The hd on my Inspiron 1545 has crashed and subsequently will not boot up. I have purchased a new hd and fitted it.
The recovery disks I have go through the local dell recovery routine but fail on the second disk. I only have the utilities cd from dell no other CDs.
I have windows 7. What I need to restart the laptop?
Dell Inspiron 15Z model 5523 laptop less than 2 years old. Locked up during a Windows update. Refreshed it and lost all my programs. Downloaded Firefox accidentally from a bad site and it was bundled with malware. So I refreshed the laptop again. Had everything working and then later that day it just quit. Locked up and when I rebooted, it said no hard drive could be found. I have a new hard drive, but how do I get my Windows 8 (paid for with the computer) and a boot disk from Dell?
View 1 Replies View RelatedI replaced my WD 250GB RPM 5400 with a WD 500GB RPM 7200 and I get a "No boot sector on internal hard drive" "No bootable devices" I have both original disks ( Operating System Windows 7 and Applications.) I've checked the BIOS and it shows the new HDD. I put the Operating System CD in and started the computer than I hit F12 went to CD/DVD and hit enter I received the message "No boot sector on Internal hard drive" "No bootable devices"
View 3 Replies View RelatedMy Inspiron N5040 doesn't start at all. Looks like hard drive has crashed. My service tag is 9XS8LT1.
View 1 Replies View RelatedMy existing hard drive is failing. So I purchased and installed a new hard drive in my laptop. Ran diagnostics. Failed the hard drive "confidence test" and got error reading 4400:011A target not ready. I ran the "device self test" and it passed. The other possible tests "read test" and "verify test" are grayed out probably because the diagnostics/system cannot see the hard drive. At the dos prompt I can access C drive and run its DIR and CHKDSK. So the new drive appears to be physically installed but the computer system does not recognize or identify it.
View 2 Replies View RelatedI replaced the hard drive on my inspiron 1545 and tried to restore it with the dell data safe disks that I made when I got the machine. Windows 7 loaded but I couldn't do anything with it, It was very slow, I couldn't even get it to update. So I loaded in the windows 7 disk that came with it and now I have windows up and running and updated. My question is what drivers do I need to install. I went to dell/support and entered my service tag number and it came up with a list of drivers (46 of them), some I know I need but others seem to be for things I don't know if I have on the computer. How do I know which ones I need?
Also I read something about a file called Dell System Software but its not on the drivers list. Do I need it or not?
My hard drive turned bad few days back and i now purchased a new WD3200BPVT 320 GB internal hard drive for my system. I installed it myself after reading all instructions and guidelines. But when i start it, system says, hard drive not found, try to reseat it. I have also reset it, but again same error coming. I dont know whats gone wrong with the hard drive or system..?
View 15 Replies View RelatedI have a Dell Inspiron 1545 running Windows 7 64 bit SP1. Recently I cloned my old original SATA hard drive for a larger Seagate (600Gb). All is fin apart from no windows update and an annoying request to activate. When i try to update I get a message that my service isn't running and I need to re-boot. It is running and a re-boot makes no difference. In System properties the laptop says it is activated but Windows thinks otherwise.
View 5 Replies View RelatedUnit powered up fine before, no issue's....worked like a champ until drive failure.
Had a hard drive error code, replaced w/ upgraded 500GB from 320GB. Computers are not my acumen although I found that I can take them apart and put them back together w/o issue-so far. Rebuilt my old Toshiba Satellite 455...new base, top, charger jack, screen, etc..works perfectly! It would be the drive which slides in on the left,, held by two screws, not the disk drive unit.
Powered up fine, than several minutes later powered off. Charger is fine, I replaced the charger jack, still won't power up.
I broke the WLAN white connector, pulled the male end off the board by accident., black OK. It broke when I went to replace the charger port. That wouldn't cause it to not power up though right?
I replaced the complete charger port board, not just the port. Seems something happened after I replaced the new driver card
I am currently on Windows 7 and sometime randomly my Computer screen freezes up and I can't do anything but wait, then it says Mobile Intel graphics accelerator (XP) has crashed.
How and where do I get the driver for the Windows 7 version?
Also... I can't seem to update my BIOS version from A05 to A14 cause my battery is dead and it says I need 10% battery, that's crap, I don't care if I have battery or not I JUST WANT TO UPDATE IT.
dell adamo hd crashed. Have new hd but no disk came with system. what to do
View 3 Replies View RelatedMy uncle has a Dell Inspiron 1545 with 3Gb RAM, 160 Gb HD and Windows Vista Home Premium. On boot up there is an error message stating that a back up should be performed immediately as the hard drive has a serious problem.
The good news is that I managed to make a clone of the 160 Gb HD to a 1000 Gb HD (Western Digital Blue) using Paragon software before the original drive failed. The bad news is that the cloning process stopped at 42%, but this 42% included the recovery partition and another part of the HD called Dell Utility.
I installed the cloned WD drive and pressed F8 on boot up, but the advanced boot menu did not appear. Instead I get the error message 'no bootable devices'.
I ran the diagnostics program using F5. All the tests were completed and 'passed'. The BIOS recognizes the new drive as 1000 Gb.
Question: how do I boot the laptop? My uncle does not have any recovery media.
My high school-age son was working on an English paper when something fell off a shelf and whacked his Aspire 3680 right above the hard drive bay. It started clicking and finally crashed.
The computer won't run with the hard drive installed. It makes nasty clicking sounds trying to boot, and finally beeps and powers off. Without the hard drive, the laptop powers up and runs BIOS just fine.
We can buy a new hard drive, but it seems awful to pay Acer another $20 + $10 shipping for the Vista restore disk!
I own a HP G72-130SB Productnumber VY062EA#UUG
My hard drive has crashed. My restore DVd is damaged. I installed a new windows 7 64 bit.
The graphics drivers (ATI HD 5430) is not installed. Can't find the driver. The latest ATI drivers don't work.
I need the original. HP don't give support anymore on their website.
Only a page with specs of my laptop. No drivers.
I have a Latitude E6410. Hard Drive crashed. Bought a new HD, installed and installed Windows 7 Home Premium. Got no wireless. Looking at Device Function I see no driver for:
Broadcom USH
Network Controller
Unknown Device
What drivers do I need and where to find??
I have Inspiron 14R N4010. Its 2 years old. Its Toshiba hard drive(320 Gb) crashed 8 months before so I bought new WD hard drive(500 Gb), which also crashed again 2 weeks before(OS drive had bad sectors apperently) . Hence i got it replaced by WD for a new 500Gb hard drive.
Now, when I am trying to install OS in my new hard drive, i am getting following error:
Intel UNDI, PXE - 2.0 (build 083)
Copyright (C) 1997-2000 Intel Corporation
For Atheros PCIE Ethernet Controller v2.0.2.3(06/18/10)
Check cable connection!
PXE-M0F : Exiting Intel PXE ROM.
Operating System not found.
after learning about possible mistakes by reading some forums
1) I checked that hard drive is installed properly, all connections are good.
2) DVD I'm using to install Window 7 is bootable one & i have used it before
3) BIOS settings are checked to boot fromCD/DVD drive. (It is not booting from network adapter which supposed to be reason for ethernet error as per many other forums)
4) I tried draining current by pressing power button for 20 sec to reset settings.(I read in some forum) but even that didn't worked.
BIOS is detecting hard drive...so that is also not issue. Could new hard drive be damaged? should i get this new one also replaced again? I need some way to confirm this before me sending it back to WD.
In one microsoft forum, I read for same problem
"update the basic input/output system (BIOS) to the latest version by contacting the motherboard or computer manufacturer and check if it works.Important: Modifying BIOS/complementary metal oxide semiconductor (CMOS) settings incorrectly can cause serious problems that may prevent your computer from booting properly. Microsoft cannot guarantee that any problems resulting from the configuring of BIOS/CMOS settings can be solved. Modifications of the settings are at your own risk.
Ref : [URL] ....
Since modifying BIOS setting involves risk
I want my Inspiron 14z Ultrabook to have two Operating Systems, Fedora (Linux) and Windows 7. Is it possible to use the SSD drive to accelerate the System's performance on both operating system?
Secondly, Can I still restore my machine to Factory settings???
My hard drive went bad (CHKDSK fails), so I replaced it. When it boots, I see the Dell starting up screen with F2 and F12 options but then it immediately displays a black screen with the text "Operating System Not Found". I've tried to press F12 with no luck, it always displays "Operating System Not Found". I double checked to ensure the hard drive is not loose and everything looks fine.
View 3 Replies View RelatedI have an inspiron 9300 with 100 GB HDD. Recently I had a huge malware or even virus that slowed down my computer tremendously.
I took it to geeksquad and they where able to remove it, but it still ran a lot slower than I ever remembered.
I had to install a new hard drive onto Dell Inspiron 17R (5720, Mid 2012). Ordered new hard drive from Dell, and also Operating System reinstall DVD. Windows was loading, but computer shut down and did not restart. I pressed the power button to restart, but now get 'BOOT MGR is missing' error, and don't know what to do next. I chose 'Custom Installation' and selected the only hard drive that was visible when prompted. Computer will not restart with DVD or without DVD. What now? Windows 7-
View 1 Replies View RelatedI formatted my HDD and now every time I try to install Windows 7 it says Missing Boot Manager!! Is there a certain sequence I need to go through to attempt this as in HDD Password?
View 4 Replies View RelatedI have an inspiron 1545, and recently a message that said "missing operating system" appeared when I booted it up. I tried pressing f8 and control+f11 but neither of those work. I also tried reinstalling my windows 7 but after it says "starting windows" it just goes to a black screen with a curser. I'm willing to restore it completely if its nessecary.
View 2 Replies View RelatedAs a routine maintenance task, I ran chkdsk /r on my Inspiron 1545 last night and it hung at 69% in stage 5 for over 10 hours. I figured it was hung for good, so shut the machine off. When I turned it back on I got the black screen with a "missing operating system". Message.
Worst case, is it as simple to get a factory restore by hitting F8 at bootup like I;ve seen posted on the web? If not, I do have the factory system recovery disks I made, but I really want to save what's on the laptop already.
I started it up and it took 20 minutes to boot Windows. I shut it down and it never booted Windows again. I have run diagnostics and they have either passed or they stop right in the middle and I am back to a blank, black screen.
View 1 Replies View RelatedI have a Dell Inspiron 1545 and cannot get it to boot up windows 7. I foolishly loaded a back up from my old sony without realising it would add sony vaio care and now the computer boots to vaio with an error message of error 12.
I have tried to restore using last good configuration but it still fails.
I closed Down the lid to head to my room and then came back about five minutes later, opened it up, and pressed the power button. A flash of a blue screen appears but I can't read what it says on it and then once it tries to load it reverts to a black screen that says "Windows has failed to start up . A recent hardware or software change might be the cause." Then I can either launch Startup Repair or Start Windows Normally.
I have tried both options, ran a hardware diagnostic test twice, tried to restore to a previous date, and tried to boot up in safe mode but each option fails and it just goes back to this black screen with the two options.
The only option I haven't tried is reverting to factory settings but that is because I would like to save my files first.
I have a Dell Inspiron 1545 running Windows 7. I try to turn on my computer, it goes through the Dell logo screen and comes up to a black screen with a blinking white cursor in the upper left corner and will not go any further. I have pushed F2 and F12 during the Dell logo screen, but no way. I have run the diagnostics for my computer, but it reports no errors, everything passes. I have also tried hitting the F8 and Ctrl+F11 keys during the Dell logo screen, but neither of these do anything, I have the OS disc for reinstallation, but because of the computer not going past the black screen with the white blinking cursor in the upper left corner, I cannot reinstall Windows because it will not restart correctly. What do I do?
View 15 Replies View RelatedCould not boot into recovery mode, launch the command prompt and run the following, bcdedit /enum all? I have a friends Dell 1545 and I think the Boot Manager/Loader is screwed up b/c it is not booting into recovery. I can boot to the Windows 7 OS, but we need to do a factory restore because of a nasty virus she has.
View 15 Replies View RelatedI have to swap out the current hard drive on my old Power Mac G5 because it's become unreadable. I've decided on the hard drive to replace it, but I have no idea how to go about installing the operating system. Moreover, my Power Mac G5 came with 10.3.5 Tiger, so is it safe to upgrade to Leopard even if I have older components?
View 5 Replies View Relatedgot a inspiron 1545 recently with a SATA 320 gb HDD / 4gb ram with Windows Vista Home Basic. Like most of us I hate Vista. So I created a partition & installed XP.
Used a program "EasyBCD" to setup dual boot. I get the dual boot screen at startup. But only XP boots. After a little probing, came to know that there are only 2 options in the BIOS for SATA operations. AHCI & ATA. If I select ATA I can boot only to XP. If I select AHCI then I can boot only into Vista. Searched around but the solutions were a bit over my head. Really appreciate if anybody could come up with something in lay mans terms.