Dell XPS 1640 System BIOS A10
Changelog states:
1) Enhance graphic function.
I've noticed that it adds display dimming and brightness levels to Power Options:
However, I haven't noticed any changes to the RGBLED screen calibration as was reported by KSMB in the RGBLED thread.
1. Updated Intel(R) Active Management Technology firmware.
2. Updated PXE OPROM
3. Updated TPM MA/MP driver.
4. Showed LOM MAC address in BIOS setup.
Fixes/Enhancements
------------------
1. Updated thermal table.
2. Removed HDD Acoustic support.
3. Added password support for remote console.
4. Fixed issue where Local KB control is not released properly during or after IDER session.
5. Enhanced INT 19h support.
Please update to the revision immediately and post your results here. It seems importance is rated as Recommended and not urgent, so I'm not sure whether or not the system downclock and fan issues have been fixed, which is quite an urgent matter.
If someone could get a log file of the changes from Dell that would be great.
Update: Thanks Weegie:
Fixes/Enhancements
------------------
1. Added support for BIOS that is signed.
2. Updated to PSA build 4117.
3. Updated thermal table.
4. Fixed the issue where system is slow to boot to internal hard drive after failed PXE boot exits.
5. Fixed the issue where Some BIOS Setup parameters are not accessible with only the keyboard.
6. Fixed the issue where system will automatically shut down at resuming from S3.
7. Fixed the issue where the time of BIOS power event log in Setup is wrong for power button event.
8. Fixed the issue where presentation mode cannot be turned on/off from the DCP.
These things look sOoOoOoO important .
During the flash, the only thing that appeared was "Updating Keyboard Controller ROM", but I don't know if that's regular or not. I will be gaming with this new revision and posting results soon.
All in all, nothing to see here. Seems like Dell either a) does not read our threads, or b) does not care. Nothing to see here .
Dell has released A09 update for Studio XPS 1645 on 17-May-2010
The update resolves following issues:
*Features update:
1. Update Processor Power Management(PPM) from 0.60 to 0.63-1 .
2. Support 2nd source SPI ROM EN25F32(BIOS) and EN25F80(EC).
3. Update ME bin file in BIOS for 2nd source SPI ROM EN25F32(BIOS).
4. Modified flash part size to prevent BIOS crash in failsafe part for factory only.
5. Support over 230W adapter to treat as 130W(EC).
6. Update Clarksfield thermal table to V.03(EC).
7. Enhanced PPM RC code for P-state thread count.
*Issues fix:
1. Fix S4 long run failed on DC mode with BSOD 9F.
2. Paltrow freeze issue: Hang up when playing youtube HD film.
3. Fix unable to communicate with battery error under delldiag.
4. Fix ACPI_PSD error in "powercfg -energy" tool under windows.
5. Fix Micron DDR3 memory can not boot up issue.
First of all, I have no idea if this has already been covered on the "Precision M4400 Owner's Lounge" thread, I have not been following it for it getting longer and longer.
So, I opened a new thread to tell everyone that Dell has released BIOS A13 for the M4400. I installed it yesterday, and not only is my machine quieter under light load, its graphics performance is also higher - much higher, actually.
I used to think that my FX1700M was not affected by the downclocking, but now I stand corrected.
It WAS indeed downclocking heavily as it seems. When I was playing some UT3 a couple of hours ago, I suddenly actually had double(!) the frame rate compared to what I had with BIOS A12.
I maxed out some settings to see what would happen, and at settings that I was not able to make it run smooth some weeks ago I now got 30 to 40 frames per second
new bios is up on the Acer support listed as version 1.16V?
I checked out the file but nothing listed and documentation?
Acer 6920G Bios Updated 1.16v
There were many SR4 laptops sold in May 2009 in China suffering the problem of stopping responding randomly and frequently, which caused quite a lot of hot threads discussing.
Sony identified the problem as some bugs in BIOS firmware and hence released an update to fix this.
Official site:[url] (Chinese site, Google Translate may work)
Download link: [url]
As a "side effect" some customers noticed that Sony has officially enabled the option of VT in BIOS settings!
This is quite unbelievable according to the usual style of Sony. Maybe it is because of the pressure from XP mode in the upcoming Windows 7.
Unfortunately the BIOS update still does not give SLIC 2.1 so to activate Windows 7 we still need SLIC 2.1 from Lenovo or other brands.
I just got the xps 1640 today and I'm very distracted by the loud system fan. It's audible all the time even when the computer is idle. I haven't been doing anything intensive on my computer either. The fan starts as soon as windows loads and never stops. I know this laptop has heat issues but I checked the core temp and it is only between 38-45degrees C. I know the fan can get louder under load, this is what I would describe as idle but still, it seems way too loud. It was raining earlier and I could hear the fan over the sound of raindrops hitting my roof. It's getting unbearable!!
Has anyone had the same experience? Or more importantly does anyone have a way to reduce the speed of the fan slighty? Speedfan doesn't seem to support my motherboard so I can't do it there.
System:
P8600 2.4ghz
4gb ram
320GB (7,200rpm) WD HD
full review of studio 1640: how a perfect system ends up on ebay
View 4 Replies View RelatedDo not upgrade... the upgrade killed my motherboard, I dont know what happened. I as installing it fine then it was totally unresponsive and would not shut off. I then had to take away the power supply and now Dell is coming to replace my motherboard.
View 10 Replies View RelatedI am not liking the latest A06 BIOS as it has increased my 1640's CPU operating temperature.
View 4 Replies View RelatedI just got the SXPS1640 and have been playing a game that is getting a bit warm after a few hours of play then the game started loading slower.
I was doing some reading and found that you can update the bios to A07? I found the download, but wanted to make sure that the computer doesn't already have this and how to install and it too.
So I tried updating my BIOS to version A14, the current one on Dell's site. Running Windows 7 Ultimate 64, btw. It seemed to update fine, but when it restarted, I got a black screen.
I waited about 20 minutes, powered off, then back on. It booted into Windows, now however my keyboard does not work. Most keys do not work, and the ones that do produce incorrect characters.
Also, whenever I restart Windows, it does not reboot. It will hang at a black screen until I power off and back on. Currently typing this on a USB keyboard.
When I go into setup, it does say version A14, so I'm assuming it went through, but for some reason is not compatible with my system. Can I downgrade to fix this, and if so, where can I find an older BIOS version?
should i install the latest bios driver a08 from the dell site? i dunno in these things and i wanna know if it's recommended and known to not screw things up, and if i even need it
View 4 Replies View RelatedJUST GO TO DELL DOWNLOADS
View 10 Replies View RelatedDoes anyone know how to reset the bios on the XPS Studio 1640?
I can't seem to find the required jumpers. I've tried to only remove the CMOS battery for a while but that didn't work
My laptop is Dell studio xps 16. i try to update bios from A11 to A12 and my laptop was crash during this update. and now my laptop can't boot to win. how to recovery bios of this laptop?
View 10 Replies View RelatedI've attempted updating my XPS 1640 BIOS to A11 in my notebook.
It hanged up at the half of it (it said "Erasing block 16 of 32") and after waiting for 1 hour, I restarted the computer...
Now it doesn't start up, when I press the power button, the 3 volume keys start to blink for some seconds, then the keyboard light turns on, and the computer turns off after a couple of seconds.
I have a Dell XPS L321X that currently has both an admin and system password set. I know these passwords, that is not the issue. The issue is that I would like to remove the system password but leave the BIOS password protected.
Maybe I am being dense, but I cannot find where to DEACTIVATE the system password. I have the option change it but not remove it.
Ok so after all the speculation it has finally happened. Head over to dell.co.in and customise an xps 16 and you can upgrade the graphics card to a 5650. Unfortunately this wasn't the complete redesign many of us were hoping for, but at least its something. Anyone know what the performance difference will be?
View 10 Replies View RelatedUbuntu 9.10 is perfect and to be true it too just works out of the box , given the fact that it has to support infinite pc configurations it is great !!!
Hail 9.10 .. and if you wont try you will surely miss something great. Where else do you have a resume and sleep time of 2-4 seconds. bootup time of less than 15 seconds ..
It doesnt have a lot more to take to catch up .. i am certain that in a year or so you will see emergence of linux everywhere .. Just that volume is what promotes things,
if a lot of people start using linux, a lot of hardware manufacturers will be forced to give better drivers and support.
getting the password for a Dell N5110. A friend of mine was having display problems so we tried resetting factory defaults and now we are completely locked out of using the computer.I read on some previous posts of DELL users saying message me the details, with proof of ownership however the posts were a little dated, is this still a viable option, and in which case who do I need to message?
View 1 Replies View RelatedHi, the Precision 6300 is out in Norway, but only with the FX 1600 graphics option yet.
But you can opt for the x7900 extreme cpu..
New Display Driver 8.702
http://game.amd.com/us-en/drivers_catalyst.aspx
Drivers are available here for Vista x64.
The are NVidia version 178.75 and should help with stability when using Hybrid SLI.
32-bit Driver
nVidia GeForce 8400M, GeForce 8600M, GeForce 8400M GS
[url]
Version: 176.44 V32, A10
Product & OS Compatibility: XPS M1330; Microsoft Windows Vista 32-bit
64-bit Driver
nVidia GeForce 8400M, GeForce 8600M, GeForce 8400M GS
[url]
Version: 176.44 V64, A02
Product & OS Compatibility: XPS M1330; Microsoft Windows Vista 64-bit
I have a problem with my dell latitude e5510..... After Updating the Bios last version() ,BIOS has been Locked and i have no access to bios, although system powers up and my windows boots without any problem..... I tried every method searched in internet but no result ... as I realized this model has a high security system...I think by updating the bios a default pass created for the bios.
View 1 Replies View RelatedI have a dell 7720 laptop, which I would like the Windows 7 install on a SSD msata. I set UEFI, everything is OK, it loads the installer, run the install halfway, and it's the first reboot, the BIOS can not find the half-installed Windows, and start over again ... I have tried everything, I have the BIOS is re-installed. Windows 8 is also doing the same.
The funny part about it the same way I did two months ago and everything was fine, the machine worked, I just wanted to make Windows 7 the next and 8 easyBCD replaced with the sequence, and then he died doing it every since.
Maybe this program (easyBCD) I reached into the BIOS to do a bios update bios reset and not restore? If you do not install uefi, but then a traditional HDD for no reason, and the SSD is not uefi does not work.
I think the BIOS is going to be something, because I see the following installation to set up the UEFI, and partition, but the BIOS does not recognize (ran half the installation and over again to start because UEFI boot is not displayed you installed.) If you set it that boot device is added, it will print that you can not find a file system, but if I turn off the traditional boot then you will find the first installed unfinished Windows, you add the boot list, and then I went to the BIOS settings, restart, and again, you do not see your operating system. (none of what I just set it boot list)....
I've just tried downloading and installing the latest bios update for my XPS 13 laptop, update 3360A18.
When I run the update, from inside Win 7 x64, I get a "ERROR 242 - This is not a valid supported system!"