device manager.
Like that:
I've tried everything, used all the recovery options from hp, even the restoration to the recorded image of the system. Tried to reinstall all drivers and nothing solved.
The system kept throwing windows nonstop. Like that:
So, what i did was just disabling the High Definition Audio Bus on System Device, and bought an Usb external sound card. Ok, its working great, BUT, i obviously dont get any sounds from the internal notebook speaker or microphone. And neither the mute light, on quickplay buttons, works. Its red all the time. Muted or not.
BUT, i want to give this notebook to my wife, but i still use this external soundcard for my musical recordings. So i really needed to figure out a way to solve this. I've contacted the HP Support Staff, none of them could help me. Warranty was over months before the problem. Obvioulsy.
OK, yesterday we bought a new Belkin router and were connected to a laptop, the home PC and Xbox Live. Today, I turned on our other laptop,
that had never been connected to the new router, and when I searched for networks, a screen cam up and asked me if I wanted to change the name.
So I did, and entered a key number and now, I cannot connect with anything, or to LIVE.
A year ago something odd happened. The soundcard just turned off, the computer crashed and turned off. When it was back up, the soundcard could not be founded anymore, and i've got like fourty "Unknow Device on High Definition Audio Bus" on my device manager.
Like that:
I've tried everything, used all the recovery options from hp, even the restoration to the recorded image of the system. Tried to reinstall all drivers and nothing solved.
The system kept throwing windows nonstop. Like that:
So, what i did was just disabling the High Definition Audio Bus on System Device, and bought an Usb external sound card. Ok, its working great, BUT, i obviously dont get any sounds from the internal notebook speaker or microphone. And neither the mute light, on quickplay buttons, works. Its red all the time. Muted or not.
i turn on my computer again and it goes to acer arcade instanton. i exit it and then when vista boots up it tells me to chkdsk. im suspicious but i skip it... when i login it tells me that my user profile is messed and thata bunch of stuff is corrupt. i then do chkdsk and luckily it manages to repair it and i still have my files. however all of my settings and user accounts are gone... also a lot of things dont feel right.
i think after backing up i might do a reinstall. just to confirm, if i use the recovery dvd, D:/ will not be touched right? (D:/ is where my files will be saved)
I've got a Sony Vaio FE model. The screen, processor, ram, wifi, etc. all work well except the graphics card (geforce go 7600). I can get my computer working but only at a resolution of 640x480. If I go to display properties and increase the resolution, the screen shows a bunch of white lines all across for a second and then restarts.
Its very hard to use a pc at that resolution! Sometimes I can change it to 1280x800 if i get the computer hot enough (weird, i know) but then (i guess) as soon as it starts to cool down the screen goes blank (after some time it will go back to 640x480 in 8-bit colour mode and show a nvidia nv4 error) and then I usually hold the power button to turn it off cuz I don't want to wait for the nv4 error which takes 10-15 mins.
I have an HP dv5t Notebook with a wireless card, Belkin. I dont know much about wireless adapters so it figures I would screw this up. I was trying to play with it to see if I could turn my wireless connection into working with my Xbox 360 (long story). To simplify things, I went into the Belkin standard IP address for utilities and enabled a "local access point." Since then, I have been unable to access internet or even access the Belkin menu to disable what I did!
View 7 Replies View RelatedI thought it was a good idea to update my BIOS from F0.A to F17.
I am now stuck with the fan constant running and I have checked some other threads and found that you can switch this off in the BIOS.
I have checked and it is already switched off!
I tried to restore to go back to the old BIOS but it seems I am f****d. Not possible.
Are there tricks to go back to the original firmware.
Are there third party software that can stop the fan turning all the time.
i just broke my screen and the screen doesnt work anymore(all the pixels are messed up) under the basic warrenty which is 1 year would it cover for my screen replacement? its a dv3t hp laptop
the basic warrenty is the manufactory warrenty so it diidnt cost me a dime when i bought the hp
I wanted to install vista. I did the normal bootcamp procedure but forgot and extracted candy bar at the same time the partition was being created.after the partition was created and the message appeared telling me to insert my windows cd appeared, my mac froze. I held down the power button and forced shut it down. I switched it on again and windows setup started. Everything went on fine and i booted in windows fine. However , when i wanted to enter my os x partition, it would start and go up to the part where the rotating circle would appear. It continued rotating for a long time and then restarted my mac. I tried again several times and it did this. I then booted my mac from the os x install dvd and selected install os x on the windows partition. Setup failed. I launch disk utility and verify and repair disk partition (There was no problem when i did disk check). I restarted my mac and everything booted fine. I now have a new partition labeled "mac os x". I launched bootcamp manager and tried to restore my disk and get the error: "The startup disk cannot be partitioned or restored to a single partition: The startup disk must be formatted as a single mac os extended (journaled) volume or already partitoned by Bootcamp Assistant for installing Windows".
How do i format it in this format? Do i have to use the setup disk again or do i use disk utility?
I restored my Acer Aspire 5720 laptop using the factory restore DVD . I used to be able to press Fn+MJKLUIO78, or Fn+9 to type the numbers 012345678, or 9 while holding the Fn key.
After I finished restore the laptop to the factory image, the Fn+M...9 keys didn't work anymore.
Instead of mapping the keys to 0..9, it mapped the keys to Home, Up, PgUp, Left, Right, End, Down, and PgDn.
So for example, if I press Fn+L, instead of "3", it gave me "PgDn". It was giving me "3" before I restored the factory image.
So recap, I used to be able to hold Fn and I could type the "blue" letters printed on the keyboard.
I don't think this is Vista problem because I boot the laptop to DOS, the keyboard mapping is the same.
I think when I press Alt-F10 to run the recovery, I must have pressed some other hidden key sequence to switch the keyboard profile by accident.
i have a ACER Travelmate 2482WXMi, i have done a fresh install of windows XP home, i have done a full format of the hard drive, but i have issues the touchpad will not work only in safe mode. I have installed most of the drivers through safe mode, but the mouse will only work when i connect an external mouse when it's in normal mode.
Also i do get some bad sectors on the hard drive, and it takes over 2mins to shut down the comp. I havent installed programs yet, except PC Wizard 2008. Also the laptop is not the base model with 512MB ram i have added a 1gb stick and it works fine. I am thinking maybe its the hard drive. If
DV9000 series, when you press the power, the lights blink ad then it powers off. So i dissembled it ad removed the motherboard to have a look, the 1 year warrenty had expired.
Now it seems this is a common problem with this series and seems to always point to a bad motherboard, bad chipset or graphics on the board.
Now it will be obvious i had opened it up as i removed a cable that was taped to the board. If there is an extended warrenty for this problem am i screwed?
I have a y410p with windows 8 on it. I recently installed a debian based linux alongside windows so I can dual boot them.This required me to also add Grub to the the disk. But grub was in legacy mode and i had problems booting up win8. So, I used boot-repair to try to fix it, but it seems to have gotten worse.
View 3 Replies View RelatedI need webcam driver and digital persona finger reader driver for vostro 3550 window 7 64bit. i could not find these driver.
View 7 Replies View RelatedLook! ...
View 10 Replies View Relatedhere's the problems:
1. The damn CPU whining? I know everyone has it. Dell said last time I called that they're working on some way to fix it. The new A09 Bios didn't seem to do anything for me, or anyone else apparently according to dell's support forum. What's up with that?
2. My laptop wobbles on the top right and bottom left corners. it only wobbles if I use my 6cell batt, and it doesn't wobble w/ the 9 Cell. So does that mean the 6cell's rubber feet thing on the top right corner isn't high enough? Can dell fix that?
3. The "increase volume" media button thing isn't as responsive as the other ones. i have to press really hard to get it to respond. all the other ones i just tap it lightly, and it works.
Here's some questions that I know Dell has no clue what to do with:
4. I'm currently using Vista Ultimate on this only because I couldn't get my bluetooth driver and my sigmatel audio driver to work properly on XP. since dell hasn't released a xp bluetooth driver, i used WIDCOMM 5.1 stack, and the bluetooth headset and stereo headset drivers would disable the sigmatel drivers. really annoying. cmd51229 says he's gotten it to work:..........................
I would like to buy a wireless bluetooth mouse and I was thinking
if this mouse will work with bluetooth installed in M1530 {bluetooth 355 +EDR} and therefore I will have another USB slot free - or it will work only with its own bluetooth..
So I dropped the extra 40 something for the bluetooth capability in my 1640, thinking it would be a fantastic way to save a usb port and add convenience for an external mouse.
Problem is, I've been to several futureshops, bestbuys, and londondrugs and none of them (okay, there was ONE) have bluetooth mice...
Where would a good place to look be, a place I can actually go in and get a feel (even if only through clear plastic) of the mouse (rather than online like NCIX or Newegg).
I have win-XP installed on my DELL Inspiron 1525.
Every time I type i touch the mouse pad by mistake, the cursor jumps to a different location and it irritates..............
What is the best bluetooth mouse for the SXPS 16? I think both the Microsoft Wireless Laser Mouse 8000 and Wireless Notebook Presenter Mouse 8000 look good but don't know much about them...
View 6 Replies View RelatedI my games COD 4 and COD 5 is my mouse laggy ,why?
i change my resulutions, my foreware,
I just upgraded from 32 bit Vista to 64 bit Vista (it was free). The onboard mouse buttons and touchpad work fine in Vista 64. My problem is that I always use an external mouse. When I'm typing and my palm hits the touchpad my cursor moves. In Vista 32 bit I could set the onboard mouse buttons and trackpad to switch off in the Dell touchpad driver whenever an external mouse is plugged in. There is no 64 bit Vista driver to download from Dell. How do I turn this touchpad off?
View 10 Replies View RelatedAnybody using this Dell Bluetooth mouse with the Studio 15?
Link: http://accessories.us.dell.com/sna/p...8&sku=330-1823
The website doesn't list the Studio 15 as compatible with it. The SXPS 16 is there, but I figured bluetooth is bluetooth
A year ago (November 2007) there was a thread titled Possible to remove key from keyboard? which is now closed. I have a similar question and one of the mods may want to merge the two threads and open the combined one until the topic is thoroughly discussed.
In any case, here is my issue. My wife has an XPS that is only about four months old.
Suddenly the left mouse button is stuck partially pressed down. If this were a keyboard key I would just pop it off and clean underneath it. But, I don't know if you can remove the mouse buttons that way or not. Does anybody have any suggestion? And before someone helpfully offers returning it to Dell for warranty work - do you want to do without your computer for a month? She doesn't either, so that's a non-starter.