Where can I purchase replacement parts for the dv5t motherboard without spending an arm or a leg. I spilled coffee on the and now it's pretty much toast. It won't even start up.
View 10 RepliesI need some rubber feet and the LCD Rubbers too.
Technical support tells me to purchase the following..
Vince Dash : Hardware kit - Contains chassis rubber foot and Bluetooth module holder
Part number: 538346-001
Price: $44.65
Vince Dash : LCD panel front bezel assembly $67.45
PArt number: 576810-001
I think its outrageous to purchase these two packages for over 100.00 just to get some rubber 1x1inch pieces?
to start off I updated my vid drivers to the most recent nvidia driver and it has been downhill from that point! When i boot up it shows bars on the screen and will not load windows so i shutdown and load using safe mode which starts right up but still has red artifacts on the screen, i then uninstall the nvidia driver and reboot windows now it loads up properly still has the red artifacts though. So now it is using a standard vga driver then i install a different nvidia driver and get the same problems
I fear i may need a new mboard, would i be able to fit a better mboard/gpu in this chassis if it turns out my gpu is dead? think this may fall under a recall or something?
My friend has a dv9000 laptop, and gpu on motherboard is dead, so he has to replace whole motherboard. I was looking through ebay and i found one silly thing, i can see that some motherboards are used for DV6000 series and also for dv9000. For instance 441534-001 motherboard can be replaced and used on bought laptops. So my question is are all motherboards replacable or just few of them as one mentioned above? We were thinking of buying one with intel cpu, cause now he has AMD.
View 4 Replies View RelatedI'm looking for an extra Hard Drive bezel/Caddy (the flimsy plastic piece you screw onto your hard drive) for my Vostro 1500. The piece has to cost pennies to make, but I'm having a hard time finding one.
I was appalled to find it here at this price ($45):
http://www.laptopking.com/kingpartde...ategory=caddys
Anyone know of a good place to find this part?
They have the entire caddy for sale on ebay, but I'm just looking for the plastic piece:
http://search.ebay.com/search/search...=32%26fsoo%3D2
I have a Acer Travelmate 2420 that needs a new LCD back cover... The hinges were/are overly tight and over time the back cover has cracked and now it is to the point where replacement part is necessary..
the part number is 60.TB2V1.004 butr I am having difficulty tracking it down..
I have found a site that lists itm, but does not have it in stock..
[url]
although i am due for a notebook upgrade..i would like to repair this one for a spare home user for my wife or children
Few days before i started a thread regarding the display issue .. and today i was got a replacement for my keyboard...
the old one was very strong and sturdy ... the new one was fragile, and flexible.. i called the CC then and reported that teh keyboard is very fragile...
he told me that currently all replacement keyboards are like that...
it seems that Indian customers are the ones who have been ill treated with cheap parts...
As the title says I'm looking for some new parts.
I'm currently in need of new:
LCD hinges
fans
palm rest
mouse buttons
Anyone know the part numbers for these or could you reference me to a parts list or online site that would sell these parts?
After some issues i had with my GPU, Dell agreed to replace both my Heatsink and Motherboard, and i wanted to ask those who have had replacements in the past; has anything changed since july 2008? (when i bought my m1530)
have they improved the heatsink, or even changed it? ( i got the aluminum one, crappy piece of engineering right there )
and im sure the GPU issues are still present, but do they run cooler now ?
im asking this because in July the "defective Nvidia GPUs" were still in the dark, and the news about them was a mere rumor...
I am getting my 1640's motherboard and lcd screen replaced tommorw (dell are taking laptop into the centre). I have the 512mb Ati card, I understand the new motherboard has a 1gb card.
What are the chances I will get the new motherboard and hence the new card? Or will they still have the old motherboard replacements?
My 6920G went down a few days ago, I sent it to local computer store to have it diagnosed. It turned out that they say it is a mobo issue and said that it would cost aroun 400 to get a new mobo + labour fee.
I don't have any warranty on theis laptop, and the 1 year warranty by the manufacturer has expired. I am just wondering if I can order the mobo fron Acer and maybe replace it on my own.... I don't know which would be better, to have the guys at the store do it for me or phone Acer....
After a completely useless representative walked me in circles, then called me back once we got disconnected and left a 3 second message full of background noise I decided to go ahead and try out another representative.
This one was more useful, I told him about how the computer was underclocking when I was playing games and was running hot in general, and he suggested that we replace the motherboard, heatsink, and fan assemblies.
I had read about a power adapter possible being the issue but that wasn't offered so hopefully this first major surgery allows me to play games again
I have a 1 year and 10 month old Acer Aspire 9300 laptop and the motherboard recently bit the dust. My retailer in Gananoque Ontario could not find a replacement. I called Acer which took forever to get to someplace where I could leave a message. I received no reply. After you've called once it's impossible to call again. I guess their answering machine recognizes my phone number and then asks questions that makes it impossible to get through. I sent a detailed explanation of my problem by email 3 times asking a few simple questions, the most important being 1) where can I send the laptop to be repaired? 2) do you sell replacement motherboards and if so how can I buy one? Am I asking too much or getting too technical for them? I've been trying for several weeks now to contact Acer to no avail. What kind of an idiot company is this? A techie put me onto a company called Grand Tech in Richmond Hill Ontario that can replace the motherboard on an exchange basis but the replacement will likely be a repaired one.
Someone told me that the problem I have with the motherboard is common and it is because the solder used at least when mine was made was of poor quality. I hope that problem has been resolved. I'm afraid a repaired replacement my have the same problem. Some people just say to trash it and get a new on which I did. I bought a Dell Inspiron 17 which is supposed to arrive on Nov 11. I would however like to repair the Acer if it can be done cheaply and use it to replace my 8 year old PC in the rec room.
Well, my Nvidia 8400 died for second time and I called Dell to replace it. After asking for a sustainable solution and to ensure me that I won't have the same issue once more, they said that they will install me a new motherboard revision which reduces the possibilities of having my GPU dead.
Thus, they replaced the motherboard. I didn't format my system but kept my Windows Vista Ultimate x64 installation.
After using the system for a couple of hours I realized that the system was under-performing. Then I checked with CPU z utility and found out that the CPU clock was stuck @1,6GHz (although my power scheme was high performance). My processor is the T7500. The system was overheated and the clock speed was reduced (I guess). The thing was that I could almost do nothing, not even surf on the internet. This makes my laptop unable to deal with applications that need lots of CPU power.
Does anybody else face the same problem? Is there something I could do to return to the old situation? Should I contact Dell and complain? It is a huge problem cause half of my applications cannot be used any more!! After a few minutes of use the laptop stops performing normally!
Could it be that if I format my HD and make a fresh install the problem will be resolved? (I repeat that I didn't format my system after the MB replacement).
So My M1330 was part of the defective batches of Nvidia Video card. A dell tech guy came and replace the motherboard and also a defective battery. I assume that the hard drive would work the same and I assumed I didn't need to format. My current hard drive was just taking forever to boot up, and was just so slow. I figure i needed to reformat.
I used a new 320GB hard drive i was planning to replace the current drive with. Now that its fully formatted. It's still unbelievable slow. I though the speed step might not be working current but i used wcpuid to test the current speed and it was at full speed. Though the system doesn't seem hot at all. I just cant figure out why its so slow. bios is currently at A12 which is the lastest
I used to use my eSATA port every day with a few different devices. I started to have an overheating problem, so Dell replaced the motherboard and graphics card yesterday.
Of course, that means I lost all my BIOS settings. I'm pretty sure I have them back to where they should be (RAID mode on the SATA controller, eSATA port enabled), yet the eSATA port doesn't see a damned thing connected to it.
Every other piece of hardware is exactly the same as it was before. Any ideas as to what I might be missing?
I just replaced the motherboard in a Dell Inspiron 1440. The last step in the Dell Service Manual is to enter the correct Service Tag within BIOS. When I started it up and hit F2 and the section with the service tag could not be changed. Is there another way of changing the service tag to the correct one.
View 8 Replies View RelatedAfter replacing the fan, I have a power up issue with the laptop. Basically, the laptop will only power on with the power cable disconnected at the motherboard. It was by mistake that after the fan was replaced and everything was put back together, that I noticed that the battery was not charging.
I then reopened the machine and reconnected the power cable to the motherboard and nothing - no power.
When plugging in the power source with the battery in place, the LED adjacent to the power socket lights up WHITE then stays ORANGE and will not power up. No other lights, no fan noise, nothing.
If I remove the battery, the LED adjacent to the power socket lights up WHITE and stays white however will not power up either. Same agin, no other LEDs, not fan noise, nothing.
I have now opened the machine back up and disconnected the power from the motherboard. Put it all back together and the laptop powers up as normal with the battery and it works fine. (Well until the battery runs out anyway).
HP is sending me a replacement pc, and i'm sending this current one back. They told me I dont need to include the battery or AC adapter, the just the main unit. So my question is, what if i open this sucker up and take more free goodies? I owe them a good screwjob.
View 9 Replies View RelatedI talked to the guy who repaired my laptop about what brands he thought lasted the longest and needed the least repairs (he's been fixing computers all his life pretty much). And he said hp/compaq were the best.
View 8 Replies View RelatedI have a friend that bought a dv9000 from me but now he damaged the keyboard with his watch. A few of the (i dont know the name lol) things that hold the keyboard keys are broken. Anybody that lives near belgium and has some to spare or sell?
View 5 Replies View RelatedI was going to be assembling an m1710 this weekend....
I called Dell Spare Parts a few days ago, and placed an order for the following;
HG345 Refurb bottom plastics, m1710
FF084 Refurb palmrest assy, m1710
J8841 Refurb speakers, LED, m1710
CF426 Refurb hinge cover, m1710
I've been watching the order on Dell's site all week, as it was scheduled to ship (on or before today) (2/21/08), and I opted for Next Day shipping.
When I placed the order, the woman I spoke with asked for my Service Tag number. I, um... don't HAVE one... I didn't say this, I simply said I don't have that information at the moment. She asked how I got the part numbers, and I told her from their own Spare Parts page.
Well....the order got cancelled today. Saw it online while at work, just before I left for the day. Another order number with the identical items was created, with a scheduled ship date of 3/3/08. WHAT?
The woman just called....she states they cannot process my order without a service tag number. YOU HAVE GOT TO BE KIDDING ME!
I told her I don't have a tag number....she asked if I was building one. "Yes." To which I hear...
"Oh....well, I don't think our supplier will allow that without a service tag number, because we reserve those parts for people who bought m1710's."
I said "That's amazing...because I know a number of people who have done the same thing I'm trying to do, and had no problems getting these parts."
"Well, that's because they have m1710's"
*mad enought to scream at this point* "Um, no...where do you think I got the idea from?? I'm certainly not the first person to have this idea."
how I can get them to sell me some refurbished plastics? What's the secret password?
One of my mates has a dead M1330. I told him about the "oven" trick but his wife might hurt the both of us. It is however possible to replace the motherboard with the integrated X3100 motherboard correct?
View 10 Replies View RelatedI have xps gen 2 with a faulty video card and i was wondring if its possible to replace the motherboard with M1710 motherboard so i can fit my 7900 gs video card in it and put all the other hardware parts for the xps gen2 motherboard to the M1710 motherboard in the XPS Gen2 palmrest ... so can u please give me some hints if its possible to do it or not,so basiclly its replacing a motherboard and putting all the old part in the new 1 ..
View 14 Replies View Relatedi'm sending my laptop in to HP for a free motherboard replacement. does this procedure wipe out the hard drive?
i'm not getting any video...do i hook the laptop up to an external monitor to back up the files?
Is the fan meant to blow air of the back vent on the bottom of the DV5t?
Air blows out of the side vent but very little air blows out the back vent even when gaming. Im worried the vent is blocked.
Im concerned because the CPU reaches 85c when playing games, which seems a bit high for a CPU in my opinion.
I am getting quite scared about my hp dv5t its getting really hot. The cpu is always at 50-mostly around 65 degrees doing normal work. I keep it on a targus cooler sometimes, but when im on campus I can only use the bare desk. I have undervolted the computer and the gpu is fine always maxing out at around 60 degrees and the harddrive is always at like 40. How do I keep this cpu from getting so high? It makes the computer really hot. Anything like undervolting, or anything free would be a + point.
View 7 Replies View RelatedI've been eyeing the dv5t on HP.com but at Costco today I saw the dv6.
Which would you choose and why? Or is the scnreen size the only difference?
if theres a way to make 5.1 with microphone jack re tasking it for center/surround. and How?
View 5 Replies View Relatedwhat motherboard from Intel this dv4-1435dx uses? It's a 14" model from Best Buy. Just wanted to know before I bought it tomorrow...
Actually chipset...is it a GM45? I'm trying to get a hold of the Chipset, Matrix, and Graphics drivers...