In November, Dell will roll out the full Latitude ON system, which will be built into the Latitude notebooks and also offered as a low-cost mini-PCI upgrade to models issued with the reader.
What does a mini-PCI upgrade entail? Is that hardware or a downloadable software upgrade?
I get an error, just says Error 15 when I try to boot using Latitude ON. Anyone else have this problem?
View 3 Replies View RelatedThis has been brought up before in this forum, but it was as an off-topic discussion on a thread with a different topic. I'd like to bring it to full discussion.
Basically, I'm quite happy with my E6400 but I don't use the fingerprint reader, because that involves using the Embassy Trust Suite.
This means that you cannot use the fingerprint reader for any other uses except logging on at boot and windows logon screen. You cannot use it for your web browser, for example.
Several people have asked Dell to invest in an open API for the fingerprint reader because of this. Dell suggested we opened a thread in their community feedback site, "Dell IdeaStorm", which I did. Here's the link.
I got my Latitude E6500 a few days ago, I'm happy with it (except the lagging ALPS touchpad) but I have a problem with the fingerprint reader (Broadcom USH w/Swipe sensor).
The fingerprint reader is connected and does respond, but the ControlPoint software throws an error if I try to enroll my fingerprint (the error doesn't show up if I don't touch the sensor). If I reboot, the "Broadcom USH w/swipe sensor" is replaced by "Broadcom USH w/o swipe sensor" in the device manager. The swipe sensor is detected again after a complete shutdown.
I've enrolled my fingerprints via the Windows 8.1 PC user settings app.
When I logon to my PC it provides the usual password box to type my password, but if I swipe the fingerprint reader nothing happens. I've registered four fingers, none of them work.
Are there some other settings I need to change to enable use of the fingerprint reader?
I see the biometric device in device manager, and registering fingerprints is no problem, it's just during logon that it's not working.
speed of the Dell Latitude E4300 Card Reader? I mean the transfer rate of the SD Card Reader.
View 3 Replies View RelatedNeed a Windows 7 driver (x32) for the SD reader on a Latitude E5420. Searched and searched everywhere, but can't find it.
View 7 Replies View RelatedWhere the software and data for the Dell Latitude E4300 ON-Reader is located?
Is it at the normal hard disk drive located just in a special partition there? Or is there another drive especially for it like a small flash media device or something like that?
All of a sudden the SD Card Reader on E5430 laptop doesn't work When I insert SD card nothing happens. Before, a window would pop up, or I could see the SD card in my computer.
No nothing happens and it doesn't show up under my computer.
Also, under device manager -> storage controllers, not there any more.
I believe it's a O2 Micro OZ600xxx card reader. I tried installing driver, but still doesn't see SD Card when inserted.
If the SD Card reader is just dead? Or do I have a driver issue. Windows 7 Professional 64bit
What causes this message when I boot my Latitude E6510 laptop?
ERROR "The reader is not installed on this machine. To install reader, press any key to restart your computer and run the reader installer. If the reader is installed on this pc, please check if the reader is installed on an encrypted hard drive.....Press any button to continue"....
I have a Latitude E6410 that I'm having problems with. On boot up it goes to a black screen with this error message: ERROR "The reader is not installed on this machine. To install reader, press any key to restart your computer and run the reader installer. If the reader is installed on this pc, please check if the reader is installed on an encrypted hard drive.....Press any button to continue".
View 4 Replies View RelatedI have Dell Latitude E6420 with Windows 7 OS installed.
The driver for Biometric device is also installed. But windows is not finding any biometric device as shown in the following picture message.
I recently converted from a Lenovo X220 to a the Dell Latitude XT3. The XT3 is a better laptop minus a couple design choices. That said, there is one feature in particular that I will miss the most....My old X220 fingerprint reader allowed me to swipe with the latop powered down. This action would boot up the PC and log me in. This doesn't seem to work the same on the XT3. Instead, I must power it up then swipe in two separate steps.
Is there a way to get the XT3 to respond to a finger swipe while it is powered down?
I just bought a Dell E6400 and it has a fingerprint reader! However, the Dell ControlPoint isn't installed. Any link to whatever I need?
It's windows 7 pro, 64 bit
I performed a windows 7 clean install on my vaio (VPCEB11FX).
After that i installed the drivers properly.In Device manager i am able to see the MMC card reader and SD reader with respective path letters.
But in when i open my computer only dvd drive showing there
The price of 2nd user Latitude D630's seems to be holding up quite well in the UK. Does this indicate that it is still a popular machine and favoured over the E6400?
I briefly checked out an E6400 the other day and for a choice between machines of approximately similar spec I would opt for the D630 rather than the newer E6400.
I would be interested in opinions from users who have experience with both models.
We are looking at getting some Latitude E4310 systems. Since fast boot up to access the web is important, we see that the Latitude On FLASH option is required.
The downside is that Dell will not install this along with the WiMax card option. They have a combo WiFi and WiMax card, but it can not be installed with the FLASH option.
They also list Latitude On ECM as an option instead of On FLASH. The ECM runs $149 more. With ECM, the system can then have the WiMax card which would be nice.
The people at Dell have not been able to provide a good explanation on what the ECM option does. There is a write up on the FLASH option, but not a good one on ECM. Does anyone know what the ECM does differently than the FLASH?
Key points of the FLASH option are (we need these functions):
Boot Fast, 8-10 seconds
Wi-Fi and LAN 10/100/1000
Web access via browser Firefox Browser
Supports Java and Adobe Flash
Read Microsoft Office
Edit Microsoft Office 2000
I've got a choice at the moment between two latitudes:
1) Dell Latitude D630: 2.2ghz C2D, 3Gb RAM, 120gb HDD, dvd/cdrw drive, vista, nvidia Quaddro GFX
2) Dell Latitude E6500: 2.26ghz C2D, 3Gb RAM, 80gb HDD, DVDRW, Vista,
Which do you reckon i ought to go for between the two?
The laptop will be used primarily between home and university, so will be taken between the two places in my shoulder messenger bag, so will probably take a few bumps
why when i insert a new SD card that my Dell Inspiron 1501 freezes and i have to restart, the computer is actually my parents and i was cleaning up the computer for them. When i insert the card into the side of the computer it locks up and i reboot i can't find anything on the net.
View 10 Replies View RelatedI am wondering whether or not the E6400 has the Latitude-On feature or can be configured as such.
View 10 Replies View RelatedDoes it still bog down the system and take forever to use?
If it worth installing, I need to install both Dell Security Manager and the driver?
I've been trying to find some software to make use of the smartcard reader in my M4400.
I've searched a lot on Google but I can't find any applications, only drivers. Is there any software that would let me view the data from the chip on my debit cards, credit cards and other smartcards?
I don't want to do anything productive with it, but just to see what it's capable of and what data is stored on the cards.
http://support.microsoft.com/kb/949126
View 4 Replies View RelatedI highly recommend the standalone desktop version by Upek.
The cheapest I could find was buy.com ($41.08 with 5% off coupon available everywhere).
[url]
Mine came with the 5.8.2 version of their software, but the build date of the one posted in the "Upek" thread was a bit higher, so I used that one... ((not so) New Upek Fingerprint Reader Driver)
The reader operates exactly the same way as the one in the laptop (duh? same brand and same software).
If you have encrypted files from your laptop, you can open them on your desktop and vice versa...
i have been trying to figure this out for a week with no luck and even no luck through dell.
I have a new latitude e6400, i originally set my fingerprint, then decided to clean install vista 64 bit, after tons of problems, i then abandoned the effort. Went back to the original vista business 32 bit, however, everytime i turn on my computer, during pre-boot it asks me to scan my finger to get access to my computer, i just want to disable it, but it will not let me, i went into security setting in dell control point, and in that funky embassy software, i cannot find a way to disable the finger print reader, i dont want to uninstall just disable, any insights?
Anyone else having problems with the SD card reader?
Everytime i plug in an SD card the system Blue Screen's on me. This is running XP. So far iv'e tried these 2 versions of drivers..
v3.54.05
and
v3.51.01
one thing, During trying different drivers I once plugged in my SD card while no drivers were installed, the system still BlueScreened on me.
The first thing I did when getting the system was wipe-off Vista. I dont know if this Ricoh card reader works or not in Vista, but im starting to wonder if I have some sort of hardware problem.
I just received my E6400 from Dell today and setup the fingerprint reader. I noticed it only works when I boot up the notebook and then I scan to get to the windows login screen.
I was wondering If I can set it up so that I scan to login to windows rather than typing in a password. I was also wondering If I could configure it to login to websites for things such as email since I know you can do that with Windows Fingerprint Reader.
I recently saw that my M1710 has an card reader...
Can I use it for reading mijn debit/creadit cards for online banking,... or not?
I got an E4300 through work and set up the fingerprint reader at the request of my IT department, but I hate this stupid thing. It never works and I always have to manually override it.
I asked them to take it off, but it's "firm policy" for our laptops to have the reader turned on.
Anyone know how to turn it off? It's controlled through Dell ControlPoint and maybe a proprietary program we have.
I put in my SDHC card from my camera and it does not read or see the card.
I have Vista Premium 32bit.
Is there are weird firmware I have to get?
