HP Dv7-3065dx Recovery :: Error 601 Battery And Error 502 CMOS
Jan 25, 2015
HP dv7-3065dx Entertainment Notebook. Win 7.
HP battery alert system detected battery capacity to be very low error 601 (internal battery). So I changed the cell to a new CR 2032 battery. Showed the same error. I changed to another new CR2032 battery. The second time I did this I had a new 502 CMOS error along with the 601 error. My clock reverted back to 2009, I lost some of the icons on the lower right, and my wireless internet disappeared.
Now I have two things that need to be fixed.
I turned on, immediately hti ESC, hit system diag. F2, Battery Test:
Battery Test Primary FAILED (on the first battery I put in, didn't check on the second)
Control - Device Mgr. - HP - Batteries - Microsoft AC Adapter, Microsoft ACPI Compliant Control Method Battery, and Microsoft Composit Battery all show that they work.
System CMOS/realtime clock says its working.
Microsoft System Mgmt. - BIOS Driver v. 6.1.7601.17514 from 6/21/2006 says it's the latest version.
I've manually updated my clock. I'll figure out the wireless and icons later I guess. Just need to know what to do about the errors.
where my laptop would shutdown randomly and give me a real time clock error. I googled around and found that replacing the cmos battery would fix the problem. I tried it out but still i am getting this problem.
I ran de PSA diagnostics on my Studio 1555 and I got the error 2000 - 0212 (CMOS failed the pattern test). I changed the CMOS setting to default, ran the test again, and I got the same error.
Called Dell tech support, they told me that they are going to replace my board. My original problem is that Win7 is taking more than normal to start (2 - 3 minutes to be ready).
I got an Intel C2D P8700, 4GB RAM DDR2 800MHz, ATI Radeon 4570HD 512mb, 250GB Samsung HD 5400RPM. It should start fast, since the HD has no fragments, the win reg is ok and I have not crappy services or programs at startup. Does any1 know what is this error about?
17 inch HP Pavilion DV9000 series laptop (DV9417CL). It is AMD, part number GL880UA#ABbA. When trying recovery with cd I made from system and have used before I get a recovery error 0x400110020000100A. My hard drive is starting to fail and I'm trying to replace it with a new drive. These recovery disks were made from drive that came in the laptop.
Since the past couple of days I am receiving this Error 2102: Detection error in HDD2 during every cold/warm boot. It pops up even after a complete powerdown for overnight and boot up the next day. Further, the boot itself has become very slow - shows blank screen until the Thinkpad logo is displayed, followed by which the error message pops up.
I got my 430s, and it's with a 16Gb mSATA SSD cache inside. Now everytime when I open my PC, it shows Error 2101 Detection error on HDD2 (mini sata) and I need to press ESC to continue. Is there any software or driver's problem, or it just phsically got wrong?
I'm getting this error window when I'm trying to do a full system recovery of my sony vaio z thru my recovery discs. When I'm near 17% recovery, it pops up this window:
ERROR: 305: 64
It prompts for OK then the screen just goes blank after that. Would I not be able to recover anymore?
i have a 1705 with 7900gs. ive been getting alot of nmi errors nonparity memory errors. so i replace my old mem stick with two brand new ones. well this did not solve the issues. so i reflash my 7900 back to default and still getting this error. i reformat my machine often so im pretty sure the os is affecting it.
During restore using Acer recovery disks for this Acer aspire 551, the recovery stalls at the final step where the wim file is written to the c: drive. It gives me an i/o error.
I suspect that the disk is functional because I have run the cmd.exe program from the x:drive and then run both scndsk.exe and scndsk.exe /F to fix any errors. No errors were detected.
However, any fix for this error that I have encountered suggests replacing the hardrive. This seems to be inappropriate, in this case.
I should also say that I have used dos commands to copy a file from the system32 directory to the c: drive successfully suggesting that there is no problem with writing to the disk.
Lastly, the cd rom hardware must be working or the disks would not be successfully read to the final stage. How this can be an i/o error eludes me.
On my HP Pavilion the Recovery disk creator kicks out disk 1 (it says it will make 3) with an error note. If I stick another disk in it starts all over.My DVD+R disk is a 4.7 GB. Could it be only one disk was needed?
When i try to enter my bios, i am asked for a password, which i didnt put on there myself. The code it gives me is CNU902222G and i cant find anything on that code. How can I bypass it and fix the issue.
I have a Dell Inspiron N5110. It ended up crashing on me about a week ago. I chose to restore the whole Computer. The computer ended up being stuck in restore mode. I let it be for three days--Too scared to shut it off. Finally I did. I ended up going and doing another restore. It worked. I started up my computer, set up the Internet and all that, then boom. It didn't want to start. It would restart itself every two seconds. I couldn't get past it shutting down on me. Then the last two days, it will start, and go to the "error recovery" page. I can select both options and both will Trigger it to restart again and open up the same page.
I have a Inspiron 1545 laptop and it shows a " windows error recovery". The screen reads: windows failed to start. A recent hardware or software change might be the cause. If windows files have been damaged or configured incorrectly, startup repair can diagnose and fix the problem. If power was interupted during startup, choose start windows Normally.
Ok..... now i have two choices to choose from: launch startup repair (recommended) or start windows normally.
I choose the recommended one and it looks like it is going to bootup but shows this blue screen with flowers on it and does nothing?
Then i choose the second option, which takes me back to the error screen!
HP mini 110 running winXP asking suddenly for current password giving Fatal Error CNU9048J2NWhy did it do this and what is the password to get into the system?
I actually use the password provided from this forum like e9lo7gfg4o, but it is not working.
How to open my HP mini 110. When I always try to open, it says ENTER CURRENT PASSWORD. After 3 tries, it says Fatal Error ... System Failed . What to do?
My sons compaq mini 110 all of a sudden is asking for a current password.It comes back with fatal error with code CNU94224GV.I have never seen anything like this. Is it now a brick?
I have the lenovo ideapad G510 and i get an error message when i trying to backup my system. the message is "current system can not support backup". why it doesn't work?
I have an HP mini 1000 that a friend gave me. It is asking for a password at the startup before windows kicks in. My friend doesn't remember the password and after 3 failed attempts.How do I get the bios password based on this error code?
Few days ago, my laptop wasn't running well. I made a hard reset - remove everything and reinstall windows by using HP Support Assistant. It was done but when laptop reboot, a install windows message showed:
"The computer restarted unexpectedly or encountered an unexpected error. Windows installation cannot proceed. To install Windows, click "OK" to restart the computer, and then restart the installation."
So I press enter many times but it was that message. I have no time to waste. I use HP Pavilion Sleekbook 14-b013nr.
