Dell :: Studio Fan Speed Controller..?
Jul 15, 2009
So does anyone know of one that actually works? I have tried i8kfangui, but it no longer works with Windows Vista 64 bit, due to the unsigned drivers issue.
I disabled the signed drivers thing by booting while pressing F8.. and it installed perfectly and worked until I restarted Windows normally..
Then it said fanio driver not found or something, and refused to work unless I boot by pressing F8..
So anyone have a solution? Speedfan doesn't seem to work either.. I want to set the fans not to kick in so load until a certain temp .....
View 4 Replies
ADVERTISEMENT
Feb 13, 2013
What do I need to download to create a High Speed USB Port Controller on my antique Inspiron 5100 .....
View 1 Replies
View Related
Apr 18, 2013
I have a Dell 1749 into which I have installed two OCZ Vertex 3 MaxIOPS SSD drives. Boot times are pretty fast using a single, non-raid, drive but I was thinking of configuring the two drives in a RAID 0 configuration to boost speed a bit further. I could not find anything in the bios settings that would allow the SATA controller to go to a RAID configuration. I guess, therefore, that at least the laptop that I have does not have RAID capabilities. Were there any Studio 1749 system boards that did indeed support RAID?
View 4 Replies
View Related
Oct 7, 2008
Has anyone been able to get their Ethernet Controller to work on the Studio 17? I have the wireless working, but the Ethernet Controller will not load any drivers, automatic or manual. I have searched Intel's site and downloaded every 64 bit driver from Dell's Studio 17 download page.
View 10 Replies
View Related
May 24, 2010
I just ordered a Dell Studio 14 today, and it comes with 4GB of DDR3 1333MHz ram but in the Order Status page is says that it runs at 1066MHz. I was wondering why it is underclocked. Is it limited by the bus speed? Also, if it is limited to that speed, why would they sell 1333MHz ram if the max speed is 1066MHz?
View 10 Replies
View Related
Apr 17, 2009
I ran several system checking software suites which showed errors in the hardware configuration because the motherboard is only capable of supporting a FSB of 800MHz.
Does anyone have a similar issue or can provide an explanation about this?..
I know the memory is 800MHz but I expected this deluxe CPU to be supported by the motherboard and run at 1066MHZ...
View 4 Replies
View Related
Nov 26, 2013
I have a ProBook 4535s. I just did a fresh Windows 7 install but I can’t get the USB controller and SM Bus controller drivers to work. I downloaded and installed them from the HP website, but they are still showing yellow in Device Manager.Â
Â
SM Bus controller Hardware IDs
Â
PCIVEN_1022&DEV_780B&SUBSYS_168B103C&REV_13
PCIVEN_1022&DEV_780B&SUBSYS_168B103C
PCIVEN_1022&DEV_780B&CC_0C0500
PCIVEN_1022&DEV_780B&CC_0C05
Â
USB controller Hardware IDs
Â
PCIVEN_1022&DEV_7812&SUBSYS_168B103C&REV_03
PCIVEN_1022&DEV_7812&SUBSYS_168B103C
PCIVEN_1022&DEV_7812&CC_0C0330
PCIVEN_1022&DEV_7812&CC_0C03
View 3 Replies
View Related
Aug 31, 2014
I tried everything and still need drivers for DV7-6C63NR:
SM Bus Controller
Â
Network Controller
Â
also I cannot get my WiFi adapter to turn on with the button on keyboard - I suspect that it must be my network controller but I cannot locate the driver for it.
View 2 Replies
View Related
Jan 17, 2010
After downgrading my hp 15-g073nr notebook PC from the preinstalled Windows 8.1 to Windows 7 64 bit I have the common driver problems others are having and I managed to resolve all but a couple.
Â
I am still missing the following drivers: PCI Encryption/Decryption Controller and the SM Bus Controller.
View 5 Replies
View Related
Jan 12, 2015
I have changed my dell studio 1535 motherboard after ordering a refurbished one from dell. When reconnecting all the parts, everything worked well except the control media button <Previous Track> which was lighting up by itself from time to time.
I unplugged the media control panel, plugged it up again. This time the media panel is lighting up intermittently and the laptop cooler is at maximum. Unplugged again, a cable pin was short circuited and got broken in the process :(.
Fixed the cable, now the media control panel is completely down and the cooler runs at maximum speed. Removing the media panel fixes the cooler issue.
As I am not an expert into this, I was wondering if changing the panel will fix my problem or the faulty connection could have broken the motherboard control panel circuit.
PS. When running diagnostic via F12 key, no faulty issue is detected.
View 2 Replies
View Related
Nov 8, 2009
But this to "video controller" and "video controller (VGA compatible)" still can't find the way to fix them, I went to dell's drivers download page and the drivers don't fix the problem!!!
I've been told that I need my video controller working so I can put my computer into standby or hibernate, since that option is not working on my computer.
My computer works fine but I really would like to fix this two issues!!!
Ethernet Controller is another device that is not working, but I'm not too worried about it since I can connect to the internet using my wireless card
View 4 Replies
View Related
Jan 23, 2009
someone installed this new driver? as installing? ..
View 4 Replies
View Related
Dec 23, 2009
In the process of trying different nVidia GPU drivers I inadvertently uninstalled a bunch of other nVidia drivers from my SXPS 1340 . Managed to reinstall most of them, but I keep on getting an error looking for drivers for the SM Bus controller. Now all the advice on t'internet is that this is part of the chipset drivers, which I have reinstalled a number of times- all the other devices are fine now, but the SM Bus controller is still flagged up in the device manager.
View 10 Replies
View Related
Jun 18, 2009
I had to format the wife's old Dell Inspiron 5100 and reinstall XP. I did not have the install CD that has all the drivers so I went to the dell website and downloaded all that I needed.
I got everything installed but the hardware manager says I have an "ethernet controller" that does not have a driver. It has a Broadcom network card in it and it says the driver is loaded properly and that the device is functioning correctly .....
View 4 Replies
View Related
Jan 17, 2009
The fan on my E6400 runs most of the time at about 3000 rpm, I would like it to run at about 1500 rpm instead, I think 3000 rpm is quite noisy, even though it's stated as "slow"...
It works great and I'm able to controll the fan-speed (and noise!) manually..
I'm wondering if it would be possible to modify this fan controller for the E6400 and other laptops as well?..
The Zalman Fan Mate 2 has an input of 12V and can via the knob output between 5-11V, hence the fan will run slower if it is conncected to the Zalman controller. The problem so far is that the Zalman Fan Mate 2 is built for desktops with bigger power-pins, the one in the E6400 is quite small. Secondly I'm not sure about the voltage of the built in Dell-fan.
Anyway, if someone figure out how to modify a hardware fan controller for the Dell Latitude series, I think these controllers could sell like hot cakes...
View 10 Replies
View Related
Jun 27, 2009
XP has the controller flag in device manager (red) When I try to install the drivers I get setup.rul 380 error..is it a bad card?
View 3 Replies
View Related
Feb 18, 2013
I just changed mine Windows 7 64 bit os to windows 7 32 bit os. After setup all of the driver were installed beside Network Controller which i think the wireless lan is. My laptop is N4110 inspiron.
View 1 Replies
View Related
Nov 24, 2014
I just bought a new Dell Vostro 5470 i5 Service Tag: <Admin Note: removed per privacy policy~RK> | Express Service Code: <Admin Note: removed per privacy policy~RK> with Ubuntu only, I reformatted it and used my Windows 7 64bit OS. I downloaded all the drivers at Dell Product Support Website. Everything worked OK except that on my Device Manager, I am missing one driver, that is for PCI Simple Communications Controller, any link where I could download the driver?
View 4 Replies
View Related
May 30, 2012
My wireless is not working yet. I'm assuming its because Network Controller is not installed yet. How to install the Network Contoller driver for Inspiron 1525?
1) new hard drive installed
2) installed OS from Factory CD
3) I have followed the proper sequence for driver installation
4) I tried drivers using my Service Tag and not using service tag (it installed Ethernet but not the Network Controller)
5) i don't see any manufacturer info or model information  in the  sysinfo or Control Panel properties
Only way to possibly identify the wireless card is from the card itself and that isn't mush work either:
MO: 42015902-04 Rev A03 DW1395CN-OJR356-13740-8B3-00WV-A03
View 17 Replies
View Related
Dec 31, 2014
I have a Precision M4800 that has its USB ports stop working in two cases so far. First, if I use the card reader at all, it works to access files, but then when I try to eject the card, it shows neither an error nor the "safe to remove" message. the card stays in the list of drives even after it's unplugged. If another USB drive is plugged in after this, it isn't recognized.
The second case is after using an external USB 3.0 drive for a while, it can stop working. The drive shows up in the list of drives, but all the directories appear empty. Unplugging doesn't remove the drive, and new drives aren't recognized. Once this happens, shutting down the machine crashes after a few minutes with DRIVER_POWER_STATE_FAILURE in either USBSTOR.sys or O2FJ2w7x64.sys. Could this be a hardware problem? It seems like the USB controller is locking up and the other drivers are getting blamed.
View 3 Replies
View Related
Aug 20, 2009
I just reinstall windows xp pro on my dell inspiron 9200 and it show that I only useing 600MHZ CPU speed eventhough I have 2GHZ...
I used to change it back to 2GHZ nad I forgot how to do it..
View 3 Replies
View Related
Oct 15, 2009
I have a dell sxps 13 right here alongside a white 13" macbook from 2007.
I bought a ssd not too long ago for the sxps and just tested the boot time between the two.
now HOW in the *insert cuss word* world does the macbook still beat the ssd in boot up time? Anyone care to elaborate on this .....
View 10 Replies
View Related
Aug 30, 2009
how do i change my fan speed?
View 10 Replies
View Related
Jun 4, 2009
i am looking at dell laptop, inspiron vs latitude (both have lots of promotion going on recently)
according to wiki, both e6400 and e6500 can support ram clockspeed at 800mhz, but i can't find similar information about the inspiron models.
View 6 Replies
View Related
Feb 20, 2009
Is this reasonable? Please see HDTune screenshot.
View 4 Replies
View Related
Apr 3, 2009
what could this be unknown device in device manager
Properties
"on Intel(R) ICH9M LPC Interface Controller - 2919"
Details
ACPIITE8708
*ITE8708
View 3 Replies
View Related
Mar 7, 2009
I have E6400 with Vista SP1. When I tested hard disk using HDtune, the burst rate is always much lower compared to the transfer rate. I already tried Seagate, WD, Toshiba, they're all the same.
But if I look benchmark from other users (they don't use Dell though), the graph is different. Here is what I have:
My graph: the burst rate is always low.
E6400 users, can you test yours and let me know?
View 10 Replies
View Related
Jan 24, 2009
I’m hoping someone can help me as I’ve tried everything (which my knowledge is very limited) that I know what to do and I am unable to fix the problem I am having.
I have a Dell Inspiron 710M which is no longer under warranty and yesterday I received the following error upon boot-up. The 710M was purchased in February 2006. Windows XP Home Edition SP3 was installed.
Phoenix NoteBIOS 4.0 Release 6.0
Copyright 1985-2002 Phoenix Technologies Ltd.
All Rights Reserve
View 3 Replies
View Related
Mar 15, 2013
I did a fresh install of Windows 7 Pro 64bit and have all the drivers loaded, I think, except one:
Mass Storage Controller
Can't find the driver, don't know what it is. I've installed the chipset driver, the ATA driver, etc. Still it shows as not found.
View 8 Replies
View Related
Aug 9, 2013
Finding the correct Universal Serial Bus (USB) Controller driver for my Dell n5110.Â
View 4 Replies
View Related
