Dell Support said this feature is not supported by them however its there feature (What) anyways can some one tell me that has it working on a XPS 1640 how it is set in the BIOS and what else I need to try to get it to work.....
View 10 RepliesWhat is this exactly? I'm planning on buying an external enclosure for my spare 3,5" SATA HDD, and I'd like to get one that uses the eSata interface.
Now I heard these need seperate power supplies sometimes..
Here's my story and, let's say, my analysis:
I bought a generic 2 HD sata2 RAID1 enclosure based on the chipset Silicon Image SteelVine 5744. It can be used in USB or eSATA2. This embedded chipset (named SiL5744) is known (understand "claimed") to auto-handle Sata I/II and host sata2 controllers that not support the port multiplier feature. The HD are two Samsung F1 1To. There's no jumper to rollback to SATA 1.5Go on them, you can only do it by flashing the HD's bios, however we don't need to do it as I wrote just before, the SiL5744 supports SATA 3Go natively.
The enclosure works pretty well with USB, but *not* in eSATA : the E6500 freezes/hangs just after the POST step (a potential driver issue with the installed vista 64bits is not the reason then). As soon has I disconnect the eSATA cable, the system recovers and continues as normal.
What I've tried/done so far :
Both E6500's BIOS SATA mode AHCI and IRRT mode were tested,
Intel Matrix driver and software was updated to the latest 8.7.0.1007 version (AHCI and IRRT),
The SiL5744 chip was upgraded to its latest firmware as well (in case of...)
In order to verify the esata cable, the HDs and the enclosure itself, I succeed to :
- Use the enclosure's RAID1 feature when using the USB connection, I could partition,format, and read/write on the logical volume
- directly connect *one* HD (Samsung F1 1To) to the E6500's esata port -(I have a sata2esata cable), Vista installed it and I was able to use it as normal, even the hotswap feature seemed to work fine (I unkindly removed it). I could so test both HD individually this way... On the enclosure hardware side, everything looks fine then.
An IMPORTANT thing : The E6500's ICH8/9-M sata host controller seems to support the Port Multiplier feature *ONLY* on sata port 0 -as a bubble message from the Intel Matrix soft sometimes shows up-, but this is exactly where the internal HD is plugged on the motherboard I found nowhere you can change the internal sata port ID (switch,bios,ect...). I think this is the key of the problem that seems to be a dumb port conflict, because the esata port is in fact the port sata 4 (the DVDRW drive is sata 1, dock's esata is 5 for instance). If somebody knows how to swap the sata port ID, I think I won't be toasted !
Has anyone successfully charged an iPod (Touch, specifically) via the Powershare USB port, while the laptop was turned off. When I plugged my iPod Touch, it powers on but doesn't charge.
The manual that comes with the SXPS says some devices won't charge and some will.
I have an XPS 14 Ultrabook. I did a clean install of Win 7 Pro (from windows 8). The USB port (one with powershare) closest to front of keyboard is not working, the other USB port is working.
Did I miss a driver? If so, which one. Unfortunately, I was working on the driver install at 3am and didnt take as good of notes as would have desired. I dont see any problems when i open device manager????
In particular pay attention to the port on the bottom. This is an "eSATA" port, correct? Now for the crazy question of mine: Is this eSATA port compatible with a male usb connector? I'm pretty sure it isn't, but would like to confirm before I try and destroy something
View 10 Replies View RelatedI pugged a drive into mine for the first time last night (after I figured out that you have to plug in both the eSata and the USB cable for power.)
View 7 Replies View RelatedHas anyone successfully used the esata port on their 1557.
I have an esata/usb backup external drive and can not get the esata port to work.
USB 2.0 is slow for a back up drive and moving data.
My Studio 17 has a dedicated eSata port which moves data at 3.0GB/sec. Now I would like an SSD drive, with an eSata enclosure. So I can rapidly hookup, back up and go.
Any ideas of what I need or how to go about this.?
I have recieved an external hard drive in the post today along with a cable to connect.
I connected the cable, turned hard drive on and nothing is happening. The hard drive connects via usb fine but that will be much slower to backup 500GB worth of data. Does anyone know if I need to do anything special to get it to work with esata or should it work straight away?
Not sure if the cable is esata 1 or 2 but it should work with either shouldnt it?
Acer 6930G's USB/eSATA Port.
Is this port actually able to be used as a USB without any problems(such as for a USB mouse)? Now for the stupid part of the question, once its used for a USB device will I have any trouble using it for an eSATA device later on? Basically wanted to make sure using it as one doesn't lock it into being one specific type of port permanently.
I used to use my eSATA port every day with a few different devices. I started to have an overheating problem, so Dell replaced the motherboard and graphics card yesterday.
Of course, that means I lost all my BIOS settings. I'm pretty sure I have them back to where they should be (RAID mode on the SATA controller, eSATA port enabled), yet the eSATA port doesn't see a damned thing connected to it.
Every other piece of hardware is exactly the same as it was before. Any ideas as to what I might be missing?
I've had my eye on the Sony Vaio VPCZ11 however, I would like to add an external hard drive for data storage, is the USB port the only way of hooking up an external hard drive? How come a high end notebook like this doesn't have a eSATA port?
View 10 Replies View RelatedDV 2400 owner here with P/N: GD712AV.
It comes with nVidia 7200 Go video card. Theoritically, nVidia video card could come with HDMI, but not always the case. So..how do I know if mine has one? I am actually looking for eSata port since I want to purchase an external HD for backup purpose.
I have an SXPS 1340 running Windows 7 Ultimate. I have tried to connect a Western Digital My Book Home external HD through the esata port but i can't get the computer to recognise it. Has anyone else successfully connected this model HD to the 1340 through esata? To those of you who have successfully connected a different external HD through the esata port what brand and model of external HD are you using?
View 10 Replies View RelatedI have a dell vostro 3350. On windows 7 the sd card and usb 2/esata port work as expected.
On windows 8 they dont. If i install the latest drivers, they work until i reboot the laptop after which they are back to not working.
Is this laptop just not Win8 compatible?
I received my E6410 a few days ago and was quite dismayed to find out that I cannot charge peripherals on the powered USB port when the latop is off/hybernated/stand-by *and* the power cable is plugged in. The specs say that the latop has a powered USB port (the one above the e-sata port), and I had assumed that powered USB was the same as always-on. Is that not the case?
I checked a colleagues E6400 today and noticed that the same USB port has a lightning symbol, but that symbol is not on the E6410. The E6400 BIOS also has a setting for "USB PowerShare" which selects whether or not USB charging can be done when the computer is off or hybernated. No such setting in the E6410 BIOS..... Did Dell remove that feature in the E6410?
According to the manual, this model is suppose to have USB Powershare abilities, however, I cannot for the life of me get it to work for charging my LG G2 phone. My previous laptop (not a Dell) was able to do this without any issues. Powershare is enabled in the BIOS, I am using the USB port with the power symbol, but when the laptop is put to sleep or powered off, there is no power to the USB port. I have tried unplugging my phone after the laptop is put to sleep, and plugging it back in, but that doesn't work either. I have also checked and disabled USB suspend modes in the power management tabs of all USB hubs and the Human interface devices. I also tried repairing/reinstalling the chipset drivers after the latest BIOS update (A03).
View 2 Replies View Relatedwhat COM port my serial port is on my XPS M1710. Is there a program that I can find all this out in Windows that I just never knew about?
View 12 Replies View RelatedThinking about getting one to go with my m4500 which is on order. Reviews seem ok though some complain it's bulky and other complained the release mechanism wasn't great. Worst was that someone said their comp wouldn't boot when docked.
Can anyone share experience and/or high res pics of what one looks like?
Can the eSATA port be used with regular USB devices? Seems as it doesn't fit correctly.
View 5 Replies View RelatedI'm getting about 15-20MB/s (transfer speed) transfering files from my Lacie d2 Quadra(eSATA 3 Gbits port) to my M4400 with Vista 32Bit thought eSATA port.
eSATA port has 3 Gbit/s bandwidth, so I wouldn't get about 300-375 MB/s transfering data?
i can't get my xps 435 mt (running vista 64 home premium) to recognise my new seagate back armour 2tb drive via eSATA. The drive works fine with USB connection, but is not recognised via eSATA. In BIOS the drive doesn't appear in the list of drives under eSATA either.
I searched and found a similar post but it was someone with RAID setup and the solution there doesn't work for me. Checking for relevant 435mt updates on the dell site - I can't update intel matrix storage manager r205899, as you need to be set as RAID in the BIOS for it to work. When I install r205900, it installs some files, but nothing happens.
I have looked for driver or firmware updates for my eSATA drive on the seagate site - nothing there either. Can't think of what else to try... Dell support will charge to help me since I'm out of warranty (even though it's highly likely to be an issue with the eSATA since I got my system).
I have a Rosewill ext. enclosure and I cannot get the laptop to recognize the drive unless I reboot the laptop with the drive on.
However I am able to simply plug this drive into my desktop and turn on with no problem recognizing it.
I'm just wondering, does the XPS16 support swappable eSata?
I have recently been debating whether or not to buy this eSata express card for the external HD I'm buying for my m1530:
http://www.tigerdirect.ca/applicatio...D&body=QA#tabs
I was all set until I read about people having problems fitting the cards properly into their m1530s, so now I'm debating whether or not to buy one
Is it possible to connect more than one eSATA device to the external eSATA port?
<wishes that Dell had a user guide for their flagship product>
I just realized that the port on the right side of this laptop that I typically use as USB also doubles as an ESATA port. I have a 1TB external that supports eSATA but didn't come with a cable *sigh*.
Can a normal 5400 RPM 2.5" laptop HDD even reach speeds that make it worthwhile to use eSATA instead of USB? Or am I just better off using the drive over USB and living with the slow speeds?
Is this reasonable? Please see HDTune screenshot.
View 4 Replies View RelatedIt is possible to make new eSata enter in XPS 1530?
View 10 Replies View RelatedI have a Dell M6400 running Windows 7 64-bit.
I also have an external My Book 500 GB with triple connectivity (Firewire, USB and eSATA).
When I connect this external HD with the eSATA cable on my M6400 while running XP 32-bit it works perfectly.
Attempting to do the same thing while running windows 7 64-bit will typically result in file transfer hanging somewhere in the middle (this also hang windows explorer). I then have to disconnect the eSATA cable to resume windows operation.
The USB mode works fine, but the Firewire seem to have to same issue than the eSATA.
I am wondering if anybody else is having similar issue and / or anybody has any idea(s) as to how to fix this.
I can use the USB, but I frequently have to transfer virtual machine back and forth so I could definitively benefit from the eSATA improve transfer rate.
I run the HD Controller in AHCI mode
----------
Dell M6400
Intel Core 2 Quad - 2530
4 GB Memory
2 HD (1 Patriot TorqX 128 GB and one Seagate Momentus 320GB)
BIOS: A07