HP Pavilion Dv6 OS/Software :: Stays For About A Minute At Logo Screen
Jan 2, 2015
Suddenly my PC started to stay for about 1 miinute at the HP logo during boot time, usually it took only a few seconds. There was no hardware change at the time of period of the start of this problem. These are the things i tried to solve this issue, but without success
-formatting the laptop
-reseating the rams
-reconnecting the hard disk
-changed the hard disks
-updating the bios
-disabling floppy, CD/DVD drive and network adapter check for boot devices
intel core i5 M450 2.4GHz
ATI Mobility Radeon HD 5650 1Gb graphics
4Gb ram ( 2 x 2Gb )
I was using my aspire yesterday to unistal an comodo anti virus program, then it stopped working. So I restarted the computer. it turn on but stay on the Acer logo. i tried the reset (HOLD POWER BTTTON FOR 30 SEC ) . It turned on but it still stay on the welcome Acer logo. whats wrong?.
I have a problem with my brand new Dell Inspiron 15R SE, that I bought yesterday.
In the evening I could use it with no problem, other than it unexpectedly disconnected from the wifi once, but otherwise it was OK.
This morning it didn't start at all, when I press power button the Dell logo appears, and it stays like that forever, nothing happens. The power and the Wifi LEDs are on, when the charger is connected, the LED is on too.
I have laptop listed above. For the past 3 days I hasn't not been able to get it in. it sounds like its starting but the screen stays black. Recently installed antivirus on 01/01/2012 because I had some kind of worm/malware. Windows 7 is the OS. Cap lock light is on and "hp combo assistant" light is on constant no blinking. Don't know what to do.
I recently bought a HP Pavilion computer (HP Pavilion 10: 10-e010nr). This was my first experience with Windows 9.1, but everything seemed to be going OK. Then, yesterday when I had to enter my password again, the computer began running very slowly and then seemed to lock-up; it wouldn't do anything. I held the "on button" until the computer shut down and then restarted it. When it restarted, it didn't get past the initial screen that shows "HP" within a blue circle and the small circle of small, white dots shows that it's working but nothing ever happens. I tried this numerous times, but the same thing happens.
So last night I replaced the motherboard and Video Card on my E1705. Everything booted fine. There were a few things I needed to fix, but the computer worked. In doing so I noticed I only had 512 RAM, so one of the sticks wasn't being recognized. I figured I must have put it in wrong, so I took them both out and put them right back in. I then tried to start the computer, and the power light and numbers lock lights came on, and the caps and scroll lock lights started flashing. The screen was black and turned off after ~1 minute.
Did I fry my RAM, or is something wrong with the motherboard reading the RAM? This is freaking me out.
I have a HP Pavilion G7 notebook. The model is 1219-wm.
I recently did a clean re-install of Windows 7 ultimate from a CD. After I did the re-install, the wireless orange light stays on and will not turn to white/blue.
I have tried to download and install drivers from the hp website. NOTHING seems to work. I even tried to download the HP Wireless Assistant Support Wizard, but it doesn't work. It keeps saying that the Wireless Assistant is not compatible with my model.
Every time I troubleshoot, I keep getting the following message "Install a driver for your network adapter"....
Recently, my Blackbook has had some troubles when I close the lid. What happens is the light never starts pulsing, and the laptop gets really warm and the fan goes crazy. When I open the lid, the screen stays black. When I reboot it, It shows the grey screen, goes black for a sec, then restarts. I tried reseting the pram, but it didnt help.
I had to uninstall the current driver. After this it auto installed the old ati driver.
I uninstalled this one as well leaving me with the bare bones driver that comes with windows. After installing the modded driver again and restarting it began to work again................................................
No matter how many times i restart the labtop, it will first go black screen with dell log, then "resuming windows", then goes to the "logging off.." screen and stays there FOREVER. I tried to use both battery or AC power but they are just the same. I can adjust the lightness of screen using my keyboard but I cant see my mouse pointer anywhere on the screen so i cant click on anything.
My acer aspire v5 - 122p went through an automatic update recently after it powered back on it never booted past the initial Acer boot screen I eventually did a hard resetbut now the screen stays completely black the fan is on the blue lights are on but nothing else. From what I have read online you can flash the bios but the file I have downloaded on the Acer website does not match any of the tutorials I have read or watched.
i have a acer aspire 3000 i got from some relatives but when i turn it on it turns on i can here the fan kick on an the dvd drive go click click and stuff but then fan stops and it goes dead silent and the screen never shows anything from the beggining by any chance do those little switches that shut off the screen when u close it ... .do they ever brake ...? ive tried hooking it up to another monitor but it doesnt show a screen of anything but it must send some type of a signal cause its just a plain blank screen and once i unplug it it sais no signal no signal all over
i have a 2 day old laptop Aspire E1 with windows 7 wont start after welcome page screen stays black until i push ctrl alt del and then the task manager will start and i kill two procsess that say RUN ONCE then windows GO HEAD and start up and run fine .what is wrong .
I'm working with a HP G72-250US Notebook and using Windows 7 64 bit Intel core(TM). M350@2.27ghz2266 mhz 2 cores
Is it the Mother board or the Harddrive? Replaced screen due to vertical and horizontal lines in color. Computer worked normal at times. I thought it was fixed but then while doing a HP diagnostic program the computer said to shut down because the batttery situation might harm the computer . I tested the AC adapter. I installed a new battery and at first it was working again. I updated and scanned with AVG & Malwarebytes. Did another HP diagnostic and at one point was told to restart. It never lived again to this point.
All it does is light up the power light and W/LAN (F 12). Blue lights are on at times indicating Cap locks and number locks are engaged. I did do a complete factory restore before it came to this point and updated the bios (to F 37) and downloaded updates for chipsets and Graphics also.(after screen installed) The only thing it does now is make noises at startup and power indicator is lit now Light keeps cycling.(light off, light on) in ten second intervals.
I tried to update my bios to A07 -> A11 (the lastest). But the update failed. Ok. I just close the updater. I open Google Chrome, surf on the Internet etc. After 10 min, I shut off my Dell computer normaly. Now when I turn my MiniPC on, it just doesn't do anything... My hard drive doesn't starts. The screen stays black...
My Dell xps 13 is stuck on the dell logo screen, since its the logo screen i am not even able to go onto bios or boot option or anything, absolutely nothing has been working? is there anything i can do from here? or should i just send it to dell?
When I open the lid to the laptop and hit the power button, the 3 buttons on the top of the keyboard cycle through and the power comes on, but the only thing that happens next is the screen turns on with a slight brightness, but it doesn't load any further. It doesn't even load to the Dell logo. If I tap the power button again, all lights and monitor goes off with a beep noise.
I have taken the battery out, unplugged the power cord and held the power button for over 15 seconds. This did not do anything.
I have a envy dv6 serial 2ce2502rs6 product b6b49av. It starts up with hp logo and goes to black screen. I tried repair before and it didn't work. I tried the hard restart and it came on and I selected repair and it didn't work again so I selected turn off and now it goes to black screen.
Once unit is powered on keep tapping the F2 key run the diagnostics test . It saysProcessor check passed. Memory quick check passed. Hard drive smart check passed. Hard drive short DST check FAILED.Failure ID OU7ATA-6B877E-QFPK1A-60U503Product iD b6b49avHard drive 1
My Laptop is Lenovo G460, I have no problem with it till about a few days ago, my problem is every time I boot my laptop, I got blackscreen between Lenovo Logo --> windows logon, it's took about 2/3 minutes with cursor appeared at the very top left corner which is really make me mad . And every time I shutdown my laptop, I faced a long time shutdown, after my screen off, my keyboard and mouse still on...after about 5-10 seconds then it's all completly off.
I try to figured out what's happened with my laptop, then I change my boot option (F2)
I changed Sata Controller from AHCI to Sata Controller Compatible, and now every thing is works! no more black screen, and not only that, now lenovo logo is just faster, but the problem is still happen, when windows logo going to appeared I got blue screen error (BSOD) then the laptop was restarted by it self.
I try to redownloaded and reinstalled the drivers for my Windows 7 64 bit, here are the following that I redownloaded and reinstalled :
Chipset Driver Intel Matrix storage Intel Rapid Store Intel Sata Controller Turbo Boost
I have been given Dell inspiron 15 as a scholarship From a Firm..On start up it shows Firm logo instead of Dell logo..even when operating system is loading it shows the same logo.I have updated BIOS..More over installed a fresh copy of Windows 8.1.... But still see the same logo...I want Default Dell logo and default windows logo.What should I do.. If i set Boot option to UEFI (without Legacy Enabled).. It gives error that there is no disk ..