Dell Inspiron N5050 :: WiFi signal Opened Then System Will Reboot With Blue Error Screen
Apr 6, 2013
I am facing serious issue with wirless adapter in my laptop. When ever system is on idle for 15 min continuously WiFi signal opened then system will reboot with blue error screen showing hardware problem .
I have dell inspiron N5050 laptop and it is under warranty. Recently i formatted it to upgrade my system from 32 bit os to 64 bit os. After formatting, I am not able to access my desktop and a blue screen is displayed that says:
"A problem has been detected and windows has been shutdown to prevent damage to your computer.
If this is the first time you've seen this stop error screen, restart your computer.
If this screen appears again, follow these steps:
The BIOS in this system is not fully ACPI complaint, Please contact your system vender for an update BIOS.
I have an Ideapad Y510P with 24G SSD and Windows 8.1. I uninstalled the Express cache by a mistake. So I want to re-install it. Unfortunately, the install program told me that I need to reboot the system even I tried to reboot or shut down the system several time.
few days back dell inspiron's windows got crashed.
I can reinstall But at the same time i will also lose my data.
is there any way I can get the window problem fixed keeping data safe at the same time
Model - Inspiron N5110 Error: windows recovery error initially (Blue screen) but now (Black Screen) which reads:File: BootBCDStatus: 0xc000000fInfo An error occurred while attempting to read the boot configuration data
I tried to use repair option but didnt work as it said there is no system image...
Every time I start my laptop Inspiron n5110, it goes to the blue error screen where it says 'collecting data for crash dump'. It usually happens in under a minute after starting the laptop. Once the screen shows I have to force restart by pressing the power key for few seconds.
So i bought a Dell Inspiron n5050 5 months ago . The first day i got it i went to play games with my friends and stayed at least 10 hours playing.
The next day it went slower , in fact in minecraft the first day it was running on 120fps and on the next day about 70 - 60.
also , the laptop kept on getting blue screens and black screens and sometimes didnt turn on.
I still play games like League of Legends and Minecraft with friends and now the fps suddenly dropped . in minecraft 70 - 60 to 20 - 30 and in league of legends constant lag when someone uses a skill / attacks.
Whenever i go to sleep i just close my laptop , i dont shut it down and also i run at least 6 hours a day. Ive also heard that it might be the cooling fan that has dust in it, however im not sure. I want it to run smooth again . Ive reseted to factory setting twice and its still running slow.
I have an Inspiron N5050 that is 8 mos old and is rarely used. When turned on, it shows windows loading files bar, then a start up repair screen but does not go beyond that. When I exit that screen, it shuts down. I restarted it and ran the F12 diagnostic test and it showed a fail with error code 2000-0142. This should still be under warranty because I bought the computer on 8/4/12. Is there anything I can do on my side or will this need to be returned to Dell for evaluation?
I was formatting dell inspiron N5050, first we created recovery disks, I tried to do a system recovery first off the partition, after which I was recieveing a BSOD, so I used the recovery disk we created to do the system recovery again this time there was no BSOD however after it said it was setting up windows for first use, it brought me to a log in screen with no user name, asking for a user name and password. It will not accept any of my friends old user names and passwords, I am unable to log into the administrator, and I am unable to log into safe mode cause it needs to set up windows 7 for the first use. How can we log into windows?
I have recently purchased Dell Inspiron 15R 5521N laptop with Windows 8 Pro. When I try to connect my laptop to an Acer monitor with an HDMI cable, it gives me a no signal error. But when the same laptop is connected to a Philips monitor using the same cable, it works perfectly. As usual I thought that the monitor was the culprit, but when I connected another laptop to the Acer monitor using the same cable it worked without any errors. So where does the problem lie. The HDMI cable is OK, the laptop is also OK as also the Acer monitor?
My dell laptop will load the dell screen but then go black. It had windows 7 on it. So I went under and selected diagnostic test under adipto? In which I am use to seeing a Bios screen labled Bios. The diagnostic ran but and passed everything except my hard drive. It recognizes and list on the Blue screen HDD Fixed and list a number. BUT under my diagnostic ut list the following code. 2000-0151 Vadlidation 62721 Msg : Hard Drive 0- #########, incorrect status =3E.
Do I need a new hard drive or does this mean I have bad sectors?
I've had my XPS 17 for a week and have run into problems. Initially, I had no problems but two days after owning the machine, picked up the first: I opened up the laptop lid and was met by a message, the gist of which was 'Windows has recovered from a blue screen error' . I rebooted and put that message in my 'lets wait and see if that happens again' memory bank.
Things went well after that until I tried installing and using a game, which would have been the first time I'd used my GT 555M graphics card in anger. Installation went well but after starting the game, the screen started flickering, messages started appearing in the bottom right hand corner of the screen saying 'graphics has malfunctioned but recovered', or something to that effect, then the laptop crashed.
I tried updating drivers (I'm 100% sure they were compatible with my card) and this made my laptop even more unstable, throwing freeze after freeze, blue screen after blue screen and refusal to boot or shut down at me.
I decided to start from scratch and did a complete factory settings restore and upon first switch on (the laptop does it's 'setting up for first use' routine) was met with a blue screen error. The error details were as follows:
Problem signature: Problem Event Name: BlueScreen OS Version: 6.1.7601.2.1.0.768.3 Locale ID: 2057Additional information about the problem: BCCode: 116 BCP1: FFFFFA800BF95010 BCP2: FFFFF8800F438EA8 BCP3: 0000000000000000 BCP4: 0000000000000002 OS Version: 6_1_7601 Service Pack: 1_0 Product: 768_1
The laptop then rebooted itself and seemed to run just fine. I checked the device manager and it appears windows has shut down my GT 555M card as it was reporting problems.
I ran Dell diagnostics prior to the full factory restore and beside the fact it didn't pick up the GT 555M (it did test the Intel HD3000 and that was fine), it said all was fine.
I have just rerun the diagnostics after the restore and it seems the DVD drive is now having issues too:
OPU Test - not supported Spindle Test - not supported Tray Out Test - not supported
My machines details:
Model Dell System XPS L702X Operating System Microsoft Windows 7 Home Premium Edition (64-bit)
I own the Compaq presario laptop and in October it started giving me problems. I would get a blue screen with an error warning. This progressively got worse. It seems the only way I can get my computer to even power up is to lay it on it's side. Yesterday I resinstalled the restore disc. Now (still with it laying on its side) I am getting an error called Windows Boot manager. It says, "Windows failed to start, a recent hardware or software change might be the cause. To fix this problem, insert the windows installation disc and restart computer." I did a computer check on the hard drive when it was up a few days ago, and it seems to be fine. I am running windows vista.
I just recently removed vista and upgraded to Win7 32 bit. I tryed to add 4gb of RAM, due to the factory 1gb it came with. However got a Blue screen Error. After that I only installed 1 of/ 2gb stick of RAM and it worked.
My question is, I need 4gb of RAM for this c700, Should I update the Bios for Win 7. By doing so will the c700 allow me to install the 4gb of RAM and work?
My Dell Inspiro N5050 is having a few troubles. It was running absloulty fine yesterday and now when I power up, it sticks just before the logon page at just the black screen with the mouse. It even does the same if I try to start it in safe mode. I have run a BIOS which comes back clean. Have also tried the power off and hold the on button for 20 seconds but alas, the problem. I'm unable to do a system restore and cannot find the optipn for a factory restore.
I'm An Acer Aspire 6930G user and it has vista home premium installed as OS. Today When I was trying to install Windows Xp on it A blue Error Screen Appear in the beginning of windows installing...I tried with 3 different Xp cd's but still the same problem.
Here's the full form of what that blue screen says:
The problem has detected and windows has been shut down to prevent damage on your computer. If this is the first time you've seen this stop error screen, restart your computer. If this screen appears again, follow this steps:
Check for viruses in your computer. Remove any newly installed hard drives or hard drive controllers.Check your hard drives to make sure it is properly configured and terminated. run CHKDSK /F to check for hard drive corruption, and then restart your computer.
Yesterday before I went to eat lunch I turned on my laptpp and signed in. When I came back it had a blue screen with a kmode exception not handled error. After waiting an hour the getting data portion was stuck on 0 still so I forced turned it on. After that the moniter wouldn't turn on even though the laptop was on, I heard the turn on noise and could hear the fan running when I listened. I tried taking the battery out and holding the button for 30 seconds and putting it back in and after a few times it managed to turn on with the screen. But it froze at the start up logo and after another hour I turned it off and havnt been able to get the screen back on again. Is there anything else I could do?
Got an Inspiron n5050 in December 2011 and it worked fine until it decided to shut down and I manually turned it back on and it stopped at the screen showing the patents and won't progress past that, I've tried manually force starting from hard drive and also doing a diagnostics run and it reported that no problems were found.
Bought a Acer Switch 10 new with Windows 8.1....after 5-6 days has to take into Acer service in Moscow after 'No bootable hardware detected' appeared.....now 3 weeks on have a blue screen and 'BAD SYSTEM CONFIG' AND nothing else!!!!!!!!!.....