I'm looking for a Lenovo B575 bios update/flash utility since my BIOS has gone bad. I cannot change/save changes and cannot restore to defaults.
I cannot find bios updtae on lenovo site (not on drivers for B575 and not under the drivers matrix). I've even tried via "Phoenix" as it's their Bios, no good. And even via a third side component (biosagent plus) that should have Phoenix bios, still no good.
I have enabled Virtualization through BIOS after updating it to v3 still the intel utility doesnt show virtualization is enabled:
Steps I have taken:
1.Disabled Virtualization in BIOS Result: Speccy and hwinfo64, 3rd party utilities show VT-x is available but disabled 2.Enabled Virtualization in BIOS Result: Speccy and hwinfo64, 3rd Party utilities show VT-x is not available 3. Repeated above steps after updating BIOS Result: Same problems
Lenovo Y510P Intel 4th Gen Haswell i7 4700MQ Windows 8.1 Pro
I recently bought a lenovo Y510P and did a clean windows 7 64-bit installation. Yesterday I reset my BIOS Setting to the default settings and now it doesnt reconise any of my hard drives or usbs anymore. The only thing I can boot from are (I think) the network cards?..
I got a X230 with 4GB 1Rx8 PC3-12800S-11-12-B4 memory installed. I tried to upgrade it with two Kingston KVR1066D3S7/4G 1.5V memory sticks.
Unfortunately after installing new memory sticks (combinations don't matter) my laptop doesn't power on. After pressing the button there's just a flash and BIOS doesn't boot.
Everything is back to normal after restoring the previous RAM configuration.
Is there something wrong with my memory sticks or is it some kind of bior issue or maybe something else?
Lenovo IdeaPad U310 with i5-3317U CPU and Bios ver 65CN89WW (09/04/2012)
I downloaded BIOS Update file (65cn21ww.exe) from ([URL]...), but after start I got a message "ERROR 233 - Only secured capsule is allowed on a SecureFlash system! Status = 1."
What am I doing wrong? How to install the update BIOS?
My lenovo Y510P used to always be at 100% but I have realized it has been decreasing by 1 every day. I have it on Maximum Battery Life with the Energy Management application.
It is currently at 85% and I would have posted this sooner if I had payed attention. I changed it to Optimized Battery Health and it is now dropping, currently at 75%.
I always leave the laptop plugged in because I usually play games on it such as battlefield, dayZ, counter strike, etc.
I've been playing Battlefield 3 for some time on Auto settings (most of them are Ultra) and my FPS were always in the range 65-85. Yesterday morning everything was fine, however at night when I opened the game again I had 10-15 FPS. I haven't changed anything in my laptop settings so I don't know why this is happening.
P.S: I only have 1 GPU (not the SLI version) so I know it's not a loss of power. But my battery settings are set to "Optimized battery health". Does it affect performance ?
I've got Y510p with USB 2.0 not working. By the time it malfunctioned it was under warranty and I sent it in the service center. They have claimed that it has been repaired (USB board has been changed) but it is still not working and my warranty ended like 3 days after I sent it back. Since then (1 month ago) I am returning it to the service center for 3 times (last one was today) and I feel they can't fix it. URL....
I bought Lenovo Y510P . and because of just hyper-v feature on win 8.1 pro also i need to upgrade windows. I found product key with a software and after that i open the "add feature to windows 8.1" . And when I choose "i already have product key" and put the product key , it does not accept . and says "this key won't work" .
So what i should do for getting windows 8.1 pro pack ? and why product key does not work ?
When I recieved my Y510p about 8 months ago, the usb ports worked perfectly fine. Around October they stopped working properly. The only solution which I found to work was doing a system restore. When I did this, an Unrecognized Device in the Device Manager was no longer unrecognized, and was instead replaced by USB xHCL (or something along those lines). However, as soon as i restared my computer again, the ports broke, and the unrecognized device reappeared. Repeating the restore followed by a restart breaks the ports every time.
My Y510p has been freezing on startup, every startup. It can be completely inoperable for upwards of half an hour before unfreezing. It unfortunately has been occuring since the computer arrived (21 March, this year), so I doubt it has been caused by any software I've added. Given my limited knowledge of computers.
Lenovo Y510p Model 20217 Windows 8(64 bit), Intel Core i7-4700MQ CPU (2.40 GHz), NVIDIA GeForce GT750M, 8GB RAM
I have a new y510p I just received this week. First thing I did was replace the 1TB HD with my own OCZ Vertex 4 256GB SSD Drive.When I power on the laptop for the first time, it does not find a bootable device (goes through network devices, then says no bootable devices). If I use ctrl-alt-delete to reboot the laptop, it then finds the drive on its own and starts booting into Windows.
I'd like to understand why this does not work on the first boot? I went into the BIOS and saw it says there that no drives are detected.This worries me slightly, as perhaps one day it will decide to no longer recognize the drive after the ctrl-alt-delete?
On my Y510p I am getting low memory warnings wether im playing a game or just idling or on youtbe. When I open up the task manager its says my memory is at 70%-100% WHILE IDLE but the programs are only using like 25%-40% memory so something is hidden. Just looking for a fix or allocating more memory to Windows. I have an 8Gb system.
Here is a screenshot of the task manager while I right this [URL] ....
How do i turn SLI mode on my dual graphics GT750M on the Y510p laptop. GPU-Z says SLI is disabled. Can't seem to find a place to turn it on Nvidia control panel either. Device Manager does show 2 GT750m working right.
I bought this laptop recently. It comes with a single graphics card. I heard this model has ultrabay and you can add another graphics card. My question is is it true that you can add a second graphics card in this system with ultrabay? I am confused if SLI and ultrabay refers to the same thing. If that is the case then this system is non sli.
After 60 seconds of inactivity, a video showing the new features of the lenovo y-series pops up. the only time it doesn't do this is when I'm in a youtube video or a game. I've changed the sleep setting to 15 minutes, but nothing has changed yet... I am on windows 8.1, have the 755M SLI, and the i7 4700-MQ.
I've just noticed that in my Y510P with SLI the CPU Clock drop to 2,4 Ghz when I play games or render some graphic, and go up to 3,2 Ghz when PC is at rest.
Just got the y510p laptop and am trying to install Ubuntu so I have this bootable DVD and I wanted to try Ubuntu before installing as usual but I can't get the laptop to bot on dvd. On boot menu options there is only EFI and some kind of network options but no dvd. I tried following instructions here but no matter how many times I press F1 during startup, I can't get to boot menu and windows starts directly: [URL] Is it not possible to boot on dvd. The dvd is ubuntu 13.10 supposedly compatible with EFI and secure boot. I don't understand why there is no option to reorder boot devices like on all my older PCs.
I manage to get BIOS setup pressing restart and shift and then selecting UEFI firware settings and I do get to bios setups but again no way to find the option for booting on a dvd.
Recently bought a Y510p laptop and of course I wanted to have an SSD as the boot drive.
I downloaded a cloning software and cloned the Windows OS partition as I had intended to keep all of Lenovo's original partitions intact on the original hard disk.
I put the original HDD in a caddy and replaced the DVD Drive and put the SSD where the original HDD was.
I tried changing boot order in the Bios but no matter what it only reverts to boot from the original HDD.
I'm not sure what I have to do to make it boot from the SSD, clone all the partitions from the HDD? I don't have any Windows 8 disks or anything so I just want to clone the original hard drive as it came installed in the laptop.
my y510p is 5 months old, it's the non - SLI version, installed Win 8.1., warranty still valid. Today I worked on my notebook as usual, listened to some music and it suddenly turned off. It was connected all the time to the charger.
I tried to turn it on several times, everything seemed fine, the keyboard lights up and the LCD shows the normal Lenovo startup screen, but after 3-5 seconds notebook turns off. The OKR works the same way - the menu is shown for a while and after about 3 seconds my notebook turns off. No BSOD, no any other supporting symptoms. Tried to enter BIOS, it worked out, but the computer still turns off after few secs in BIOS.
I thought the reason might be too high temperature, but the notebook was almost always slightly warm, never hot and the cooling fan was running pretty quiet. My computer never fell off or was hit or anything.
I heard computers run a self-test before start. Is it possible that some component of the notebook can't pass the test?