HP/Compaq :: DV7-1135nr- Finding Correct System Board
Jan 3, 2010
I have an hp DV7-1135nr laptop. Recently there was an incident and one of my friends managed to throw up into my laptop while it was open and on. The computer was off before i could pull the battery and even after being cleaned and dried will not turn on, this leads me to believe that the system board has shorted out and needs to be replaced. Where can i find a replacement system board and how much should i expect to pay?
Seeing as how i have already taken the laptop apart, are there any upgrades I can do while replacing the sytem board? It has a 2.0 ghz dual core AMD
processor, and crappy integrated graphics. I was wondering if i would be able to purchase and install a better system board?
View 4 Replies
ADVERTISEMENT
Nov 4, 2009
if anyone who has an HDX 16t-1200 could tell me what their system board ID is. You can find this out by going into your system BIOS on the main info page on the front it lists your system board id.
View 10 Replies
View Related
Mar 16, 2009
can any1 give me a list of drivers for a dv7-1135nr witha amd processor and a hitachi hts543225l9a300 ata device harddrive all i need basically is the filename to slipstream n to the os with nlite
View 6 Replies
View Related
Nov 22, 2014
I have an HP G62. After failing to enter the correct administrator password 3 times, it gives me error code 50889491.
View 2 Replies
View Related
Aug 14, 2014
I have several HP 8530p and I getting the num lock & cap lock leds blinking 5 times which indicates a general system board error. Bought new boards still getting the same issue. Note all the units will boot to windows fine, but there is a 10-15 sec delay in hard drive response when operating pc. The mouse is real time responsive but once you clink on a item the lag shows up. What to look for as the problem, CPU , Memory changed, Fans, Cooling system. Bios versions have been updated, I've torn the unit down, cleaned and added new thermal paste to CPU, GPU and added copper shims to promote better heat transfer. The system Diagnostics indicates hardware is ok.
View 3 Replies
View Related
May 13, 2009
how to slipstream sata drivers onto Windows XP installation disk I decided to try it out. I had two unsuccessful attempts and I'm wondering that it probably is due to me using the wrong drivers for the job.
I have a Dv5t 1135ee, can anybody please direct me to the right drivers that I need to put onto my Windows XP installtion disk to not get a BSoD.
View 4 Replies
View Related
Mar 26, 2009
I plug in my adapter and it turns on and all is well once I put it in the charging port to charge the battery of my computer the adapter shuts off immediately. The charging port on the computer is slightly cracked from a fall about a year ago but it recharged perfectly fine until now. I've had 2 other adapters go out on me the original and an aftermarket and now this one is acting up on me. After a bajillion trys if I get the charging prong at the exact right spot it'll charge the battery if I push it in too far it shuts off etc.... Is this a circuitry connection problem? Does it have something to do with the cracked charging port? Is it an electrical short? Is it another bad adapter? Is it a bad battery? Is it a bad "charging board"? Which of these is most likely the case?
View 4 Replies
View Related
May 2, 2009
I replaced this board and display worked for approx. one day, now no display again, notebook still diplays fine on external monitor.
View 3 Replies
View Related
Jun 3, 2012
After rebooting my system I now come to a screen to enter system password. Only thing is.. I never set this and there is no way around it.I have tried the take battery out reset CMOS trick that used to work in desktops to no avail.
This is the message I get after too many password attempts.
system disable key 92931076
View 4 Replies
View Related
Apr 9, 2009
Well got my third E6400 and third unit that had a CCFL from the outlet when ordered a system with LED. Got a hold tech support
they overnighted a new screen T661h which is a CMO. Bezel a RK149 and a Y793H assy back cover which has a inverter
View 10 Replies
View Related
Sep 16, 2009
Would someone please verify that the utility used to flash the BIOS on my new Acer laptop looks like it does in the attached image? Because flashing a BIOS is a pretty serious thing to do with a purchase that costs $500+, I was surprised to see a picture of a CRT monitor wearing a wizard hat using a pencil to erase something. Also the use of non standard fonts is disturbing.
more importantly, are all ACER bios releases unsigned?
The attached picture is of the Insyde InsydeFlash utility for a 4810T v1.28 BIOS.
View 10 Replies
View Related
Sep 3, 2014
we just got a new Dell 15 3542 for our son for school..
1) Which is the correct size SSD for his laptop? 7mm, 9mm, etc
2) Which Dell drivers would I need to load onto the install after installing Win 7? Audio, video, network drivers?
View 4 Replies
View Related
Jan 3, 2008
Im using the Juan Lu bioses on my Inspiron and with 7900GS bios with a voltmod the temps were coming up to 91C (the clocks were 520/750 more or less). And then i decided to flash it with a gtx bios with a volt mod - and it works! It lets me overclock a little higher (like 580/750, but it seems that its not very stable though...) and the temps are a lot lower! 69-73C. I once saw it go up to 86C, but thats that. Also the idle temps went down from 63C to 54C. So my question is - is this real? This is a huge difference, video bios can do that? Or mayby... somethings mixed up with the sensors and theyre not giving the correct temps?
View 10 Replies
View Related
Feb 10, 2014
I was wondering what the correct resolutions are of the 3 available screens on the customizing page of the Lenovo E540. I can't find it anywhere and I really want them for comparing.
View 1 Replies
View Related
Oct 29, 2014
I'm looking to find out the correct DDR3 RAM memory for an Aspire 5736z-4460. I bought it used and am not sure the PC3-12800s is correct. I do know it's PC3 or DDR3.
View 5 Replies
View Related
Jun 20, 2009
Looking for a SSD as my primary drive.........................
View 10 Replies
View Related
Jul 31, 2008
One of my computers is a Dell XPS M1210. When I purchased it the OS was XP. Later on I upgraded (uhh that is questionable these days..) it to Vista Ultimate. I am thinking of doing a "dual boot" for it but I cannot locate the registration code for Vista. Seems the code was on a box that got tossed. Does anyone short of calling Microsoft know how to locate the registration number perhaps somewhere on the computer?
View 12 Replies
View Related
Dec 26, 2007
I always put 8 degree offset on my 2500M/7900GTX. I never questioned it before. But couple of days ago a guy wrote this on this forum (read bellow), so can someone comment or clarify this for me?
"I hit 87C in Crysis, so you're doing damn good there. DON'T use an 8 degree offset in FanGUI. ATITool reports wrong temps. To prove this, put your system to sleep long enough for all components to reach room temperature. Resume the system and immediately bring up FanGUI. You'll see with an offset that the GPU is for some reason about 8 degrees higher, when everything should be at room temperature. If you have no offset and then resume, you'll see that your temps are nearly identical, which they should be from a cold start up."
his sig:
E1705: WINXP32 / T7600 / 3GB OCZ PC5400 / 7.2K 160GB Seagate Momentus / 1440x900 / 150W Brick / 7950GTX@670/830 / 169.04 / 11,346 3DM'05 @ 678/837 / Total investment: $2,235
View 15 Replies
View Related
Mar 18, 2013
I was asked to take a look at an E5500. This is what I found:
a) a screen that could only be seen with the correct reflected light; and
b) outboard screen working perfectly.
This is what I did:
a) tried a known replacement inverter board and this didn't solve the problem;
b) tried a known working LCD screen and this didn't work;
c) checked the video cable and it looks fine; and
d) since there's no screen switch that might be stuck and I'm assuming that all functions are software controlled.
I did a clean install of xp pro. Still no good. I looked for a SMD e.g. a fuse and found none.
View 2 Replies
View Related
Jan 31, 2010
I need to find the latest chipset drivers on Intel's website. Dell has several listed and i'm not sure which ones i need so i think it would be best to get them from Intel however i'm not sure which ones to download? Can anyone provide a link?
Dell M4400
Service Tag: HC4GXH1
Windows 7 x64
View 6 Replies
View Related
Dec 4, 2014
know where I can download the drivers with these hardware id's:
PCIVEN_8086&DEV_9C24&SUBSYS_2248103C&REV_04
PCIVEN_10EC&DEV_5227&SUBSYS_2248103C&REV_01
ACPIHPQ6007
USBVID_138A&PID_003F&REV_0104
View 5 Replies
View Related
Sep 23, 2009
I've just completed a full clean install of Win 7 on my Dell Studio (1737) laptop. I can't seem to find the correct fingerprint driver to download. I'm using win 7 x64.I can see the AuthenTec Inc. AES2810 Driver under device manager and it says it's working.I have the digital persona software installed and it tells me the fingerprint reader is not installed or can't be detected.
View 15 Replies
View Related
Dec 23, 2009
Trying to upgrade my wifi card. The machine originally came with Centrino 2200 card. I wanted to upgrade to Centrino 6205. I thought that all I had to do was ensure that I get a card that has a known/authorized FRU, as per the X230 FRU List. So I picked a card with FRU 60Y3253, but upon installing it, I get the all familiar "1802: Unauthorized Network Card" error. Why? What else am I missing?
Images of said card:
X230, W7 64-bit
View 9 Replies
View Related
May 9, 2009
I have a problem, which seems to be a common problem with Win 7 and bluetooth but I have been searching the far reaches of th einternet for 4 hours no with no luck.
My laptop finds the bluetooth hardware and installs drivers automatically, and says it is working correctly, but it cannot find any devices, it just says "searching" and never finds anything.
View 9 Replies
View Related
Sep 22, 2009
Well, after nearly a year since I've done the copper mod, my GPU has finally give in .
Currently, I'm in the process of shipping it back to Dell's repair depot under their limited Nvidia extended warranty to have the motherboard replaced. However, to do so would mean that I have to revert to the original condition to avoid the warranty being void upon inspection.
Unfortunately, I can't locate the blue thermal conductive pads that I took off since the mod...
View 4 Replies
View Related
Oct 15, 2014
I can't find the drivers for my laptop HP Pavilion g6-2337sr for Windows 7. What drivers will be OK for it? I mean, what types or names, how can I find them?
View 5 Replies
View Related
Oct 30, 2013
i need window 7 drivers for this model : 15-r128ne
1. USB3ROOT_HUB30&VID_8086
2. nvidia dsplay driver
View 3 Replies
View Related
Sep 15, 2014
Aspire 1414WLMi driversWhere can I find drivers for the Aspire 1414WLMi (Aspire 1410 15.4")
I can only find for the newer Aspire 1410 11"
View 3 Replies
View Related
Feb 6, 2010
I bought a Sony Vaio vpcf111fx/b 17" laptop and I'm looking to protect it from scratches and dings. I'm not looking for a skin. I've been looking thru google but all I find are hard shells for Mac's.
View 5 Replies
View Related
May 3, 2009
I never got around to installing the Windows 7 beta image, but now I have no idea where I saved it on my MacBook Pro. I definitely did download it. What were the names for the 64-bit downloader (I forget if there was a downloader or how I downloaded it, it was official from Microsoft's site, though) and the 64-bit Windows 7 image? It'd be good to clear up a few GBs from my HD.
View 8 Replies
View Related
