One of our employees has an HP Pavilion G6 laptop. He uses an external display at work but has to keep the screen of the laptop open. If he closes the screen, then the video to the external display is power off.
What are the settings to allow the laptop screen to be closed and still be able to get video to an external display.
I have one monitor connected through the HDMI interface and I would like to have another one attached as well. Can I use the VGA port (or the other flat one -- I do not know what it is called) and have the monitors work in concert?
(Windows Vista, Pavillion dv7 laptop)
The monitor on my HP Pavilion dv9830us laptop has not been working for some time and I have had to use an external CRT monitor for my display. A couple nights ago, my operating system (Ubuntu Linux 10.04) failed to load and because I can't get video feed to my external monitor until the video drivers on Ubuntu loads, I am unable to run Ubuntu's repair feature and the beginning of boot.
Is there a way I can get my laptop to use my external monitor at all times, even at the BIOS screen? Is there a setting in BIOS for this?
My screen is no longer good so im trying to connect a external display.Been trying for hours trying to get the external display to work of boot.Ive tryed everything changing 2 sets of hd cables and svga cables. The function key. The Laptop does recognize the display but seems to go into powersave mode or something.The only way i can get the external display to work is if i pull the battery and wait a bit then power up the display will work with a notice on the screen that cmos will be reset to defaults then restarts and back to where i was again.Pavilion dm4-1160us.
View 5 Replies View RelatedI am having problems connecting an external monitor, Dell 2709W, to my Elitebook 820 G1.
I have an Intel HD 4400 graphics solution. The monitor says:
Out of range signal
Cannot display this video mode
change computer display input to 1920 x 1200 @ 60Hz.
I use a Display Port cable for the connection.
My OS is Win 8.1 64bit
I have used the HP support assistant to update all hardware drivers...
I have Thinkpad Edge E330 bought this July, with win8 downgraded to win7. It recently started a problem where the laptop's own display doesn't display anything (just blank) if I don't have external display connected. The external display doesn't have be in use, just connected, and E330's own display works fine. If I disconnect the external display, the E330's own display goes blank also. It doesn't matter what display setting I have.Currently I'm not able to use my E330 as a laptop at all.
View 2 Replies View RelatedSo I've just got a e6400 for e-port plus.
Is it possible to have two external monitors AND the laptop display all running at the same time? If so how?
Even better would be this: I have two external monitors - both vga with no DVI (oh well). Can I get this working?
I have a HP Pavilion dv4t-4200 CTO Entertainment Notebook PC model # A1M02AV and it has a VGA port, one that looks like a phone/broadband cable port, and one that looks like a USB port but indented on either side at the bottom. Can I even connect an external monitor? How do I find out if I have more than 1 video card? Besides the usual USB/headphone ports, I don't have any other ports. It says my drivers are up to date...but I don't even know what I should be looking for. Do I need to install something or buy some sort of adapter?
I am trying to connect a Dell external montitor via the VGA port with a VGA cable. The monitor has power but my notebook does not recognize/detect it. However, when I first plugged it in, my notebook display shrank into a square (vs the whole screen) so it recognized something...but nothing happened on the external monitor.
I tried detecting it via my display settings, but I accidentally changed some dispaly setting so that the home desktop only shows on monitor 1, but unselected my actual notebook display or something or changed it to be monitor 2 (even though monitor 1 does not exist), so when I plug the cable in to my notebook, all of a sudden my desktop goes away and it's a just a blank background screen - and I cannot access the computer display settings or anything.... when the cable is unplugged this setting looks normal, so I can't figure out how to fix it.
I discovered that my display wasn't turning on yesterday when I tried turning on my notebook. Luckily I was able to plug it into an external monitor with a VGA cable and I have a monitor in my office, but I really cannot be restricted to my living room or office to use my laptop.
View 1 Replies View RelatedTried (and sometimes successful) to connect HDTV to laptop, Inspiron 5720. Now laptop screen does not display (goes black) without an external monitor physically attached. Tried using Projects and clicking on single laptop display, but if I disconnect the external monitor, the laptop screen just goes black. Not very portable if I have to lug around a second display.
View 1 Replies View RelatedI have a latitude E6430s running windows 7. I have it docked using a dell docking station, and have 2 dell monitors connected using dvi. With this configuration if I have the 2 monitors running I can't get any picture on the laptop screen. I wanted to be able to use all 3 screens at the same time is this even possible, how to have all 3 screen working at the same time.
View 1 Replies View RelatedToday i bought an Inspiron 5547 and i have an issue when closing and opening the lid. The issue is get screen artifacts like if were pressing the screen with my finger. Is this normal?
View 4 Replies View RelatedI have a problem with my Lenovo IdeaPad S206. Display isn't works correctly: sometimes it turns dark, especcialy when opening/closing notebook.
I think it's problem with LCD cable, but warranty period has timed out.
My laptop is HP Pavilion G6. My product number is A7Q28EA#ABV Can I see 3d movies / videos at my laptop if I take 3D Glass ?
View 5 Replies View RelatedI've purchased a HP Pavilion 15-n011tu Notebook. I'm unable to install display driver for WIndows 8 (64bit). I've tried all 3 drivers given on HP site.
1.NVIDIA Graphics Driver (2013-10-02 , Version9.18.13.1170, 318.33M)
2.AMD High-Definition (HD) Graphics Driver (2013-08-16 , Version12.105.9.0, 204.81M)
3.Intel High-Definition (HD) Graphics Driver (2013-08-16 , Version9.18.10.3224, 136.34M)
I cannot adjust the brightness of my display using the Fn keys or the Control Panel... I have already had to replace my battery once... I need to be able to adjust the brightness in order save my battery life!
View 8 Replies View RelatedI am running Win 8.1 x64 (up-to-date) on HP Pavilion 1322TX laptop. There are Intel HD Graphics 3000 and ATM Radeon HD 7450M two graphic cards as the device manager window. Recently I am getting blue screens and later message appear saying the ATM driver stopped working. I found many problems with this driver in the past as well. When I check the relevent page for my laptop model, there is no update since 2012..
Can I update these two drivers seperately by getting updates from Intel and AMD sites?
Is there any update for catalyst control system (CCC) ?
When I try to update through the CCC or HP Support Assist, it is always no updates..
I changed my operating system from WINDOWS 7 ULTIMATE 32 BIT TO WINDOWS 7 ULTIMATE 64 BIT,and the problem is after changing OS my laptop is not displaying Brightness bar. Brightness is increasing and decreasing but it is not showing bright bar.
Any driver i have to install ? if required then driver download link.
I have an HP Pavilion G6 2136tx. I would like to know whether my laptop has 3d capabilities or not.
View 2 Replies View RelatedI recently purchased an HP Pavillion X2 2in1 laptop and want to connect it to my TV. The laptop was recentluy upgraded to windows 8.1. When I connect using an HDMI cable, the TV recognises that the HDMI is connected, but the laptop screen will not transmit onto the tv screen. When I hit f4 to toggle the display, it says 'Your PC cannot project to another screen. Try reinstalling the driver or using another video card.'
When I go into control panel as recommended on other queries, the adjust resolution screen does not give me any other options than the Basic PnP display. It's like my laptop cannot detect my tv. It is not in my computer, devices or anything. I didn't attempt connecting it to my tv when it just had windows 8 on it ...
I have a laptop HP Pavilion g7. Windows 7 Home Premium 64-bit Service Pack 1Intel (R) Core (TM) i5-2450M CPU @ 2.50GHzGraphics Unit 1: AMD Radeon HD 7400M Series Graphics Unit 2:Intel (R) HD Graphics 3000All the driver has been updated weekenden-
My problem is that I do not get the picture up when I connect it to my Panasonic TV, both during display settings and sound can see my TV, but there No picture, have tried all display settings that are possible?but it works without problems on 32 "and 40" TV but not at 46 smart TV and my 50 "TV
The HP dv4-1548dx laptop computer has keys to adjust the display brightness of the LCD display but no keys to adjust the contrast. "Operating system Windows 7" How can I adjust the Contrast ?
View 2 Replies View Relatedfor some reason the on screen display meter for my volume when pressing on the keyboard suddenly disappeared, I would like to get this back. I found this thread in the forum URL.... which another was having the same problem I'm having. The only difference is that I'm using HP Pavilion G7 with Windows 7.
View 1 Replies View RelatedI noticed the display automatically adjust its brightness when I open different webpages with different color background, which I'd rather it not do. How to disable this dynamic adjustment?
Product Name:
HP Pavilion dv7 Notebook PC
Product Number:
A5F92AV
OS:
Windows 7 home premium 64 bit
So I have a HP pavilion dv6 laptop with an intergrated Intel HD 4000 Graphics card and I want to run Warframe wich requiers 256 MB of dedicated memory and I only have 64.Is there any way I can increase the Dedicated Graphics memory?
View 1 Replies View RelatedI have a pavilion dv6 6190se and I cant find an update of display driver in HP support and when i download the update from AMD site it doesn't work. the latest update on this site is v8.882 and i doesn't support win8 and it goes back to 2011-11-18. is there any way to update it?
View 7 Replies View RelatedThe brightness on my display is somewhat dim. How do you increase the brightness?
View 3 Replies View RelatedThe display of my hp pavilion 15 N 043ee laptop is extremely dim. I'm unable to see anything on the screen unless I shine a flashlight onto it, and even then I can barely see. When I connect it to an external monitor it works fine. I restarted it and hit f8 to access the bios screen and it's also dim there as well. My laptop is only a few months old ....
View 1 Replies View RelatedMy current problem is that when switching from the mobile power-saving GPU I lose the backlight on my screen when the high performance GPU kicks in. The HDMI output is displaying video when in High Performance, but the screen of the laptop will only show a picture with no backlight, and can only be seen by shining a light on the screen.
Just started happening the last few days, I've tried a system restore (didn't allow it), tried uninstalling all of the AMD drivers and software then reinstalling with their updated drivers, as well as the same process but with the HP drivers that came with the laptop, still the same result.Is it possible for the high performance GPU to be failing some how or is this a software issue?
I have an HP PAVILION G6-1241EA and I just got a new motherboard and I installed it into my laptop. My laptop turns on but the screen is white. I looked at the wire and it is fine and I tried plugging in some other monitors vga and hdmi but nothing happens. Its been a long time since I've been on the laptop.
View 1 Replies View Related