hp pavilion g6 1d63nr-ram; hard drive; fan ; power light have all be checked good after trooubling with information that was provided.
I have a recall plug LS 15-(need Rreplacement) could this be the problem?
 Is their damage to the motherboad ?
my laptop is a hp pavilion g6 2312ax
-amd a10 processor,4gb ram,1tb hdd
-previous bios version F26 insyde
Â
hp support page for my laptop showed a newer bios available,so i installed it and from then my laptop shows black screen i.e it switches on and keeps blinking capslock twice and 2 sec interval and repeats.i searched the internet and found that twice capslock signifies bios failure.so i thougth of following the win+B method,but the problem here is,when i extracted my bios package sp*****.exe i have 2 *.bin files and i dont know where to paste them on my pendrive.
i have a 1.5 year old HP PAVILION dv2500.
A couple days ago I tried turning the laptop on, and it just went to an all black screen.
I could not click/type anything (nothing worked), and I couldnt open the CD drive.
After a few minutes, the laptop shut down by itself.
Bought a HP 255 G2 (windows 8.1) to be used with Linux Mint.I know that I have to enable Legacy mode in the BIOS and disable the secure boot. I forgot the last part (disable the secure boot).Now I cannot do anything with the laptop, it is not responding to ESC or F10 to get into the BIOS to correct my mistake.I also have created an USB stick with the BIOS flash, but it won't boot from the USB stick to reflash the BIOS.Have it picked up by HP for repair?
View 3 Replies View RelatedI have an HP Pavillion model 17-e019dx running Windows 8. Every time I turn it on, it stops at a blue screen that says
Â
Recovery
Your PC needs to be repaired
 A required device isn't connected or cannot be accessed
 Error code 0xc000000f
Â
When I press enter to "Try again" it come back with:
Â
File:WindowsSystem32winload.efi above the error code listed above.
Â
I have tried the Recovery and after MUCH time waiting, it still comes back to the above mentioned screen. I have also run all the diagnostics that are available on the laptop and everything come back normal. I don't have the original discs or documentation as I "received this laptop as a "gift/curse" . It is, however, registered to me.
I have a little problem with my Acer E1-570.Yesterday I turned it completely off for the first time (I have been using sleep mode before), and when I tried to turn it on again, nothing happens.Power led is on, and HDD led flashes once, but after that it does nothing.I can hear fan spinning for few seconds but after that it's complete silence inside the computer.
View 2 Replies View RelatedI have pavilion dv7, so far I had no problem. Now, when I login it logs in but then instead of showing me the home screen, it goes into blank black screen. It has just started to happen and I hope there is another way to make it work without rebooting the whole system.
View 3 Replies View RelatedHp Pavillion 15 startsup with black screen, after 2 min login screen pop-up and disappears, laptop is 10 months Old, mot daily used
View 9 Replies View RelatedWhen I start up my laptop the Windows splash screen loads but with vertical lines then the screen shows random fuzzy lines and colours and then the screen goes completely black and nothing happens.
At first I restarted and ran in Safe Mode and ran CCleaner which after restarting worked for a short period but then would suddenly go to a black screen and one occasion went to a blue screen with the following message
*** Hardware Malfunction
Call your hardware vendor for support
NMI: Parity Check/Memory Parity Error
*** The system has halted *** .....
My R51 was working perfectly and has been maintained over the 8 years it has been with me. I wanted to upgrade my RAM and downloaded the BIOS update and chipset drivers updates.
After powering down I pulled the old 256MB RAM sets from under the keyboard and bottom of machine. I then inserted the single 2GB RAM into the slot under the keyboard and reassembled it.
Black screen/ no boot
Took out the 2GB replaced the 256MB sets and it worked fine for a few hours as I searched out reasons why the 2GB would not work. 'Suddenly the screen goes black and the system shut down.
It will power up (battery light/ status light green) but screen is black and it will not boot. Fan is running and battery charges. I tried hitting F12 and F8 but nothing.
i'm having a issue with my santa rosa mbp. I left for dinner and left my notebook on. Naturally the machine went to sleep. After i came back the machine would not boot up, the screen doesn't even turn on. The light on the latch release remains on. When i try a hard reboot, i'm having the same issue. Black screen, doesn't even get to the grey screen with the apple logo. I've tried going on 1 dimm or ram to see if it's a issue with the ram and still doesn't fix it.
View 10 Replies View RelatedWhen I turn my XPS 15 on, I get a continuous beep code (3 beeps pause 3 beeps pause....), a black screen with the following error message: ERROR 210: CPU Variable MTRR configure failed.
View 5 Replies View RelatedWhen powering up I get the Acer screen for about 10 sec and then black screen. Immediately before this there was a Windows update for the graphics card, if I remember correctly. I have tried hard power down 3 times but on the 4th time I do not get the message "preparing for automatic repair". I am unable to get into Safe Mode.
View 5 Replies View RelatedLenovo G560 - Issue with won't boot and black screen after HDD upgrade.
Â
 What happen: My laptop was working fine, no blue screen issue, no funny business at all. I bought a new SSD Intel 120 GB and thought it would be good to replace the HDD. I shutdown and disconnected the power adapter, waited a couple of minutes and removed the battery. I opened up the back case and replaced the HDD. And put all the screws back and put the battery back in.
Â
Problem: The very first time I turned the power on, nothing happens besides a black screen. I pressed the dvd drive it works and opens up and closes. I waited for about 30 mins and still has blac screen. When I mean black screen, no bios menu, no logo, just a black screen with the fan sound on.
 Â
I have tried these:
Â
1. Unplugged everything - battery, adapter, and pressed the power on button for about 60 seconds, nothing, the laptop turns on with the LED display on for both on and battery LED's. But nothing but black screen, no sound of windows loading just the fan and black screen.
Â
2. I tried putting back my old 2.5" and nothing but black screen.
Dell Inspiron 7720 (17R SE) approx 2 years old, just started having problems about a week ago when turning on the computer. LEDs flash and dell quickset buttons light up; but then process just dies, screen is black and only the LEDs by the power symbol and on power buttons are lit, never reaches the Dell logo screen, no fan sounds or anything.
At first, hitting the power button to turn off then back on and the second time the boot process would work. Then it failed to do that, so I had to remove the battery, pull the power cord and hold the power button down for 30 sec's, and then it would boot normal. Now even that does not work, just have to keep powering down and re-powering and after a random number of times, 10-30 it finally boots normal, every once in while it will work first try. It seems to be getting worse.Â
I have used the Dell Diagnostic on boot (though it took many tries to get into the ePSA, that did not detect any problems. When I use the Dell Support Advanced, no problems detected, and I specifically rand the Motherboard (which included CMOS test) and those did not find any problems.
If I put the computer in sleep, it comes back fine. It is only when I shut down, laptop just will not boot until I hit power on (fail) / power off repeatedly until finally, as if by luck it works fine.
I have a Dell Vostro 1500 which sometimes ,doesn’t want to boot.
I was using Windows 7,I have changed it to XP ,and it’s happening the same thing.
If I want to restart it , I’m getting a black screen(without any beep) , and when I'm turning it on ,I must press 20-60 times on power button  and maybe it will work.
In the same time ,I can keep it on,3 4 days ,without any problem.
I discovered that, when I want to turn it on (forced),if I press hard in the middle of the keyboard ,around keys "y /u/i/k/j/h" ,I hear a small sound, and after this its booting.
should be receiving new key board soon.
View 2 Replies View RelatedI have an Acer 7535-5020 that will not boot up. A few times prior to this happening it said that Windows was not shut down properly - this was right after a batch of Windows updates was installed.Now, it will not start at all. I have tried pressing every F button in hopes of it catching the Bios - we had noticed a few times that it was not set to start from the hard drive and changed it but for some reason it was not holding the changes, we think.I have googled and found that many Acer's (different models) seem to run into this problem and for many, it seems that something called flashing the Bios takes care of the issue. I would like to know which Aspire 7535 model BIOS I need to use as well. I think there are 2 different models listed.
View 5 Replies View RelatedI've now spent many hours of research and troubleshooting to try to fix this issue, both via external sites through google search and here on Acer site.
Â
It is the same issue reported many times: Acer 5552g laptop powers on, but does not boot up -I get blank / black screen, fan sound briefly, then idle, and that's the end of. Also, when I do manage to get it going (booting), it seems a totally random event...
I have a T420s that I bought a couple weeks earlier, it's a used one, so there's no warranty with it, I used it several days without any issue, I don't use it very frequently as I use my corporate one most of the time.
Someday when I wanted to turn it on, it stacks on a black screen and it beeps one beep then two other, nothing showing on the screen not even the thinkpad logo at startup, I thought it was a RAM related issue so I put the one from my corporate PC but without any luck, so I wanted to see if its graphic controller issue, I plug the VGA cable on the laptop and my TV and here I can see the thinkpad startup logo but after that I see a message on the screen telling :
"Real Time Clock Error - Check Date and Time settings. Press Esc to continue or F1 to enter setup" and when I press either one nothing happen at all, still stacks there.
My laptop will not boot up, just get the 7 beeps and a black screen. I have done research on this issue and it seems to be an ongoing problem with this laptop. If this is the case, this should be taken care of by Dell.
View 4 Replies View RelatedXps m1530 with windows vista . When I could boot the laptop after a while it then shut off. I did run diagnostics, all passed. I run virus scan - all ok. i updated all drivers and now can not get pass the black screen.
View 1 Replies View Related2 year old DV7 will not start up it just continually beeps, there are no stuck keys, everything has been unplugged, there is nothing connected. i've tried esc, F8 and F12 nothing happens....
View 5 Replies View RelatedHP Pavilion 14-b109wm Windows 8.1 How can I get the BIOS to boot from USB Drive first? I change the order in the BIOS but goes to Hard Drive first even when saving while exitting the BIOS? Trying to use a Password Recovery Program from my USB Drive to redo my admin password?
View 6 Replies View RelatedI was using my HP Pavilion g7 the other day, while gaming and the screen went black for no appairent reason. Â i haven't down loaded anything recently and i run virus software. Â
Â
We went to the HP support web site and went through several diagnotics. Â When the laptop is rebooted the screen on the laptop will flash images of my desk top but once the machine boots up the screen remains blank. Â you can see the glow from around the edges but that is it. Â I have another monitor plugged in currently and the system is functioning propertly except for this. Â We have also done the following, hard reset,Test for memory modual problems, test the hard drive. Â I was also trying to update the video drivers but the system tells me the drivers are working properly.
Just installed Visa 64 , everything went fine , but every time i boot into Vista i get a black screen with a white cursor in the top left have corner flashing very fast and it does this for almost 60 seconds and then Vista boots normally.
I have tried unplugging everything from my Mac , but i still get the same problem.
It looks like Vista is wating for something then it gives up, I have not installed any software only the bootcamp driver.
Anybody know what is wrong, I had Xp on previously and did not have this problem on fat32 , Vista only works on NTFC if that makes a difference.
I've just out my hdd to check whether the ssd will fit there, just checked whether the slot is ok. Then I put back the original HHD very carefully. After that I opened the extra RAM slot, took it out and put it back, also VERY carefully. I didn't harm the laptop in any way.
Then IÂ turned the computer on and it was just a black screen, nothing happening. No indicators lighted up, except for power button. I cannot enter BIOS, no response whatsoever.
Laptop still under warranty. I recently had a motherboard and HDD replacement. I wanted to install Windows myself, but the BIOS was set to UEFI, and I couldn't seem to boot off of a USB drive. So I switched it to Legacy, booted from the pendrive, and installed Windows just fine.
Â
For whatever reason, I went back to try and change the setting to UEFI. Now the laptop switches on, but refuses to boot. I get a black screen, with no logo or any prompt whatsoever to access the BIOS.Â
I read a bit and seems I need to remove the BIOS battery, let the memory clear itself to reset BIOS settings to default, and try again? If it matters, I re-installed Windows 7 64-bit.
My Acer Aspire One 10.1 notebook wont boot. All I get is a black screen with microsoft corporation written under neith a rectangle, where a green bar sliding from left to right should appear, but doesn't. What do I need to do?
Â
I have reinstalled win7 on my c drive using another computer. The hard drive booted on that computer. Which leads me to believe some thing is missing.
Laptop still under warranty.
Â
I recently had a motherboard and HDD replacement. I wanted to install Windows myself, but the BIOS was set to UEFI, and I couldn't seem to boot off of a USB drive. So I switched it to Legacy, booted from the pendrive, and installed Windows just fine.
I went back to try and change the setting to UEFI. Now the laptop switches on, but refuses to boot. I get a black screen, with no logo or any prompt whatsoever to access the BIOS.Â
Â
I read a bit and seems I need to remove the BIOS battery, let the memory clear itself to reset BIOS settings to default, and try again? I re-installed Windows 7 64-bit.