I have Thinkpad Edge E330 bought this July, with win8 downgraded to win7. It recently started a problem where the laptop's own display doesn't display anything (just blank) if I don't have external display connected. The external display doesn't have be in use, just connected, and E330's own display works fine. If I disconnect the external display, the E330's own display goes blank also. It doesn't matter what display setting I have.Currently I'm not able to use my E330 as a laptop at all.
ThinkPad Edge, Win 7 Sp1. For the last month I have had a problem with the control key always down. Programs react as if the control key were pressed. MS Word 7 gives an error message that the control key is down and asks if I want to go to Safe Mode. I have had the keyboard replaced with no change. The computer has been thoroughly checked, all drivers, patches, software upgrades have been made by my Tech, and the Bios has been flashed.
Last week, I found a post on Google for Win XP where the poster had the same problems. The fix was to ensure that the Sticky Keys were turned off in Ease of Access on the Control Panel. I went to Ease of Access and turned off all of the selections, and the fix seemed to work. However, yesterday the problem reoccurred. I don't know if it is a problem with the motherboard, hardware, or with Windows. It appears that this problem affects more than one version of Windows.
I am experiencing issues with my touchpad on my Thinkpad Edge AMD with 4 GB Ram.
Sometimes the touchpad will work and sometimes it will not respond. When I restart the computer, it will work but not for long. I have the up-to-date drivers which came with the machine. I just received my machine 2 days ago.
I just purchased the E540. Running Win 7.1. I have 2 WD 3.0 Passport drives plugged into a USB 3.0 hub. The 3.0 hub has the correct cable for 3.0. They are not being recognized as 3.0 devices (I get a message). I updated the USB 3.0 driver on lenovo's site and BIOS is set to auto.recognize. I have also tried the 3.0 option in the BIOS but that didn't do anything. I also tried using the drives without the hub in one of the 3.0 USB slots but that didn't do anything either.
I have checked the forum but what I found was possibly purchasing a 3.0 cable (not necessary - my cable is 3.0 compliant) but that was for a Wn 8 system or updating 3.0 device driver (done). So much for plug and play.
This laptop shows "no operating system found" when I power up. I ran knoppix which works but I tried pressing F8 to get to the CMD prompt but it doesn't work, I can get into the BIOS, anything I can do in the bios to do either a system restore or run the recovery?
I just reinstalled windows 7 on my edge 13 (cause the system really slowed down), everything's working so far, expect the WLan Device. The network adapter (realtek RTL8168D/Familie-PCI-E-Gigabit-Ethernet-NIC) is properly detected, if i plug in a Lan cable I have got a connection.
I already tried this Lenovo Update tool, it installed some drivers and updates, but still no change. I already tried all Wifi drivers from lenovo homepage without success. Hitting the F9 Button didn't change a thing.
Just a got a brand new Thinkpad 540-E. So far this CPU runs like a beast(with a new SSD installed). I have one minor issue though...
GOAL:: Make the F1-F12 keys function without having to press Fn first.
So I've tried the three tips I've come across online. Here is what happens:
1. BIOS(ThinkpadSetup): I only get the option to switch the Fn and Ctrl key. There are no option in my BIOS to do anything else with the keyboard/mouse settings.
2. Holding down the Fn key for 30 sec to 1 minute: Nothing happens. I even tried to do a three minute press and hold. I had a blast, but nothing came out of that neither.
3. Entering the keyboard settings in Win 7 manually: So I have no trouble entering the keyboard settings window, but mine looks extremely limited. In fact I see no options to do anything in there besides updating the driver.
I am planning to upgrade my RAM on my E420(1141CTO). It already has a 4 Gb on one slot. Couple of questions here.
1. What is the max RAM I can go upto on this E420 (Intel i3 2nd Gen) laptop. 2. As I have 4 GB on one slot can I put one 8Gb RAM (single module) on the other slot. 3. What brand of RAM I can use. 4. On this model can I fix another RAM myself easily or asking it the other way are the slots placed such that I can do it easily by merely oepning a couple of screws or do I have to tear everything apart. 5. Any other special considerations like about clock speed ?
With this laptop, the CPU usage rises significantly whenever the battery is charging. If I'm on running on battery power or it's fully charged, I don't have this problem. The CPU stays at 2-3% while browsing the internet, for example. But browsing the internet while the battery is charging will send the CPU up to 90-100%. It's not just browsing the internet, but any task, such as running Sony Vegas, using Skype, watching a movie, etc.
Again, this only happens while the battery is charging. Everything runs much, much slower. All power management settings are identical whether it be running on battery or charging with the AC adapter, so it's not that. I am also using the 65w power adapter that was supplied with the computer, and the adapter becomes very hot to the touch while charging.
I have recently purchased a Lenovo ThinkPad Edge E540, with Windows 7 installed. I'm trying to use the integrated camera with Skype, but I can record no picture. When I try to install the Integrated Camera Driver from Lenovo Support, [UR], the setup always fails with Engrish error messages.
I purchased a Edge E545 that came pre loaded with Win7 Pro 64. I created the Recovery disks for Win7 and used the Win 8 Disks to upgrade the OS. I have created a new NTFS partition on my hard drive and would like to install Win 7 to that partition. I have tried to load the recovery disks to install into that partition but I have not been successful; the boot disk won't even load. I downloaded the Win7 Pro 64 ISO to try and load it into that partition but the computer does not have the COA sticker under the battery like it's supposed to.
I have recovery disks that won't load at restart or cold boot and I have a perfectly good ISO that i don't have a COA to.
I just got a brand new Edge 335 with Windows 8 Pro 64 bit installed. It has 8 GB RAM, and AMD E2-2000 APU. I've had a couple of issues with this. One was that I couldn't turn on Bluetooth in Windows 8 (fixed by installing an older version of Thinkpad Hotkey features software). The other issue which is still unresolved is that of virtualization.
AMD virtualization is enabled in the BIOS. However, Windows 8 as well as the AMD virtualization tool both state it is turned off. I have, after searching these forums and the web, disabled it, cold booted the machine (removing battery), re-enabled it, cold booted again (also removed the battery). However, Windows just doesn't want to accept that it's enabled.
AMD virtualization and DEP were both enabled when I got the laptop from Lenovo. Is there anything else I need to turn on/ off?
I have bought my new E540 some days ago. My keyboard is Norwegian so there is a key called AltGr available which is used as a combinational key similar to shift. when I just press the key related to backslash ( it's '+') it works fine but when I want to type backslash (it's AltGr and '+' together) it does not work.
I have a ThinkPad Edge 15. It had a charging problem from the day I purchased it. The people I bought it from sent it back to IBM/Lenovo who apparently tightened the area where the charging cord goes into the PC?
That did NOT fix the issue, so when I got my laptop back, I called LEnovo, they sent me a new battery (even though I told them the 'Power Manager' said the battery was in good condition) which did nothing. Then they sent me a new charging cord, again-nada. They sent me a box to send the laptop back to them. As I was figuring out how to put the laptop in the box, I looked over @ my PC, and lo and behold; the light that tells you if it is charging was shining!
Last night. I looked @ the charging icon; '15%, not charging'! Oops! Oh dear, not again! Went to power manager, everything is just fine. Checked all of my connections, same thing. I left the laptop plugged in. This morning as I look over @ the laptop & Guess WHAT! It was charging, the light was on! I turned it on...
I'm encountering having just purchased my laptop. None are dealbreakers and I'm not that put off by them but the fact that I'm not able to figure out a solution bothers me. Primarily, no matter what power setting I'm on or settings I change the display will turn off after 1 minute. Ther other power settings still come into play when they should (computer sleeps etc.) but I'm not able to delay the screen turning off.
I've got a brandnew Thinkpad E530 with Windows 8 and integrated Camera. But the Camera is not wotking. When I start the Camera-App, the green Light of the Camera starts to shine, but there is no preview. Theres is only a picture of a crossed camera. Also if i start skype, my skype-partner can't see me.
I already had a look in the BIOS if the Camera is enabled (it is) and reinstalled the driver of the camera.
My laptop freezes for a couple of seconds randomly from time to time. The problem sounds like this one: [URL] .....But CC cleaner did not solve the issue.
The problem happens with almost every program such as microsoft word e.g. if I type and it freezes, the words will come out after it unfreeze.
Before the freeze, the laptop usually becomes very quiet then a few seconds later something spins and freezes the computer. I can assume that it is the HDD. However, the computer does not freeze every time the hard disk spins loudly.
When the disk spins loudly, the HDD activity spikes in task manager and the 'system' is the program that corresponds to the spike which is 'ntoskrnl'. However, the data transfer is no more that 0.1 MB/s during the spike.
I tried running in safe mode and I'm not very sure if it worked. The disk spins loudly much less often but the freeze did not seem to happen. Safe mode either tells me that it is a program/connecting to the internet/(maybe the system) that makes this freeze.
I tried a hard disk scan using lenovo solution centre and it found no problems. Also tried antivirus scan using windows defender and found nothing after a full scan.
Finally specifications: OS: Windows 8 HDD: 1TB (upgraded from 750GB) RAM: 8GB (upgraded from 4GB) intel Core i5 3210M @2.5GHz 2.5GHz Bios: v2.52
I got a really annoying problem with my E330. It came without an OS, so I put Win 8 on the preinstalled HDD. Then I switched it out for a SSD and put Win 7 on it. (everything in UEFI mode)
Since then I can't get into the BIOS/UEFI anymore by either pressing Enter or F1. Pressing Enter still gives me a beep, but then Windows continues to load normally instead of showing several options like it used to do.
And yes I'm aware that I need a cold-boot in Win 8 to get into UEFI ... The only way to access UEFI at the moment is through the Win 8 charms-bar restart into UEFI trick.
I tried already to reflash the BIOS which doesnt work obviously since it's the same version, tried removing the CMOS battery, that gave me a one time opportunity to get into the UEFI with F1 when it complained about the date/time.
Switching to Legacy only leads me to an infinite PXE - something error loop, but I still cant get into the BIOS.
I tried pressing every combination of Fn+F-Keys and without Fn. Nothing works. I don't want to return the notebook, but it's a deal breaker for me if I can't get Win 7 running on it with accessible UEFI.