As my Studio 1557 kept giving blue screen, I decided to run diagnostics. When both rams were installed I got 2000.0123 Memory integrity test failed. Then I uninstalled one, i got same error.I tried the one i just uninstalled on same slot, i got same error.And then i tried them both on the other slot, i didn't have any errors.
The thing is, fan has been changed 2 times, and mainboard has been changed before. I've been using this notebook with an acceptable Thermaltake cooler from the day I have bought it. What makes this notebook like that? 7200rpm HDD? i7 processor?
My HP elitebook 8540p has been serving me well for years but recently it shows a bluescreen and resets after entering the windows password.
Diagnostics when starting up say:
Memory Test: Failed Failure ID : UOEDUC-56C77E-XD7U3G-40N603 Product ID : WTO38ES#ABH Memory Module 2 Bottom-Slot 1 (right)
This means the memory card underneath the keyboard should be replaced, correct? I am confused by the message saying "Module 2 Bottom-Slot 1 (right)", I see only one card... If so, what is the best way to acquire a new memory card (Primary memory board)?
I'm trying to load a new hard drive for my Dell Studio 1557 LT due to the original failed. I've worked on many PCs and LTs before and loaded software so I know the basics and then some. Problem is, when the LT boots from the OS from an external dvd drive -Win 7 64 when it attempts a write to the hard drive at the same point in the installation every time it blue screens then reboots. I cannot capture the blue screen info due to the immediate reboot. I have tried many utilities and other hard drives but the LT wont let me write to the hd to load an OS. I tried loading a hd from another pc then install it into this LT, same results blue screen then reboot. Very strange as if the LT wont allow a new hard drive or OS to be loaded. I've been trying to get this loaded for a week now and have tried everything. The hd was even DoD low level formatted too. Is there s Dell disk I need to get it started ?
I ran de PSA diagnostics on my Studio 1555 and I got the error 2000 - 0212 (CMOS failed the pattern test). I changed the CMOS setting to default, ran the test again, and I got the same error.
Called Dell tech support, they told me that they are going to replace my board. My original problem is that Win7 is taking more than normal to start (2 - 3 minutes to be ready).
I got an Intel C2D P8700, 4GB RAM DDR2 800MHz, ATI Radeon 4570HD 512mb, 250GB Samsung HD 5400RPM. It should start fast, since the HD has no fragments, the win reg is ok and I have not crappy services or programs at startup. Does any1 know what is this error about?
I have a Dell Studio 1535 Laptop from 2008. I got an error message telling me to reseat the memory modules. I looked up how to do that and did it. I tried to boot it back up and still have the same error. I did try to reseat again and I am still getting the error. What should I do next?
I have a hp pavilion g7, operating with windows 7As of this evening, my laptop is failing to start up and freezes on the 'starting up' page display. After doing several of the recommended options, I ran the start up test which has failed.
The display screen reads-Memory test: passedSmart check: passedShort dst: failedFailure id: GU6E00-63479L-MFPX01-60TP03Product id: A7A44UANBAHard disk 1Start up test: failed
The dell support center PC Check showed my hard drive funnel seek test failed. Before I ran the PC check, the laptop flashed and shutdown. I restarted in safe mode and backed up all of my files, shut down the laptop again and restarted.
I am currently rebooting the laptop, and have inserted the Dell Diagnostics and utilities CD and testing my hard drive. the following error code keeps occurring..No additional sense information
Test Results: Fail Error Code: 0F00:1332 Msg: DISK - Block 4507 : Interrupt Request (IRQ) did not set in time
The same message also occurred with the following Block Numbers, with the same error code:
I recently ran a test on my laptop(N4050).It first showed me I had a SMART extended self test failure. Then I had a hardware failure message. I have attached one of the things.May I know what am I supposed to do? My warranty has expired.
I have a dell inspiron 1750, and the past couple of weeks, i have been having intermittent screen problems, it occurs when i shut the computer down and then restart it, sometimes it works, sometimes i get a bit of light off the screen but its just blank (black), i know everything works because when the windows 7 start up screen comes on, i can hear the sound and can enter my password (even though i have a blank/black screen), i did a diagnostic test and the lcd test failed, i got the error code:
Error code 0321 Msg: Error code 2000-0321 Msg: LCD EDID - Unable to access the EDID EEPROM
I just moved he screen, and it goes different colours and pixels go out of place, i think it might be a loose/bad connection on the right hinge where the laptop joins the screen?
My HP Pavilion G6 laptop fails to load Windows. The HP UEFI diagnostics for hard disk failed the Short DST test with failure code GU754F-6PK7GW-MFPWXG-60TQ03. Does this mean I have to replace my hard drive? My laptop's product ID is E3D62EA#ABU and I have Win8.1 64-BIT installed on it.
My laptop HP Pavilion dv6-6c35dx fails to load Windows. I ran diagnostics and got a quick (303) error. The HP UEFI diagnostics for hard disk failed the Short DST test with failure code MBX47F 0006QU PXGK01 60QT03. Does this mean I have to replace my hard drive? My laptop's product ID is A6Y53UAR#ABA and I have Win7 -64 installed on it.
I have a Pavilion dv7 1245dx with Windows Vista 64 Bit bought 2009 at Best Buy. It slid off the arm of the couch onto a carpeted floor while shut down. Next day started ok, got into yahoo, facebook, then kind of froze up. Eventually, would not do anything, manually shut it down, started it back up. Black screen, 'No Bootable Device-Insert Boot Disc And Press Any Key'. It will not accept recovery discs that I made after purchase. Start up test ok, memory test ok, hard disk failed 'Boot Drive Not Found'. Caps lock light is blinking. I saw something in a forum about resetting or reseating the hard drive but no explanantion how to do it.
I haven't noticed any issues with my PC, but the scan reported this today on device Seagate-ST9500420AS-5VJEW3V. what this error means, what device it's referring to, and a recommended course of action?
I noticed that the Studio 15 is pretty much the same as the Studio XPS 16 minus the RGBLED screen. I really don't know which to choose and really need some guidance from some expert people. Here's what I have in mind:
Is that possible to install Windows XP sp2 on DEll Studio 1557 with Windows Vista Home Premium pre installed?
Getting the error acpi.sys on the blue screen when installing the XP.tried googling it, was told to disable acpi, but that option is not available in this bios.
heard that, we can download the sata drivers for XP and integrate them into XP bootable installation disc?? also, can we press F6 when loading XP, and insert the drivers cd of vista to install the raid drivers and resume the setup with XP?
Blue screening regulary over past 3 weeks, albeit in random pattern. Removed recent programs just in case. Just ran dell test and it failed on System Memory - Advanced Pattern Test. Whether blue screen and system memory fail are related.
My Acer Aspire 5101 wasn't running very fast so after the usual anti-spyware and anti-virus programs I tried the Windows Memory Diagnostic program booting from cd.
My laptop came with two sticks of 512MB DDR2 RAM. I got fails on wmats+ so I tried each stick seperately in both slots. I got the same errors for each stick in either slot.
I don't know what to do now. My laptop is out of warranty so if I want to speak to Acer technical support there's a 50p/min helpline. I thought I'd ask for advice on this forum first to see if anyone had any other advice before I end up spending a fortune on the phone.
I`ve just recived my 1557 and after 4 days of using it i can tell you this...
I HATE IT! I can`t really use it without overheating! I`m an Industrial Design student, and i use a lot PS, Solidworks, 3dMax, and various rendering engines. While using them, just after 5 o 6 minutes of rendering, the laptop overheats and turns off.
Just when it starts, core temperature rounds 73/75 degrees celcius... it reaches about 93 while rendering... and i can`t even tell when i`m gaming (i used gta san andreas for 10 minutes before ati 4570 reached 105 degrees and core about 90, then it shutted off). I`m so annoyed.... this really bothers me, in a few weeks i`ve to get back to work and university, and i have a usless "POWERFUL" machine!
I need recommendations for a new laptop, because i`m going to send thisone back next week. I don`t care if it is apple, asus, or hp, i need something wich i can really use, and i need it to be just as powerful as this (or a little less, i don`t care, as long as it really works and do de JOB).
My budget is arround 1500 US dollars.
My 1557 Specs: Core i7 720QM, 4gb DDR3 1066, 320gb 7200rpm, ATi 4570.