When I logon to Win7 it hangs at 'welcome' for quite a while, then goes to desktop and has the loading cursor while my desktop icons load, then my antivirus loads.
It isn't crazy slow, it is just a lot slower than my M1530 which was instant. Am I just noticing the difference between my 5400rpm drive and my old 7200rpm drive? Is it a significant difference? I will be poppin in another WD Scorpio Black
I seem to be having an issue with playing DVDs on my SXPS 1647. I have the Blu-ray combo drive (HL-DT-ST DVDRWBD CA10N, with firmware A109).
Every few minutes you can hear and feel the drive start clicking. When this happens, the playback starts stuttering for a few seconds. This doesn't seem to be an issue when playing Blu-rays.
The drive still clicks every few minutes, but the playback doesn't stutter. Is this normal that the drive should be clicking every few minutes? I checked to see if there was a newer firmware version, but the latest version on Dell's site was A108.
So lately (the last few days, just out of nowhere) I've been starting to have a problem with an XPS m1330. Every now and again the notebook starts Windows
A lot of the times it doesn't go past the welcome screen (after entering the user password etc.)
If it does get past the welcome screen it just is extremely slow for the first 5-7min then, it's normal again .....
I've had a Vostro for a couple months now and continue to be plagued by slow startup times of 2-3 minutes. Just as a frame of reference, I have 3 systems: a desktop I built, a Latitude E6400 and the Vostro. All have similar specs - a Core2Quad on the desktop, a dual-core Centrino on the Latitude and a Core i5 on the Vostro; each with 4GB RAM. I've installed Windows 7 Ultimate 64-bit and the same software on each of the machines - if anything, the Vostro has LESS software on it than the other 2. I downloaded all the drivers directly from this site.
At first I thought the startup time was slow due to a 5400 RPM hard drive, but last night I replaced it with a 7200 RPM (though not a fresh install - I took an image of the existing installation using imagex and applied it to the new drive) and it's still slow to boot. I turned off some programs and services in msconfig and using Revo and CCleaner and still get similar results.
Just now I turned both laptops on simultaneously to make sure I'm not making a big deal out of it (especially since the Vostro goes straight to desktop and the Latitude requires me to enter credentials) and I still got to my Latitude's desktop first - despite having to re-enter the password a couple of times!
I'll note that this is the only time the Vostro feels slow at all. Once I'm in everything runs smoothly and resuming from hibernate is noticeably faster (reasonably so I suppose)....
I have a Studio XPS M1640 and I'm experiencing extremely slow internet browsing with firefox and ie. My SXPS has the Intel 5300 card, which I've read has problems such as dropouts and slow speeds. I'm also running Vista 64-bit, which I'm assuming could also be part of the problem. Web pages take way too long to load, but my download and upload speeds are the same as they would be if I plugged directly into my router. Has anyone else experienced slow browsing with their SXPS 16? I'd love it if someone could give me a solution to this.
A week or two ago my Studio XPS 16 use to boot up fairly quickly, but now it takes about 3-4 minutes to boot up from shut down.
The only things I have running at startup are Zonealarm, Skype, Dell Touchpad, NOD32 Antivirus, and Dell Quickset. I'm running Vista 64-bit. Has anyone else experienced slow boot times with their SXPS 16?
I have dell inspiron 15R, 1TB HDD, i7 processor, windows 8.1. My C drive has 500GB(approx) memory out of which 200GB(approx) is free
It used to work fast but suddenly it became very slow. I tried restarting , it got shut down but was unable to start. So I ran diagnostic test which gave an error in hard disk with error code :2000-0142. The next morning I ran the diagnostic test again and it ran successfully without any error.
I formatted it from my recovery disk and it took me almost whole night as the formatting process was also very slow. My laptop still works very slow. It takes almost 15mins for start-up and my applications are also opening too slow.
It's been a year I've been using Lenovo p500. It works great, but recently the startup has been really slow. it takes around 3-4 minutes sometimes. Is there any way to improvise the performance?
Purchased from Amazon 2 months ago and worked perfectly without a hitch until a few days ago when I got on the receiving end of the win8 equivalent of the BSOD with the . From them on I ended up with slow boots random pauses etc. I opted to refresh the PC without affecting any files but toward the end of the reinstall the BSOD appears and now all I had was a black background with only a white cursor.
Left that for over a hour, nothing happened so held down the power button to force shutdown. Found that Z500 no longer boots into win8 so eventually decided to do a clean reinstall with the onekeyrecovery via NOVO button. This should have been the end of all the problem I was having but unbelievably the problem is still there.
Research what I could about this and found that the slow boot is caused by hard disk constantly being thrashed about by a system file ntoskrnl.exe. I tried updating the wifi driver and it appeared to have done the trick until the next day when I booted up the system again. It appear that the constant hd activity goes away after a few hours of leaving the PC on.
Anyway I have drawn a blank as to what's going on especially as everything was working perfectly until up to that point with no signs of system conflict.
This is interesting... a friend of mine just tried to order the SXPS with the i7-820 processor and got denied by Dell. Apparently, the 1645 has been fully discontinued, and Dell will no longer be placing the i7-820 processor in any SXPS form factor. They quoted that due to hardware and power issues as the reason behind discontinuing the 1645 (and replacing it with the 1647) and killing i7-820 support. The sales rep said the only offering will be the Studio series for the i7-820.
As a 1645 owner with the i7-820, this is kinda scary that this laptop has been discontinued this quickly as well as the offering of the 820 series chip. We ended up calling a second time, and another sales rep confirmed the same story.
Anyone get similar information from Dell on this? I'm also wondering if this is a "Dell Canada" thing...
When I first loaded up my Vaio the Startup Assistant booted by itself and I unchecked the box to stop booting on startup. After the while the Startup Assistant started booting up by itself even though the box is still unchecked. I thought by recovering to factory settings and unchecking the box would fix it but it has started booting up again.
I have Compaq Presario CQ42-273TU NBPC. In my laptop , if i play video , it becomes very slow. After video becomes slow, everything else on the laptop becomes slow. recently i gave laptop for service also, then also i have issue with video.
After waiting for over a month or so, I finally got my XPS 1647 from dell. I was very keen on adding a second HDD to store bulk data and use a SSD as primary driver for OS.
Speical thanks to this specific thread, specially Nando4 for all the information.
Pre-Requisites:
Confidence to open your laptop
HDD Caddy to replace the Optical Disk Drive - I got one from New Mode Electronics, which sells such caddys. This specific machine uses 12.7mm (height) slot-loading model with SATA external interface. You can buy it on ebay too for a cheaper price, but most of them ship from China and takes a long time to arrive.. and if there is a problem..its a nightmare to return or re-order. A second HDD
Dell Service Manual for Studio XPS 16 series - Specially how to replace the Optical Drive
Here is the Pictorial :
Click on each of the image below to see a larger image (in a new window)
Step 01 - Ready to Dismantle the Laptop
Step 02 - Remove the Back cover (10 screws to remove)
Step 03 - Remove the Rear caps (slide, and pull out as described in the dell service manual). Don't apply force.
Step 04 - Remove 14 screws (this is needed to remove the palm rest). On my system 10 screws were marked "P", 2 were marked "K" and 2 were flat screws.
Step 05 - Turn over, and remove the two screws to remove the palm rest. (Point to remember - once you are done, and when you tighten this later, don't tighten it too much, else the plastic under it would crack). Once the two screws are removed, use the two tabs to pull out the palm rest (as described in the service manual)
Step 06 - Disconnect the cables connected (by lifting the tab - again - its described very well in the service manual).
Step 07 - Remove the cables connected (two of them). Now the palm rest is free & the motherboard and the ODD is visible
Step 08 - View of the mother board and ODD
Step 09 - View of the mother board and the 3 screws that need to be removed to free the OOD
Step 10 - One screw at the back to remove the ODD. Point to note - the HDD caddy did not have this screw hole - but the HDD Caddy fits in place securely with other 3 screws.
Step 11 - the ODD is now free - You can see the inter-poser (SATA to the motherboard pins) - simply pull it out from the ODD to set it free.
Step 11a - View of ODD out of the system
Step 12 - The ODD and the HDD Caddy that I got from New Mode Electronics. There is a component that is used on the ODD to secure it to the motherboard - This needs to be removed (2 screws) and put on the new HDD caddy as shown in this image.
Step 13 - View of ODD, Securing Component, Interposer, and the HDD Caddy - all side by side.
Step 14 - The new HDD caddy with the 500 GB Seagate HDD (that came with my system), interposer and the securing component
Step 15 - Plug in the HDD caddy in the system and fasten the screws. From this point, its just a reverse process of putting things back in place (palm rest, screws, rear caps and the back cover)
Step 16 - BIOS - now shows the second HDD !
Step 17 - Window Shows the second HDD!
Total time taken from start to finish (including taking photos..etc) - 60 mins!
So, there you go.. you now have a second HDD in your XPS 1647..
I've been stalking the XPS 1645/1647 for a while now hoping that the overheating/under clocking issues get resolved. I'm to the point now where I just need to roll the dice and make one of these work for me.
Currently I work off of a Mac Book Pro (latest unibody) with the 3.06 GHz processor upgrade and the 256 SSD upgrade and 4GB RAM. I do primarily web design (.NET, WordPress, etc.), so I stay in Windows (via Bootcamp) most of the time or work on my Sony Vaio Z. I was waiting for the Bootcamp upgrade to come out in hopes that it would help the hardware cope with Win7 better. Well, it came out a couple of days ago, and it did help, but it's still lacking in a few ways.
My question is around the processor. My everyday activities, making up 80% of my day, are fairly light with the exception of Adobe Creative Suite apps and Microsoft Visual Studio, but I do a decent amount of video processing. I am looking for the most power available without sacrificing battery life. If I understand the processor options correctly, that would be the i7-620M. How would that processor compare to the i5 540M in terms of speed and battery life? I have read that the i5 is "newer technology" and "should" be more efficient than the i7's.
It should be shipped in a week or two, and I was wondering what recommendations you all had for it. I plan on reformatting it to get rid of all the bloatware and also undervolting it.
I'll use it as a desktop replacement and occasionally play some games on it (probably nothing too demanding though). So any suggestions on what to do to start off right and keep it healthy?
I'm getting this next month (or the order says I am), and I have a couple questions reading this forum:
1. I'm getting an i7 Quad Core -720, that's still a 1647 right? I keep reading that the 640 is what that goes up to, but am not sure.
2. What is throttling? I do a search on the internet and all I get is Drag Racing info Is that when the fan starts to spin super hard?
3. I've got a 1640 that I'm selling once I get it....it's new from Dell because of an exchange so no warranty (but can be upgraded by the buyer), what do you think is a fair asking price? It's a P8700 2.53 Core 2 Duo, 4GB RAM 320GB HD, 512MB ATI 3670. HD screen, etc.
I just got my 1647 in yesterday and it's been a struggle of immense proportions. I have a MSDN subscription, so I ordered it with Win7 Home and reformatted it when it got here to install Win7 Pro. I have finally got all of the yellow exclamation marks gone from the Device Manager, but I don't have any Bluetooth connectivity.
I could have sworn I checked that box during the build, but I can't find it in any of my documentation. What's worse, when I go back to the Dell EPP site, I don't even see the Bluetooth module listed as an option when trying to build another one. Could this mean that it isn't available on XPS's configured on the EPP system?
I do see the Bluetooth radio listed in the BIOS to be turned on by the wireless switch, but the light never comes on, on the front of the machine when turning wireless on and off. I'm taking that as a bad sign.
I have just ordered a XPS 1647 & was unsure if I should download all the Bios from the DELL website when I get it. There is currently the A00 & the A01, do I download both or just the latest release
I've been starting to see more references about Studio XPS 1647 here and on Dell's site, but I couldn't figure out what distinguishes this model from the others (1640 & 1645).
I'm pretty disappointed since the whole reason I bought this computer was for photo editing and the RGB Led screen was just perfect. But the Dell rep tells me that they are no longer offering that screen and that they will be sending me a 15.6 inch WLED.
They are still checking with the dispatch people to make sure that they aren't shipping the RGB Led, but I was wondering what my options were? I'm tempted to ask Dell to give me the Studio 17 instead, since it seems to be one of the last Dell computers to offer the RGB Led.
I installed dell webcam central in the hopes that would update the driver, but although the webcam central SW works, the driver has not been updated in device manager. It still says the MS Integrated Webcam 6.1.7600.16385.
What do other people who have no problems with their webcam see under device manager for their imaging device, and where did you find the driver?